LG LSES302ST, LSRE307ST, LRE30955S, LRE30757S, LRE30453S User Manual

ENGLISH ESPAÑOL

INSTALLATION MANUAL

ELECTRIC RANGE

Please read these instructions thoroughly before
installing and operating the range.

MODELS

LRE30955S
LRE30755S
LRE30757S

P/NO : MFL57205802

LSE3094S
LSE3092S
LSRE307ST

LRE30855S
LRE30451S
LRE30453S

LRE3091S
LSES302ST

www.lg.com

Part 1 SAFETY

1

BEFORE YOU BEGIN

Remove all tape and packing materials before using the range.
Dispose of all plastic bags after unpacking the range. Never allow children to play with packing materials.

IMPORTANT SAFETY INSTRUCTIONS

Read and follow all instructions before using your oven to prevent the risk of fire, electric shock, personal injury, or
damage when using the range. This guide does not cover all possible conditions that may occur. For further
assistance contact your service agent or manufacturer.

This is the safety alert symbol. This symbol alerts you to potential hazards that can cause personal injury to you and
others. All safety messages will follow the safety alert symbol with either the word “WARNING” or “CAUTION”.

WARNING

CAUTION

This symbol will alert you to hazards or unsafe practices which could cause serious
bodily harm or death.

This symbol will alert you to hazards or unsafe practices which could cause bodily
injury or property damage.

WARNING

• The information in this manual should be followed exactly.

- A fire or electrical shock may result causing property damage, personal injury or death.

• DO NOT step or sit on oven door. Install the Anti-Tip Bracket supplied with the range.

- The range could be tipped and injury might result from spilled hot liquid, food, or the range itself.

- If the range is pulled away from the wall for cleaning, service, or any other reason, ensure that the Anti-Tip Device is properly
reengaged when the range is pushed back against the wall.

• New branch-circuit installations (1996 NEC) for mobile homes, recreational vehicles, and

installations where local codes do not allow grounding through the neutral wire require a 4­conductor UL listed range cord or 4 wire conduit connection.

• The middle (neutral or ground) wire of a 3 wire power cord or a 3 wire conduit has to be connected

to the middle post of the main terminal block. The remaining two wires of the power cord or
conduit have to be connected to the outside posts of the main terminal connection block.

- Failure to do so can result in electrical shock, severe personal injury or death.

• Only a 4-conductor power-supply cord kit rated 120/240 volts, 50 amperes and marked for use with

ranges with closed-loop connectors or open-end spade lugs with upturned ends shall be used.
The middle (neutral) wire of the power cord or 4-wire conduit has to be connected to the middle
post of the main terminal block. The other two wires of the power cord or conduit have to be
connected to the outside posts of the main terminal connection block. The 4th ground wire must
be connected to the frame of the range with the ground screw.

- Failure to do so can result in electrical shock, severe personal injury or death.

CAUTION

• Put on gloves during installation procedure.

- Failure to do so can result in bodily injury.

• Make sure that the wall covering, countertop and cabinets around the range can withstand

the heat (up to 194°F) generated by the range.

- Discoloration, delamination or melting may occur.

- This range has been designed to comply with the maximum allowable wood cabinet temperatures of 194°F.

• Cabinet storage space located above the surface units should be avoided.

• Install a range hood that projects horizontally a minimum of 5 inches beyond the bottom of

the cabinets If cabinet storage is to be provided.

- The risk of burns or fire by reaching over the heated surface elements can be reduced.

2

Part 1 SAFETY

Gloves

Safety Glasses

Tape Measure

Pencil

Rear filler & 2 Screws

(LSE Series only)

WARNING

• The information in this manual
should be followed exactly.

- A fire or electrical shock may result causing

property damage, personal injury or death.

WARNING

• DO NOT step or sit on oven
door. Install the Anti-Tip
Bracket supplied with the
range.

- The range could be tipped and

injury might result from spilled hot
liquid, food, or the range itself.

- If the range is pulled away from the

wall for cleaning, service, or any
other reason, ensure that the Anti­Tip Device is properly reengaged
when the range is pushed back
against the wall.

ENGLISH

PREPARE TO INSTALL THE RANGE

TOOLS NEEDED

PARTS PROVIDED

CAUTION

• Put on gloves during installation
procedure.

- Failure to do so can result in bodily injury.

NOTE

• Read all instructions contained in these installation
instructions before installing range.

• Remove all packing materials from the oven
compartments before connecting the electrical
supply to the range.

• Observe all governing codes and ordinances.

•

Be sure to leave these instructions with the consumer.

NOTE

Keep these instructions with your owner’s manual for
future reference.

• As when using any appliance generating heat, there
are certain safety precautions you should follow.

• Be sure your range is installed and grounded
properly by a qualified installer or service technician.

• Make sure the wall coverings around the range can
withstand the heat generated by the range.

• To eliminate the need to reach over the surface
elements, cabinet storage space above the elements
should be avoided.

(For Anti-Tip Bracket Mounted

on Concrete Floors and Walls)

PARTS NOT PROVIDED

3

Part 2 PREPARE TO INSTALL THE RANGE

2

INSTALLATION DRAWINGS (LRE/LSRE Series only)

NOTE

SAVE FOR THE USE OF THE LOCAL ELECTRICAL INSPECTOR.

CLEARANCES AND DIMENSIONS (Figure 1)

To install range refer to the following Figure 1.

For installation in CANADA, a Free-standing range is not to be installed closer than 15/
adjacent surface.

32 (12mm) from any

CAUTION

• Make sure that the wall covering,
countertop and cabinets around the
range can withstand the heat (up to
194°F) generated by the range.

- Discoloration, delamination or melting may occur.

- This range has been designed to comply with the

maximum allowable wood cabinet temperatures
of 194°F.

CAUTION

• Cabinet storage space located above
the surface units should be avoided.

• Install a range hood that projects
horizontally a minimum of 5 inches
beyond the bottom of the cabinets If
cabinet storage is to be provided.

- The risk of burns or fire by reaching over the

heated surface elements can be reduced.

A = 30”(76.2 cm) For U.S.A

= 30”(76.2 cm) ~ 31”(78.7 cm) For CANADA

FIGURE 1 FIGURE 2

MINIMUM DIMENSIONS (Figure 2)

* 30”(76.2 cm) minimum clearance between the top of the cooking surface and the bottom of an

unprotected wood or metal cabinet; or 24”(60.9 cm) minimum when bottom of wood or metal cabinet is
protected by not less than
sheet steel, 0.015”(0.381 mm) stainless steel, 0.024”(0.610 mm) aluminum or 0.020”(0.508 mm) copper.

** 15”(38.1 cm) minimum between countertop and adjacent cabinet bottom.

1

/

4”(6.4 cm) flame retardant millboard covered with not less than no. 28 MSG

4