LG LRE6321ST INSTALLATION MANUAL

LG LRE6321ST INSTALLATION MANUAL
<![if ! IE]>

<![endif]>FRANÇAIS ENGLISH

INSTALLATION MANUAL

ELECTRIC RANGE

Please read these instructions thoroughly before installing and operating the range.

LRE6327ST

 

 

 

LRE6323SB

LRE6385ST

LRE6383SW

LDE3037ST

LRE6325ST

 

 

 

LRE6323SW

LRE6385SB

LSE3092ST

LDE3031ST

LRE6325SB

 

 

 

LRE6321ST

LRE6385SW

LSE3090ST

 

LRE6325SW

 

 

 

LRE6321SW

LRE6383ST

LSE3392ST

 

LRE6323ST

 

 

 

LRE6387ST

LRE6383SB

LSE3390ST

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

www.lg.com

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

(REV.04 130801)

 

 

 

2 TABLE OF CONTENTS

TABLE OF CONTENTS

3 SAFETY

3 Before You Begin

3 Important Safety Instructions

5Prepare to Install the Range

6PREPARE TO INSTALL RANGE

6Installation Drawings (LSE Series only)

7Installation Drawings (LRE Series only)

8Installation Drawings (LDE Series only

9INSTALL THE RANGE

9 Electrical Connection Requirements

9 Anti-Tip Device Installation

9 Final Installation

SAFETY 3

BEFORE YOU BEGIN

Remove all tape and packing materials before using the range.

Dispose of all plastic bags after unpacking the range. Never allow children to play with packing materials.

You can download the installation and owner’s manual at: http://www.lg.com.

IMPORTANT SAFETY INSTRUCTIONS

Read and follow all instructions before using your oven to prevent the risk of fire, electric shock, personal injury, or damage when using the range. This guide does not cover all possible conditions that may occur. For further assistance contact your service agent or manufacturer.

This is the safety alert symbol. This symbol alerts you to potential hazards that can cause personal injury to you and others. All safety messages will follow the safety alert symbol with either the word “WARNING” or “CAUTION.”

WARNING

This symbol will alert you to hazards or unsafe practices which could cause serious bodily harm or death.

CAUTION

This symbol will alert you to hazards or unsafe practices which could cause bodily injury or property damage.

WARNING

The information in this manual should be followed exactly.

-A fire or electrical shock may result causing property damage, personal injury or death.

DO NOT step or sit on oven door. Install the Anti-Tip Bracket supplied with the range.

-The range could be tipped and injury might result from spilled hot liquid, food, or the range itself.

-If the range is pulled away from the wall for cleaning, service, or any other reason, ensure that the Anti-Tip Device is properly reengaged when the range is pushed back against the wall.

-Install the Anti-Tip Bracket. Screws must be fixed to at least two locations.

-A child or adult can tip the range and be killed.

-Failure to do so can result in death or serious burns to children or adults.

-1) According to the Anti-Tip Bracket Template, install Anti-Tip Bracket to the floor and wall.

-Anti-Tip will fasten the range by holding the range’s leg from the rear side and the Anti-Tip Bracket Template lets you know the location of Anti-Tip Bracket easily.

-2) Engage the range to the Anti-Tip Bracket by putting the range’s legs into each Anti-Tip Bracket.

-3) Re-engage the Anti-Tip Bracket if you can move the range without oven’s front direction.

-4) See installation instructions for details (refer to the page 9).

New branch-circuit installations (1996 NEC) for mobile homes, recreational vehicles, and installations where local codes do not allow grounding through the neutral wire require a 4-conductor UL listed range cord or 4 wire conduit connection.

The middle (neutral or ground) wire of a 3 wire power cord or a 3 wire conduit has to be connected to the middle post of the main terminal block.The remaining two wires of the power cord or conduit have to be connected to the outside posts of the main terminal connection block.

-Failure to do so can result in electrical shock, severe personal injury or death.

<![if ! IE]>

<![endif]>ENGLISH

Loading...
+ 6 hidden pages