LG HT352SD-D0 User Manual

HT352SD-D0_NA3NLLD_ENG_1126

USB

P/N: MFL56941126

DVD/CD RECEIVER

Read the manual carefully before using the unit

English

RECEPTOR DVD/CD

Lees deze handleiding aandacht door voordat u dit toestel gebruikt.

GERMAN

RECEPTOR DVD/CD

Veuillez lire attentivement le présent manuel avant d'utiliser l'appareil.

FRENCH

RECEPTOR DVD/CD

Lees deze handleiding aandacht door voordat u dit toestel gebruikt.

DUTCH

HT352SD

(HT352SD-D0, SH32SD-S, SH32SD-W)

5.1 Speaker Setup

Make the following settings for the built-in 5.1 channel surround decoder.

1. Press ENTER and 5.1 Speaker Setup menu appears.

2. Use b / B to select the desired speaker.

3. Adjust options using v / V / b / B buttons.

4. Press ENTER to confirm your selection. Returns to the previous menu.

Speaker selection

Select a speaker that you want to adjust. [Front speaker (Front L), Front speaker (Front R), Center Speaker (Center), Subwoofer (SubWoofer), Rear speaker (Rear L), Rear speaker (Rear R)]

Note:

Certain speaker settings are prohibited by the Dolby Digital licensing agreement.

Size

Since the speaker settings are fixed, you cannot change the settings.

Volume

Press b / B to adjust the output level of the selected speaker. (-5dB ~ 5dB)

Distance

If you connected speakers to your DVD/CD Receiver, setting the Distance lets the speakers know how far the sound has to travel to reach your set listening point. This allows the sound from each speaker to reach the listener at the same time.

Press b / B to adjust the Distance of the selected speaker. (You can’t adjust front / Woofer speakers)

Test

Press b / B to test the signals of each speaker. Adjust the volume to match the volume of test signals memorized in the system.

Front Left (L) → Center → Front Right (R) → Rear Right (R) → Rear Left (L) → SubWoofer

QUICK SETUP GUIDE

Speaker System Connection

Connect the speaker wires the speaker terminals. To obtain the best possible surround sound, adjust the speaker parameters (volume, distance, etc.).

Notes:



Be sure to match the speaker wires to the appropriate terminal on the components, + to + and – to –. If the cables are reversed, the sound will be distorted and will lack bass.



If you use front speakers with low maximum input rating, adjust the volume carefully to avoid excessive output on the speakers.

ENGLISH

Introduction

Installation

Before Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3

TV Connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4

Antenna Connection . . . . . . . . . . . . . . . . . . . . . . . .4

Speaker System Connection . . . . . . . . . . . . . . . . .4

Optional Equipment Connection . . . . . . . . . . . . . .4

Operation

Operate using the Front Panel . . . . . . . . . . . . . . . .5

Operate using the Remote Control . . . . . . . . . . .5-7

Setup

Initial Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7

General Operation . . . . . . . . . . . . . . . . . . . . . . . . . .7

Language . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7

Display . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7

Audio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7

Others . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7

5.1 Speaker Setup . . . . . . . . . . . . . . . . . . . . . . . .8

Lock (Parental Control) . . . . . . . . . . . . . . . . . . . . .8

Presetting the Radio Stations . . . . . . . . .8

Playing an Audio CD or MP3/WMA/JPG/DivX file

Playing an Audio CD or MP3/WMA file . . . . . . . . . .9

Viewing a JPEG file . . . . . . . . . . . . . . . . . . . . . .9-10

Playing a DivX Movie file . . . . . . . . . . . . . . . . . . .10

Additional features . . . . . . . . . . . . . . . . . . . . . . . .10

RDS Operation . . . . . . . . . . . . . . . . . . . .10

Reference

Language Codes . . . . . . . . . . . . . . . . . . . . . . . . . .11

Area Codes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11

Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . .12

Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . .13

Before Use

About the Symbol Display

“ ” may appear on your TV display during operation and indicates that the function explained in this owner’s manual is not available on that specific DVD video disc.

Symbol Used in this Manual

A section whose title has one of the following symbols is applicable only to the disc represented by the symbol.

DVD and finalized DVD±R/RW

Audio CDs MP3 files

WMA files JPEG files DivX files

Types of Playable Discs

In addition, this unit can play a DVD-RW, DVD+RW, and CD-R or CD-RW that contains audio titles, MP3, WMA, JPEG or DivX files.

Notes:



Depending on the conditions of the recording equipment or the CD-R/RW (or DVD-RW, DVD+RW) disc itself, some CD-R/RW (or DVD-RW, DVD+RW) discs may not be played on the unit.



Do not attach any seal or label to either side (the labeled side or the recorded side) of a disc.



Do not use irregularly shaped CDs (e.g., heart-shaped or octagonal). It may result in malfunctions.

Regional Code

This unit has a regional code printed on the bottom of the unit. This unit can play only DVD discs labelled as the same as the bottom of the unit or “ALL”.

Notes on Regional Codes

If you try to play a DVD with a different regional code from your player, the message “Check Regional Code” appears on the TV screen.

DivX

JPEG

WMA

MP3ACD

DVD-V

Manufactured under license from Dolby Laboratories. “Dolby”, “Pro Logic”, and the double-D symbol are trademarks of Dolby Laboratories.

DTS and DTS Digital Out are trademarks of Digital Theater Systems, Inc.

TV Connection

Make one of the following connections, depending on the capabilities of your existing equipment.

Tips:



Depending on your TV and other equipment you wish to connect, there are various ways you could connect the

DVD/CD Receiver

. Use one of the connections

described below.



Please refer to the manuals of your TV, VCR, Stereo System or other devices as necessary to make the best connections.

Caution:



Make sure the DVD/CD Receiver is connected directly to the TV. Select the correct AV input on your TV.



Do not connect your

DVD/CD Receiver

to the TV via your VCR. The DVD image could be distorted by the copy protection system.

SCART connection

Connect the EURO AV OUTPUT (TO TV) socket on the DVD/CD Receiver to the corresponding jacks on the TV using the scart cable (T).

Component Video connection

Connect the COMPONENT VIDEO OUT jacks from the DVD/CD Receiver to the corresponding jacks on the TV using a Y P

B PR cable (C).



If your television is a high-definition or “digital ready” television, you may take advantage of the DVD/CD Receiver’s progressive scan output for higher video resolution.



If your TV does not accept your resolution setting, abnormal picture appears on the screen. Please read owner’s manual for TV then set the resolution that your TV can accept.

Antenna Connection

Connect the supplied FM/AM antenna for listening to the radio.



Connect the AM Loop aerial to the AM aerial connector.



Connect the FM Wire aerial to the FM aerial connector.

Notes:



To prevent noise pickup, keep the AM Loop aerial away from the DVD/CD Receiver and other components.



Be sure to fully extend the FM wire aerial.



After connecting the FM Wire aerial, keep it as horizontal as possible.

Speaker System Connection

Connect the speaker wires the speaker terminals. To obtain the best possible surround sound, adjust the speaker parameters (volume, distance, etc.).

Notes:



Be sure to match the speaker wires to the appropriate terminal on the components, + to + and – to –. If the cables are reversed, the sound will be distorted and will lack bass.



If you use front speakers with low maximum input rating, adjust the volume carefully to avoid excessive output on the speakers.

Optional Equipment Connection



Connect a VCR to the AUX IN connectors.

Installation

Do not touch the inner pins of the jacks on the rear panel. Electrostatic discharge may cause permanent damage to the unit.

AM Loop Antenna (supplied)

FM Wire Antenna (supplied)

Rear of DVD/CD Receiver

Rear of TV

COMPONENT VIDEO /

PROGRESSIVE SCAN INPUT

To AUX IN AUDIO (L/R)

SCART INPUT

AUDIO (L)

AUDIO (R)

To AUDIO OUT (L/R)

Rear of VCR

ENGLISH

Operate using the Remote Control

1. POW

2. OPEN/CLOSE

Opens and closes the disc tray.

3. FUNCTION SELECT buttons BAND, DVD, AUX, USB

4. SLEEP You can set the DVD/CD Receiver to turn off automatically

at a specified time.

1. Press SLEEP to set the desired sleep time. The SL indicator and the sleep time appears in the display window.

2. Each time you press SLEEP the setting changes in the

following order.

SL 180 →150 →120→90 →80 → 70 → 60→ 50 → 40 → 30 → 20 →10 →OFF

Note: You can check the remaining time before the DVD/CD Receiver turns off. Press SLEEP. The remaining time appears in the display window.

5. DIMMER This function will change the brightness of the display

window on the front panel during in power-on status. Press the DIMMER repeatedly.

6. 0-9 numerical buttons Selects a service, program number

directly or selects numbered options in a menu.

7. XTS Pro Each time you press XTS Pro the setting changes in the

following order.

XTS→ NORMAL → XTS-P...



XTS-P: The unique sound quality of the LG Technology creates the optimum sound for you to play the perfect playback of the original sound and to feel the living sound source.



XTS: When playing a movie with weak bass relative to the general music, it forces sound to the woofer. In the mode of 2 CH BYPASS, It creates the high display effect by playing the sound source via the rear speakers same as the front speakers. Note: The XTS mode is temporarily disabled when changing from

2.1 CH to 5.1 CH and it is enabled when changing it to 2.1 CH.



NORMAL: XTS-P and XTS modes turn off.

8. RETURN Removes the setup menu.

9. SOUND You can enjoy surround sound simply by selecting one of

the pre-programmed sound fields according to the program you want to listen to (2 ch. sound only).

Press SOUND button repeatedly.

BPASS(BYPASS) → On STR(ON STAGE) →STU(STUDIO) → CLUB(CLUB) → HALL(HALL) → THEA(THEATER) → CHUR(CHURCH) → PL ll-1(PL ll MOVIE) → PL ll-2(PL ll MUSIC) → PL ll-3(PL ll MTRX) → BPASS(BYPASS)... Note: Initial sound mode is BYPASS.

10. SUBTITLE

During playback, press SUBTITLE repeatedly to select a desired subtitle language.

DivX

DVD

Operate using the Front Panel

1. STANDBY/ON/STANDBY indicator

Lights red when the receiver is in Standby mode (off)

2. USB Port Connect the USB port of a USB Memory (or MP3

player, etc.) to the USB port on the front of the unit.

Removing the USB Device from the unit

1. Choose a different function mode or press STOP (x) twice in

a row.

2. Remove the USB device from the unit.

3. DISC Tray

4. DISPLAYWindow

5. Remote Sensor:

Remote Control Operation Range

Point the Remote Control at the remote sensor and press the buttons. Distance: About 23 ft (7 m) from the front of the Remote Sensor Angle: About 30° in each direction in front of the Remote Sensor

6. OPEN/CLOSE Opens and closes the disc tray.

7. FUNC./PLAY Press and hold down this button about 3

seconds, then press repeatedly to select other function.

8. MONO/ST./PAUSE/STEP

If an FM program is noisy

Press MONO/ST. on the front panel to make “ST.” disappear in the display window. There will be no stereo effect, but the reception will improve. Press the button again to restore the stereo effect.

9. STOP

10. TUNING(-/+)/SKIP/SCAN(..bb/BB>>)

For manual tuning, press TUNING (-/+) repeatedly. For automatic tuning, press and hold TUNING (-/+) for about two seconds on the front panel.

11. VOLUME controller Adjusts speaker volume.

Operation



Don’t extract the USB device while operating.



Music files (MP3/WMA), image files (JPEG) and Video files can be played.



This unit cannot use a USB HUB.



Recommended Memory Cards. Compact Flash Card (CFC), Micro Drive (MD), Smart Media Card (SMC), Memory Stick (MS), Secure Digital Card (SD), Multimedia Card (MMC), Memory Stick Pro (MS-Pro)

- Compatible with: FAT16, FAT32

- Only use the memory cards recommended.



Devices which require additional program installation

when you have connected the unit to a computer are not

supported.



In case of a USB HDD, make sure to connect an

auxiliary power cord to the USB HDD for proper

operation. Up to four primary partitions of a drive are

supported. If there is an extension partition, it will not be

supported.



If the drive of USB device is two or more, a drive folder is

displayed on the screen. If you want to move to the initial

menu after you select a folder, press RETURN.



Digital cameras and mobile phones are not supported.

7 8

+ 9 hidden pages