Installation Space
When unit is surrounded by walls
A 900 mm or more (Control box is of a open/close type)
B 250 mm or more
B B
B B B B
A A
B B
B B B B
A A
When there is an obstruction above the unit
A 45° or more
B 200 mm or more
C 250 mm or more
A A
AA
B B B B
C C C
C
< Front view >
D 1000 mm or more
E |
Air outlet guide (Procured at the site) |
|
F |
250 mm or more |
D |
|
|
F
E
< Side view >
18 |
Outdoor Unit |
Lifting Method
Season wind and cautions in winter
?Sufficient measures are required at a snow area or severe cold area in winter so that product can be operated well.
? Get ready for seasonal wind or snow in winter even in other area.
?Install a suction and discharge duct so that snow or rain does not enter into when the product operates at out- door temperature of less than 10°C.
?Install the outdoor so that it does not directly touch with the suction hole at the area with much snow since the inside of the Indoor Unit may be frozen because the air suction hole of the Outdoor Unit is clogged due to snow-
fall and then attach the hood to prevent effect of snowfall.
?Install the Outdoor Unit at the higher installation console by 50cm than the expected average snowfall (annual average snowfall) at the area with much snowfall since the inside of the Indoor Unit may be frozen because the
air suction hole of the Outdoor Unit is clogged due to snowfall.
? Where snow accumulated on the upper part of the Outdoor Unit by more than 10cm, always remove snow for operation.
1.The H of frame height must be more than 2 times the snowfall and its width shall not exceed the width of the product. (If width of the frame is wider than that of the product, snow may accumulate)
2.Don't install the suction hole and discharge hole of the Outdoor Unit facing to the seasonal wind.
20 |
Outdoor Unit |