LG LDE3017SB, LDE3019ST, LDE3017ST, LDE3017SW User Manual

ENGLISH

ESPAÑOL

INSTALLATION MANUAL

ELECTRIC DOUBLE OVEN RANGE

Please read these instructions thoroughly before
installing and operating the range.

LDE3019ST
LDE3017ST
LDE3017SB
LDE3017SW

P/No.: MFL63290401

LDE3015ST
LDE3015SB
LDE3015SW

www.lg.com

Part 1 SAFETY

Gloves

Safety Glasses

Tape Measure

Pencil

Gloves

Safety Glasses

Tape Measure

Pencil

Gloves

Safety Glasses

Tape Measure

Pencil

BEFORE YOU BEGIN

1

Remove all tape and packing materials before using the range.
Dispose of all plastic bags after unpacking the range. Never allow children to play with packing materials.

IMPORTANT SAFETY INSTRUCTIONS

Read and follow all instructions before using your oven to prevent the risk of fire, electric shock, personal injury,
or damage when using the range. This guide does not cover all possible conditions that may occur. For further
assistance contact your service agent or manufacturer.

This is the safety alert symbol. This symbol alerts you to potential hazards that can cause personal injury to you and
others. All safety messages will follow the safety alert symbol with either the word “WARNING” or “CAUTION”.

WARNING

CAUTION

This symbol will alert you to hazards or unsafe practices which could cause serious
bodily harm or death.

This symbol will alert you to hazards or unsafe practices which could cause bodily
injury or property damage.

WARNING

• The information in this manual should be followed exactly.

- A fire or electrical shock may result causing property damage, personal injury or death.

• Any person should not step or sit on the oven door. You should install the Anti-Tip
Bracket supplied with the range.

- The range could be tipped and injury might result from spilled hot liquid, food, or the range itself.

- If the range is pulled away from the wall for cleaning, service, or any other reason, ensure that the Anti-Tip

Device is properly reengaged when the range is pushed back against the wall.

• You should use two or more people to move and install range.

(Excessive Weight Hazard)

- Failure to do so can result in back or other injury.

• You never pull or push any handles of upper& lower door to move and install range.

- Failure to do so can result in serious damage to the door of the range.

• New branch-circuit installations (1996 NEC) for mobile homes, recreational vehicles,
and installations where local codes do not allow grounding through the neutral wire
require a 4-conductor UL listed range cord or 4 wire conduit connection.

• Power supply cord and plug should not be modified. If it will not fit the outlet, have a
proper outlet Installed by a qualified electrician.

• Using an extension cord to connect the power is prohibited. The way to connect the
power cord and plug directly is strongly recommended.

• Electrical ground is required on this appliance.

• You should make sure that the power cord is not pinched by the range or heavy objects.

- Failure to do so can result in serious burns or electrical shock.

• You never remove the protection cover covering the rear of lower oven.

- Failure to do so can result in serious damage to power cord. The damage causes serious burns and electric

shock.

2

Part 1 SAFETY

WARNING

• The middle (neutral or ground) wire of a 3 wire power cord or a 3 wire conduit has to be
connected to the middle post of the main terminal block. The remaining two wires of the
power cord or conduit have to be connected to the outside posts of the main terminal
connection block.

- Failure to do so can result in electrical shock, severe personal injury or death.

•

Only a 4-conductor power-supply cord kit rated 120/240 volts, 50 amperes and marked for use
with ranges with closed-loop connectors or open-end spade lugs with upturned ends shall be
used. The middle (neutral) wire of the power cord or 4-wire conduit has to be connected to the
middle post of the main terminal block. The other two wires of the power cord or conduit have
to be connected to the outside posts of the main terminal connection block. The 4th ground
wire must be connected to the frame of the range with the ground screw.

- Failure to do so can result in electrical shock, severe personal injury or death.

CAUTION

ENGLISH

• You should put on gloves during the installation procedure.

- Failure to do so can result in bodily injury.

• You should make sure that the wall covering, countertop and cabinets around the range
can withstand the heat (up to 194°F) generated by the range.

- Discoloration, delamination or melting may occur.

- This range has been designed to comply with the maximum allowable wood cabinet temperatures of 194°F.

• Cabinet storage space located above the surface units should be avoided.

• You should install a range hood that projects horizontally a minimum of 5 inches
beyond the bottom of the cabinets. If cabinet Storage is to be provided.

- The risk of burns or fire by reaching over the heated surface elements can be reduced.

• You should not install the range in the humid place. Splashing the range with water or
any electrolyte can result in electrical shock.

• You should not let cooking grease or flammable material accumulate in or near the
range.

- Failure to do so can result in serious burns.

3

Part 1 SAFETY

Gloves

Safety Glasses

Tape Measure

Pencil

Gloves

Safety Glasses

Tape Measure

Pencil

Rear filler & 2 Screws

(LSE Series only)

Gloves

Safety Glasses

Tape Measure

Pencil

Rear filler & 2 Screws

(LSE Series only)

Gloves

Safety Glasses

Tape Measure

Pencil

Gloves

Safety Glasses

Tape Measure

Pencil

Gloves

Safety Glasses

Tape Measure

Pencil

Gloves

Safety Glasses

Tape Measure

Pencil

WARNING

• The information in this manual

should be followed exactly.

- A fire or electrical shock may result causing

property damage, personal injury or death.

WARNING

• Any person should not
step or sit on the oven
door. You should install the
Anti-Tip Bracket supplied
with the range.

- The range could be tipped and

injury might result from spilled hot
liquid, food, or the range itself.

- If the range is pulled away from

the wall for cleaning, service, or
any other reason, ensure that the
Anti-Tip Device is properly
reengaged when the range is
pushed back against the wall.

PREPARE TO INSTALL THE RANGE

TOOLS NEEDED

PARTS PROVIDED

CAUTION

• You should put on gloves during
the installation procedure.

- Failure to do so can result in bodily injury.

NOTE

• Read all instructions contained in these installation

instructions before installing range.

• Remove all packing materials from the oven

compartments before connecting the electrical
supply to the range.

• Observe all governing codes and ordinances.

Be sure to leave these instructions with the consumer.

•

NOTE

Keep these instructions with your owner’s manual for
future reference.

• As when using any appliance generating heat, there

are certain safety precautions you should follow.

• Be sure your range is installed and grounded

properly by a qualified installer or service technician.

• Make sure the wall coverings around the range can

withstand the heat generated by the range.

• To eliminate the need to reach over the surface

elements, cabinet storage space above the elements
should be avoided.

(For Anti-Tip Bracket Mounted

on Concrete Floors and Walls)

PARTS NOT PROVIDED

4