.
Basic operation - more you can do
Mute
1. Press on the unit(MUTE on the remote control) to cut the sound.
2. To cancel it, press again.
Using EQ(Equalizer)
EQ is to increase or decrease the signal strength of audio frequencies. The function helps you to enjoy sound more plentifully.
Press EQ/
• XDSS+ on the unit repeatedly. The indicator lights up in the following
order.
POP t CLASSIC t ROCK t JAZZ t VOCAL t SALSA t SAMBA t
REGGAE t RUSSY t USER1 t USER2 t Off(not displayed)
Note
• When XDSS+ is set to “Off”, you can adjust the EQ settings.
• You can adjust sound level to your preference. Once you select a USER mode
and press [SOUND], then adjust the sound level(BASS(bass), MID(middle),
TRB(treble)), it will be automatically stored for the currently selected USER
mode. Refer to the “For sound setting” for USER 1/2 mode.
Using XDSS+ (Extreme Dynamic Sound System)
It improves the treble and bass sound.
1. Press and hold EQ/
• XDSS+ on the unit.
2. To cancel it, press and hold it again.
Checking the clock
1. Press DISP once to check the clock.
2. Press it again to remove it.
Turning off the display light
1. Press and hold DISP.
2. Press and hold it again to turn it on.
Note
Under the light-off condition, press any keys, the light is turned on and then off
automatically if you don’t press it within a few seconds.
Resetting the unit
It resets the unit when it does not operate properly.
1. Press [OPEN] and pull out the front panel.
(Refer to page 6 for detaching the control panel.)
2. Prick the RESET hold with sharp object.
Adjusting general settings
You can adjust sound, light and other settings by using the MENU button.
On the Unit
1. Press and hold FUNC/
• MENU.
2. Rotate the volume knob to select [SOUND], [LIGHT], or [OTHER] and press
it.
3. Rotate the volume knob to select the item and press it.
4. Rotate the volume knob clockwise or counterclockwise to adjust the level.
5. Press the volume knob to confirm the setting.
If you want to return to the previous step, press .
On the Remote Control (OPTIONAL)
1. Press and hold FUNC/
• MENU.
2. Press
v or V to select [SOUND], [LIGHT], or [OTHER] and press ENTER.
3. Press
v or V to select the mode and press ENTER.
4. Press
v or V to adjust the level.
5. Press ENTER to confirm the setting.
If you want to return to the previous step, press .
For Sound setting
You can adjust sound quality by adjusting the level of BAL(left/right speaker),
FAD(front/rear speaker) and S--W(Sub-woofer:optional).
CAR CD/MP3/WMA Receiver 9
Basic Operation
ON PLAYER
1. Turn the unit on.
2. Select a source.
3. Adjust the volume.
4. Turn the unit off.
Any key
SRC
Rotate the
volume knob
Press and hold
OFF