LG LGSLIDE2 Users manual

User’s manual for SLIDE2

Federal Communications Commission (FCC) Statement

You are cautioned that changes or modifications not expressly approved by the
part responsible for compliance could void the use’s authority to operate the
equipment

FCC- Class B

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a communications.
However, there is no guarantee that interference will not occur in particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

The description for SLIDE2

This SLIDE2 PBA is ONESOFT company designed specifically for the LG.
Compares with the previous SLIDE2 version, This design uses the SMI's latest USB
controller chips (SM321CC).The Product has highly compatibility, and best
performance intended for supporting Dual-Channel SLC & MLC NAND type Flash
memory, and it also supports USB1.1 & USB2.0. The Product delivers extremely high
data transfer rate and correct data through reliable 8-bit ECC engine for the coverage
of the MLC flash read/write disturbance.

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:
(1) This device may not cause harmful interference. and
(2) This device must accept any interference received, including interference
that may cause undesired operation.