LG GW-L227-YRMV, GW-P227-YRMV User Manual

Electrical Connections

(In the UK Only)

Important

The wires in this mains lead are coloured in accordance with the following code :

GREEN AND YELLOW : EARTH

BLUE : NEUTRAL

BROWN : LIVE

This appliance must be earthed

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows :

The wire which is coloured Green and Yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol( ) or coloured Green or Green and Yellow.

The wire which is coloured Blue must be connected to the terminal which is marked with the letter N or coloured Black.

The wire which is coloured Brown must be connected to the terminal which is marked with the letter L or coloured Red.

If a 13 amp(BS 1363) plug is used, fit a 13 amp BS 1362 fuse.

Table of contents

Introduction

Installation

Operation

Entry

Important safety instruction

Identication of parts

Where to install

Door removal

Door replacement

Feed water pipe installation

Height adjustment

Starting

Adjusting the temperatures and functions

Refreshment center (Applicable to some models only)

Shelf (Applicable to some models only)

Wine holder (Applicable to some models only)

Egg box

Suggestion on

food storage

Care and

maintenance

Humidity control in the vegetable compartment

Convert into a vegetable or meat compartment (Applicable to some models only)

Deodorizer (Applicable to some models only)

Miracle Zone Temperature Transition Corner (Applicable to some models only)

Temperature Change at Miracle Zone (Applicable to some models only)

Miracle Zone (Applicable to some models only)

Location of foods

Storing foods

How to dismantle parts

General information

Cleaning

Trouble shooting

Entry

The model and serial numbers are found on the inner case or back of refrigerator compartment of this unit. These numbers are unique to this unit and not available to others. You should record requested information here and retain this guide as a permanent record of your purchase. Staple your receipt here.

Date of purchase : Dealer purchased from : Dealer address : Dealer phone no. : Model no. : Serial no. :

Before it is used, this refrigerator must be properly installed and located in accordance with the installation instructions in this document.

Never unplug your refrigerator by pulling on the power cord. Always grip plug firmly and pull it straight out from the outlet.

When moving your appliance away from the wall, be careful not to roll over the power cord or to damage it in any way.

After your refrigerator is in operation, do not touch the cold surfaces in the freezer compartment

, particularly when your hands are damp or wet. Skin could adhere to

these extremely cold surfaces. Unplug the power cord from the power outlet for cleaning or other requirements. Never

touch it with wet hands because you can get an electric shock or be hurt. Never damage, process, severely bend, pull out, or twist the power cord because

damage the power cord may cause a fire or electric shock. You have doubts on whether the appliance is properly grounded.

Never place glass products in the freezer because they may be broken due to expansion when their contents are frozen.

Never allow your hands within the ice storage bin of the automatic ice maker. You could be hurt by the operation of the automatic ice maker.

The appliance is not intended for use by young children or infirm persons without supervision.

Young children should be supervised to ensure that they do not play with the appliance. Never allow anyone to climb, sit, stand or hang on the refreshment center door. These

actions may damage the refrigerator and even tip it over, causing severe personal injury. If possible, connect the refrigerator to its own individual electrical outlet to prevent it and

other appliances or household lights from causing an overload that could cause a power outage.

The refrigerator-freezer should be so positioned that the supply plug is accessible for quick disconnection when accident happens.

If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

Do not modify or extend the Power Cord length.



It will cause electric shock or fire.

Introduction

Important safety instruction

Don’t use an

extension cord

Accessibility of

Supply Plug

Supply Cord

Replacement

Warning

Introduction

Child entrapment

warning

Don’t store

warning

Grounding (Earthing)

warning

DANGER: Risk of child entrapment. Before you throw away your old refrigerator or freezer:

inside.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

any other appliance.

In the event of an electric short circuit, grounding (earthing) reduces the risk of electric shock by providing an escape wire for the electric current. In order to prevent possible electric shock, this appliance must be grounded

electrician or service person if the grounding instructions are not completely understood, or if you have doubts on whether the appliance is properly grounded.

*Non dispenser model

Freezer Compartment

Refrigerator Compartment

Milk product corner

Door rack

Shelf or Drawer

Lamp

Shelf or Drawer

Door rack

Drawer (2 or 3)

Door rack

Lower cover

Lamp Shelf Wine holder (Plastic or wire) Door rack (1piece or 2piece)

Shelf

Snack drawer (Optional)

Shelf (Folding or Normal)

Refreshment center (Optional)

Egg Box

Door rack (1piece or 2piece)

Vegetable Drawer (1 or 2)

Door Rack

Humidit Opti Temp Zone(Optional)

Fresh compartment (Optional)

Conversion switch (Meats/Vegetables) (Optional)

NOTE

•

Parts, features, and options vary by model. Your model may not include every option.

y switch

Introduction

*Dispenser model

Automatic

Icemaker

Shelf or Drawer

Lamp

Shelf or Drawer

Drawer

Door rack

Drawer (2 or 3)

Door rack

Lower cover

Freezer Compartment

Refrigerator Compartment

Milk product corner

Lamp Shelf Wine holder (Plastic or wire) Door Rack

Shelf

Can Server Snack drawer (Optional)

Shelf (Folding or Normal)

Refreshment center (Optional)

Egg Box

Vegetable Drawer (1 or 2)

Humidity switch

Opti Temp Zone (Optional) Fresh compartment (Optional)

Door Rack

Conversion switch (Meats/Vegetables) (Optional)

(Optional)

NOTE

•

Parts, features, and options vary by model. Your model may not include every option.

Where to Install

Installation

Select a good

location

Disposal of the

old appliance

Warning

Remove lower

cover and

then feed water

tube

1. Place your appliance where it is easy to use.

2. Avoid placing the unit near heat sources, direct sunlight or moisture.

3. To ensure proper air circulation around the

space on both the sides as well as top and maintain at least 2 inches (5 cm) from the rear wall.

4. To avoid vibrations, the appliance must be leveled.

5. Don't install the appliance below 5°

which are reusable and/or recyclable. All the important materials should be sent to the collection center of waste material and can be reused after rework (recycling). For take back, please contact with the local agency.

Door removal

Electric Shock Hazard

Disconnect electrical supply to refrigerator before installing. Failure to do so could result in death or serious injury.

If your access door is too narrow for the refrigerator to pass through, remove the refrigerator door and pass the refrigerator laterally.

Remove the lower cover by loosening all the screws. Then pull up the feed water tube while pressing

Warning

Remove

top cover and

then cover

hinges

NOTE

•

If a tube end is deformed or abraded, cut the part away.

Top Cover Removal

Electric Shock Hazard

Disconnect electrical supply to refrigerator before installing.

Watch out of sharp edges Cover might contains sharp edges, avoid them.

1) Removing the cover by loosening all the screws.

Installation

2) Remove the cover in the direction shown on picture.

3) While disassembling and assembling watch out of damaging power cord.

Remove the

freezer

compartment

door

Remove the

refrigerator

door

Hinge

1) Removing the hinge cover by loosening the

cover

screws. Separate all connection wires except for the earth line after.

2) Remove the keeper by rotating it counter )

clockwise ( hinge up (

and then lifting the upper

Upper hinge

Keeper

Upper hinge

NOTE

•

When removing the upper hinge, be careful that the door does not fall forwards .

3) Remove the freezer compartment door by

lifting it upward. This time, the door should be lifted enough for the feed water pipe tube to be completely pulled out.

Lower hinge

NOTE

•

Move the refrigerator compartment door passing through the access door and lay it down, but be careful not to damage the feed water pipe tube.

1) Loosen the hinge cover screws and remove

the cover. Remove connection wire, if any, except for the earth line.

Connection

wires

Connection wires

Earth line

2) Remove keeper by rotating it clockwise (

and then remove the upper hinge by lifting it up ( ).

3) Remove the refrigerator compartment door

by lifting it up.

)

Upper hinge

Lower hinge

Keeper

Installation

Door replacement

Feed water pipe installation

(*Dispenser model only)

Pass the refrigerator laterally through the access door as shown in the right figure.



Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5 kgf/cm2) (That is, an instant paper cup (180 cc) will be fully filled within 3 sec.).



If water pressure does not reach the rating 147 kPa (1.5 kgf/cm2) or below, it is necessary to purchase a separate pressure pump for normal automatic icing and cool water feed.



Keep the total length of the feed water pipe tube within 8 m and be careful for the tube not be bent. If the tube is 8 m or longer it may cause trouble in water feed owing to the drain water pressure.



Install the feed water pipe tube at a place free from heat.



Connect to potable water supply only.



Refer to instructions with water filter kit for installation.

Mount them in the reverse sequence of removal after they pass through the access door.

Pass the

refrigerator

Before

installation

Warning

M a x

R Z

M P RE F TE MP

Mi n

Ma x

Installation

Height adjustment

Level the door by inserting flat (-type) driver into the groove of the left height adjusting screw and rotate it clockwise ().

Level the door by inserting flat (-type) driver into the groove of the right height adjusting screw and rotate it clockwise ().

The refrigerator doors will close smoothly by heightening the front side by adjusting the height adjusting screw. If the doors do not close correctly, performance may be affected.

If the freezer

compartment door

is lower than the

refrigerator

compartment door

If the freezer

compartment door

is higher than the

refrigerator

compartment door

After leveling the

door height



1. Wipe off all dust accumulated during shipping and clean your appliance thoroughly.

2. Install accessories such as the ice cube box, cover evaporating tray, etc., in their proper places. They are packed together to prevent possible damage during shipping.

3. Connect the power supply cord (or plug) to the outlet. Don't double up with other appliances on the same outlet.

+ 21 hidden pages