Room Air Conditioner
(Window Type)
OWNER'S MANUAL
WINDOW TYPE ROOM AIR CONDITIONER
•Please read carefully and thoroughly this manual before operating this unit.
•Contact the authorized SVC man for repair or maintenance of this unit.
•Contact the installer for installation of this unit.
•The appliance is not intended for use by young children or infirm persons without supervision.
•Young children should be supervised to ensure that they do not play with the appliance.
MODEL : HWC093GBAA0.AWYBLPS (MODELO)
Antes de usar su aire acondionado, lea este manual cuidadosamente y manténgalo para futura referencia.
<![endif]>LOÑAPSE HSILGNE
Aire Acondicionado (Tipo de Ventana)
MANUAL DEL USUARIO
Window-Type Air Conditioner Owner’s Manual
TABLE OF CONTENTS
1.
Safety
Precautions
2.
Operating
Instructions
3.
Care
and
Maintenance
4.
Hardware
Installation
5.
Common
Issues
FOR YOUR RECORDS
Write the model and serial numbers here:
Model #
Serial #
You can find them on a label on the side of each unit.
Dealer's Name
Date Purchased
■Staple your receipt to this page in the event you need it to prove date of purchase or for warranty issues.
READ THIS MANUAL
Inside you will find many helpful hints on how to use and maintain your air conditioner properly. Just a little preventive care on your part can save you a great deal of time and money over the life of your air conditioner.
You'll find many answers to common problems in the chart of troubleshooting tips. If you review our chart of
Troubleshooting Tips first, you may not need to call for service at all.
PRECAUTION
•Contact the authorized service technician for repair or maintenance of this unit.
•Contact the installer for installation of this unit.
•The air conditioner is not intended for use by young children or invalids without supervision.
•Young children should be supervised to ensure that they do not play with the air conditioner.
•When the power cord is to be replaced, replacement work shall be performed by authorized personnel only using only genuine replacement parts.
•Installation work must be performed in accordance with the National Electric Code by qualified and authorized personnel only.
2
Safety
Precautions Precautions
To prevent injury to the user or other people and property damage, the following instructions must be followed.
■Incorrect operation due to ignoring instruction will cause harm or damage. The seriousness is classified by the following indications.
WARNING This symbol indicates the possibility of death or serious injury.
CAUTION This symbol indicates the possibility of injury or damage to properties only.
■ Meanings of symbols used in this manual are as shown below.
Be sure not to do.
Be sure to follow the instruction.
WARNING
■ Installation
Always install the expansion panel(s). |
Do not place the power cord near a heater. |
• No installation may cause fire and electric |
• It may cause fire and electric shock. |
<![endif]>ENGLISH
Do not use the power cord near flammable gas or combustibles such as gasoline, benzene, thinner, etc.
• It may cause explosion or fire.
Gasolin
Do not disassemble or modify products.
• It may cause failure and electric shock.
3
■ Operation
Plug in the power plug properly.
•Otherwise, it will cause electric shock or fire due to heat generation or electric shock.
Do not modify power cord length.
•It will cause electric shock or fire due to heat generation.
Unplug the unit if strange sounds, odors, or smoke come from it.
•Otherwise it may cause fire and electric shock accident.
Do not operate or stop the |
Do not damage or use an |
unit by inserting or pulling |
unspecified power cord. |
out the power plug. |
|
• It will cause electric shock or |
• It will cause electric shock or |
fire due to heat generation. |
fire. |
ON
Do not share the outlet with |
Always plug into a |
other appliances. |
grounded outlet. |
• It will cause electric shock or |
• No grounding may cause |
fire due to heat generation. |
electric shock (See |
|
Installation Manual). |
Do not use the socket if it is |
Do not operate with wet |
loose or damaged. |
hands or in damp |
|
environment. |
• It may cause fire and electric |
• It will cause electric shock. |
shock. |
|
4
Do not allow water to run |
Leave the door closed while |
into electric parts. |
the air conditioner is |
|
running. |
• It will cause failure of machine |
• It is not designed to cool the |
or electric shock. |
entire house. |
Ventilate before operating air conditioner when gas goes out.
•It may cause explosion, fire, and burn.
<![if ! IE]><![endif]>ENGLISH
CAUTION
■ Installation
Never touch the metal parts of the unit when removing the filter.
• They are sharp and may |
• It |
cause injury. |
|
■ Operation
Be cautious not to touch the sharp edges when installing.
• It may cause injury. |
• It |
Sharp edges
Ensure that the outer case is not damaged by age or wear.
•If leaving appliance damaged, there is concern of damage due to the falling of product.
Turn off the main power switch when not using it for a long time.
•Prevent accidental startup and the possibility of injury.
5
Do not place heavy object on the power cord and take care so that the cord should not be pressed.
If water enters the product, turn off the the power switch of the main body of appliance. Contact service center after taking the power-plug out from the socket.
Do not clean the air conditioner with water.
•There is danger of fire or electric shock.
•Water may enter the unit and degrade the insulation. It may
Turn off the power and breaker firstly when cleansing the unit.
Do not put a pet or house plant where it will be exposed to direct air flow.
Do not use this appliance for special purposes such as pets, foods, precision machinery, or objects of art.
•Since the fan rotates at high speed during operation, it may cause injury.
• This could injure the pet or |
• It is an air conditioner, not a |
plant. |
|
Always insert the filter securely.
Clean it every two weeks.
Use a soft cloth to clean. Do not use wax, thinner, or a strong detergent.
Do not drink water drained from air conditioner. / Do not direct airflow at room occupants only.
•Operation without filters will cause failure.
•The appearance of the air conditioner may deteriorate, change color, or develop surface flaws.
•It contains containments and will make you sick. / This could damage your health.
Wax
Thinner
6
Operating |
Location and Function of Controls |
Instructions |
Controls
The controls will look like one of the following.
NOTICE : Optional
<![endif]>HSILGNE
Thermostat |
Auto Swing |
Operation |
|
|
|
|
|
||
5 |
|
OFF |
|
|
|
|
|
||
6 |
|
|
|
|
|
|
|
||
4 |
Off |
On MED |
|
HIGH |
|
|
|
|
|
|
|
|
|
|
|
|
|||
3 |
|
7 |
FAN |
|
COOL |
|
|
|
|
|
|
|
|
|
|
|
|
||
2 |
|
8 |
|
|
|
|
|
|
|
1 |
9 |
|
LOW |
|
MED |
|
|
|
|
|
FAN |
|
COOL |
|
|
|
|
||
|
|
|
|
LOW COOL |
|
|
|
|
|
Temperatura |
|
|
|
Función |
|
Temperatura |
|
|
Función |
|
|
AUTO AIR SWING |
No |
|
|
|
|
No |
|
|
|
|
|
|
|
|
|
||
|
|
NO |
SI |
|
|
|
|
|
|
Min. |
Max. |
|
|
Vent. |
Refrig. |
Min. |
Max. |
Vent. |
Refrig. |
|
|
|
|
|
|
7
■ OPERATION
High Cool ( ), Med Cool (
) and
Low Cool ( ) provide cooling with different fan speeds. Med Fan (
) or Low Fan (
) provides air circulation and filtering without cooling. Off ( o ) turns the air conditioner off.
NOTICE : If you move the switch from a cool setting to off or to a fan setting, wait at least 3 minutes before switching back to a cool setting.
Cooling Descriptions
For Normal Cooling- Select High Cool or Med Cool with the Operation knob at the midpoint of
Thermostat knob.
For Maximum Cooling- Select High Cool with the Operation knob at the highest number available on your
Thermostat knob.
For Quieter & Nighttime Cooling- Select Low Cool with the Operation knob at the midpoint of
Thermostat knob.
■ THERMOSTAT
The THERMOSTAT is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the same level of comfort. When you turn the knob to a higher number(the right side) and the indoor air will become cooler.
The 5 or 6 position (the middle position of arc) is a normal setting for average conditions.
■ AUTO SWING (Optional)
Auto swing switch controls the horizontal air direction by air swing system (not on all models).
ON ( ) : Auto swing is operated.
OFF ( ) : Auto swing is not operated.
CAUTION: When the air conditioner has been performed its cooling operation and is turned off or set to the fan position, wait at least 3 minutes before resetting to the cooling operation again.
8
Controls
The controls will look like one of the following.
NOTICE : Optional
FAN FAN
Thermostat Operation
Heater
Warmer Cooler
Thermostat |
Operation |
■ AUTO SWING (Optional)
ON ( ) : Air swing is operated while OPERATION knob is set to the COOL or HEAT position.
OFF( ) : Stops the operation of air swing.
■ THERMOSTAT
Turn the thermostat control to the desired setting. The control position is a normal setting for
average conditions. You can change this setting, if necessary, in accordance with your temperature preference.
The thermostat automatically controls cooling or heating, but the fan runs continuously
whenever the air conditioner is in operation. If the room is too warm, turn the thermostat
control clockwise. If the room is too cool, turn the thermostat control counterclockwise.
■ HEATER ( ) LAMP
When the unit sets heating operation condition, the green lamp is lighted.
When the frost settles on the heat exchanger of the outside, defrosting is made automatically and the green lamp is turned off.
The unit may give a "hiss" and the fan motor stops for
1 to 10 minutes.
This should not be regarded as a problem.
After defrosting, the heating operation begins again.
■ OPERATION
OFF |
( |
o ) : Turns the air conditioner off. |
LOW FAN |
( |
) : Permits the low fan speed |
|
|
operation without cooling |
|
|
(heating). |
LOW COOL ( ) : Permits cooling with the low fan speed operation.
HIGH COOL ( ) : Permits cooling with the high fan speed operation.
LOW HEAT ( ) : Permits heating with the low fan speed operation.
HIGH HEAT ( ) : Permits heating with the high fan speed operation.
CAUTION : When the air conditioner has been performed its cooling operation and is turned off or set to the fan position, wait at least 3 minutes before resetting to the cooling operation again.
<![endif]>ENGLISH
9
Operating
Instructions
Remote Control Operation
The controls will look like one of the following.
5 |
6 |
|
|
|
|
REMOTE CONTROL |
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
7 |
|
|
|
|
|
|
7 |
4 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1 |
|
1 |
|
|
|
1 |
6 |
|
|
|
|
|
|
|
|
3 |
|
3 |
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
1 |
|
|
|
4 |
3 |
2 |
|
5 |
4 |
|
|
4 |
|
3 |
|
|
|
||||
|
|
|
|
|
|
|
||
5 |
6 |
|
|
|
6 |
5 |
6 |
5 |
|
|
|
|
|
|
2 |
|
|
|
|
|
|
7 |
|
|
|
|
|
|
|
|
1 |
|
|
|
|
4 |
3 |
|
|
|
|
|
|
|
Controls
CAUTION: The Remote Control unit will not function properly if strong light strikes the sensor window of the air conditioner or it there are obstacles between the Remote Control unit and the air conditioner.
1.POWER BUTTON
Operation starts, when this button is pressed and stops when you press the button again.
2.AUTO SWING (Optional)
The vertical louver swings horizontally by the automatic system and stops when you press the button again.
3.ROOM TEMPERATURE SETTING BUTTON
Control the room temperature within a range of 16°C to 30°C
4.FAN SPEED SELECTOR
Select the fan speed in three steps {High[F3] → Low[F1] → Med[F2] → High[F3]...}.
5.OPERATION MODE SELECTION BUTTON
Select Cooling, Fan, or Dehumidification mode with this button.
6.ON/OFF TIMER BUTTON
Set the time of starting and stopping operation. The timer is set by 1 hour.
7.SIGNAL RECEIVER
AUTO RESTART
In failure of electric power, the unit runs as previous setting operation.
How
to
Insert
the
Batteries
1.Remove the cover from the back of the remote controller.
2.Insert the two batteries.
3.Re-attach the cover.
•Do not use rechargeable batteries, such batteries differ from standard dry cells in shape, dimensions, and performance.
•Remove the batteries from the
remote controller if the air conditioner is not going to be used for an extended length of time.
10
Operating |
Adjusting the Air Flow Direction |
Instructions |
Additional controls and important information.
Ventilation
The ventilation lever must be in the CLOSE position in order to maintain the best cooling conditions. When fresh air is necessary in the room, set the ventilation lever to the OPEN position.
The damper is opened and room air is drawn out.
Part B
Part A
CLOSE VENT
OPEN
NOTICE :Before using the ventilation feature,
position the lever, as shown. First, pull down part to horizontal line with part
.
Air
Direction
The direction of air can be controlled whenever you want to cool by adjusting the horizontal louver and the vertical louver.
• HORIZONTAL AIR DIRECTION CONTROL
To control horizontal direction of air flow, press the air flow direction control button and the air flow will be swept horizontally by the automatic air-swing system.
If you want to stop the air flow from moving, press the button again at the desired position of the vane.
• VERTICAL AIR-DIRECTION CONTROL
The vertical air direction is adjusted by moving the horizontal louver.
• Auto Swing Models
The horizontal air direction is automatically controlled by setting the AUTO SWING switch to the ON position.
<![endif]>ENGLISH
11