LG GWL2710PS, GWP2723PS, GWP2720PS User manual

OWNER’S MANUAL

SXS
REFRIGERATOR

Please read this manual carefully before operating
your set and retain it for future reference.

MFL67683087

www.lg.com

Shelf

Deodorizer

Freezer compartment

It is normal...

15

18

18

19

20

20

20

21

22

23

23

24

26

26

28

Don’t use an

extension cord

Accessibility

of Supply Plug

Supply Cord

Replacement

Warning

Introduction

Entry

The model and serial numbers are found on the inner case on the back

or one side of the refrigerator

are unique to this unit and are not available to others. You should record
requested information here and retain this guide as a permanent record of
your purchase. Staple your receipt here.

Date of purchase :
Dealer purchased from :
Dealer address :
Dealer phone no. :
Model no. :
Serial no. :

Important safety instructions

Before it is used, this refrigerator must be properly installed and located in accordance with
the installation instructions in this document. This Refrigerator is intended for Domestic
indoor use only.

Never unplug your refrigerator by pulling on the power cord. Always grip plug rmly and
pull it straight out from the outlet.

When moving your appliance away from the wall, be careful not to roll over the power
cord or to damage it in any way.

After your refrigerator is in operation, do not touch the cold surfaces in the freezer
compartment, particularly when your hands are damp or wet. Skin could adhere to these
extremely cold surfaces.

Unplug the power cord from the power outlet for cleaning or other maintenance. Never
touch the appliance with wet hands as you may receive an electric shock or injure yourself.

Never damage, press, severely bend, pull or twist the power cord as damage to the cord
may cause re or electric shock. Never touch the cord if you are uncertain if the appliance
is correctly earthed.

Never place glass items in the freezer as they may break due to expansion of their contents
on freezing.

Never put your hands into the storage bin of the automatic ice maker as you could be
injured during its operation.

The appliance is not intended for use by young children or inrm persons without
supervision.

Young children should be supervised to ensure that they do not play with the appliance.
Never allow anyone to climb, sit, stand or hang on the refreshment centre door. These

actions may damage the refrigerator and even tip it over, causing severe personal injury.
It is advised that this appliance should be connected through an independent power

socket to prevent it and other appliances from overloading the circuit and causing a power
outage.

The appliance should be positioned so that the supply plug is easily accessible for quick
disconnection should an accident occur.

If the supply cord is damaged, it must be replaced by the manufacturer or its service agent
or a similarly qualied person in order to avoid a hazard.

Do not modify or extend the Power Cord length.

It may cause electric shock or re.

4

compartment of this unit. These numbers

*Non dispenser model

Introduction

Dairy corner

NOTE

• Parts, features, and options vary by model. Your model may not include every option.

Introduction

*Dispenser model

Dairy corner

NOTE

• Parts, features, and options vary by model. Your model may not include every option.

7

Select a good

location

Installation

Where to install

1. Place your appliance where it is easy to use.

2. Avoid placing the unit near heat sources, di­rect sunlight or moisture. Do not operate the
appliance outdoors where it can be exposed
directly, or indirectly to sun, wind and rain.

3. To ensure proper air circulation around the

space on both the sides as well as top and
maintain at least 2 inches (5 cm) from the
rear wall.

4. To avoid vibrations, the appliance must be
levelled.

5. Do not install the appliance in temperatures
of less than 5°C as the performance may be

Disposal of the

old appliance

Door removal

Remove lower

cover and then

feed water

tube

Remove the

freezer

compartment

door

als which are reusable and/or recyclable.
All the packaging materials should be sent to the collection centre for recycling. For
details of your local recycling centre, please contact your local council.

Electric Shock Hazard
Disconnect electrical supply to refrigerator before installing. Failure to do so could

result in death or serious injury.
If your front door is too narrow to get

Applicable to No Plumbing

Ice & Water Model only

the refrigerator into the house,
remove the refrigerator doors and pass
the appliance through laterally.

Lower cover

Remove the lower cover by loosening
all the screws. Then push in the feed
water tube while depressing the
connector , as shown in the illustration

Feed water tube

on the right.

NOTE

• If a tube end is deformed or abraded, trim the end with sharp knife until perfectly round.

1) Remove the hinge cover by
loosening the screws. Then sepa-

Hinge
cover

Connection
wires

rate all connection wires except
for the earth.

2) Remove the keeper by rotating it
counter clockwise ( ) and then
lifting the upper hinge up ( ).

①

②

Upper
hinge

Keeper

Earth line

Upper hinge

-

NOTE

• When removing the upper hinge, be careful that the door does not fall forwards .

Installation

3) Remove the freezer compartment door
by lifting it upward. The door should be
lifted high enough for the feed water
pipe tube to be completely pulled out.

Lower cover

NOTE

• If you have removed the refrigerator compartment door to pass the appliance
through an access door, lay the door down, but be careful not to damage the feed
water pipe tube.

water feed pipe tube to
be completly pulled out

Enough for

Remove the

refrigerator

compartment

door

Pass the

refrigera

tor

1) Loosen the hinge cover screws and
remove the cover. Remove
connection wires, if any, except for
the earth line.

Connection

2) Remove keeper by rotating it
clockwise ( ) and then remove the
upper hinge by lifting it up ( ).

①

②

3) Remove the refrigerator
compartment door by lifting it up.

Pass the refrigerator laterally through

the access door as illustrated to
the right.

wires

Upper hinge

Keeper

Lower hinge

Door replacement

Once the fridge is through the access door, remount the fridge doors by following
the door removal instructions in reverse.

9

installation

Warning

compartment

door is lower than

compartment

door

Installation

Feed water pipe installation (Dispenser model only)

erofeB

rezeerf eht fI

rotaregirfer eht

▪Automatic ice maker operation needs water pressure of 147~834kPa

(1.5~8.5kgf/cm2) (The pressure is correct when an instant paper cup (180cc) is

▪If water pressure does not reach the rating 147kPa(1.5kgf/cm2) or below, it

is necessary to purchase a separate pressure pump for normal automatic icing
and cool water feed.

▪Keep the total length of the feed water pipe tube within 8m and be careful that

the tube does not bend. If the tube is 8m or longer it may cause water feed prob­lems owing to the drain water pressure.

▪Install the feed water pipe tube at a place free from heat.
▪

Door height adjustment

Levelthedoorbyinsertingflat(-type)driverintothegrooveoftheleftheight
adjustingscrewandrotateitclockwise().

①

Height

compartment

door is higher than

compartment

door

Left height

adjustment screw

rezeerf eht fI

Levelthedoorbyinsertingflat(-type)driverintothegrooveoftheleftheight
adjustingscrewandrotateitclockwise().

①

rotaregirfer eht

Height

10

Right height

adjustment screw

Installation

zer eerfeht fI

compartment

door is lower than

the ref or taregir

compartment

door

(on some model)

zer eerfeht fI

compartment

door is higher than

ref or taregireht

compartment

door

(on some model)

Insert the transparent sheet supplied with the product wen the freezerdoor is lower
then the refrigerator door

Separate the door with the lower height, use the (+) type screwdriver to unscrew
the screw at the bottom hinge as shown at Figure ( ), insert the transparent sheet

as shown at Figure ( )

Make adjustments when the refrigerator door is lower then the freezer door while
using the refrigerator.

Use the adjustment tool ( ) to rotate the adjustment hinge pin ( ) in either
clockwise or counterclockwise direction to level the height of the refrigerator
to that of the freezer.

②

①

①

②

Warning

After levelling

the door height

Next

Do not adjust the height axcessively. You can lose the hinge pin.
Height adjustable range: Maximum of 5mm)

Therefrigeratordoorswillclosesmoothlybyadjustingthefrontsideusingthe

height adjustment screw. If the doors do not close correctly, performance may be

thoroughly.

2. Install accessories such as the ice cube box, cover evaporating tray, etc., in their
proper places. They are packed together to prevent possible damage during
shipping.

3. Connect the power supply cord (or plug) to the outlet. Don’t double up with

11

other appliances on the same outlet.