LG GR-P227ZGB Owner’s Manual

<![if ! IE]>

<![endif]>ENGLISH

OWNER’S MANUAL

SXS

REFRIGERATOR

Please read this owner's manual thoroughly before operating and keep it handy for reference at all times.

P/No. : MFL38898120

www.lg.com

Introduction

Installation

Operation

Suggestion on food storage

Care and maintenance

Table of contents

	3
Important safety instruction	3
Identification of parts	4
Where to install	5
Door removal	6
Door replacement	7
Feed water pipe installation	7
Height adjustment	8
Starting	9
Adjusting the temperatures and functions	9

Refreshment center (Applicable to some models only) Shelf (Applicable to some models only)

Wine holder (Applicable to some models only) Egg box (Applicable to some models only) Humidity control in the vegetable compartment

Convert into a vegetable or meat compartment (Applicable to some models only) Deodorizer (Applicable to some models only)

Miracle Zone Temperature Transition Corner (Applicable to some models only) Temperature Change at Miracle Zone (Applicable to some models only) Miracle Zone (Applicable to some models only)

Location of foods

Storing foods

How to dismantle parts

General information

Cleaning

Trouble shooting

When replacing PANEL…….

2

Introduction

Entry
The model and serial numbers are found on the inner case or back of refrigerator
compartment of this unit. These numbers are unique to this unit and not
available to others. You should record requested information here and retain
this guide as a permanent record of your purchase. Staple your receipt here.
Date of purchase	:
Dealer purchased from	:
Dealer address	:
Dealer phone no.	:
Model no.	:
Serial no.	:

	Important safety instruction
	Before it is used, this refrigerator must be properly installed and located in accordance
	with the installation instructions in this document.
	Never unplug your refrigerator by pulling on the power cord. Always grip plug firmly and
	pull it straight out from the outlet.
	When moving your appliance away from the wall, be careful not to roll over the power
	cord or to damage it in any way.
	After your refrigerator is in operation, do not touch the cold surfaces in the freezer
	compartment, particularly when your hands are damp or wet. Skin could adhere to
	these extremely cold surfaces.
	Unplug the power cord from the power outlet for cleaning or other requirements. Never
	touch it with wet hands because you can get an electric shock or be hurt.
	Never damage, process, severely bend, pull out, or twist the power cord because
	damage the power cord may cause a fire or electric shock. You have doubts on whether
	the appliance is properly grounded.
	Never place glass products in the freezer because they may be broken due to expansion
	when their contents are frozen.
	Never allow your hands within the ice storage bin of the automatic ice maker. You could
	be hurt by the operation of the automatic ice maker.
	Young children should be supervised to ensure that they do not play with the appliance.
	Never allow anyone to climb, sit, stand or hang on the refreshment center door. These
	actions may damage the refrigerator and even tip it over, causing severe personal injury.
Don’t use an	If possible, connect the refrigerator to its own individual electrical outlet to prevent it and
extension cord	other appliances or household lights from causing an overload that could cause a power
Accessibility of	outage.
	The refrigerator-freezer should be so positioned that the supply plug is accessible for
Supply Plug	quick disconnection when accident happens.
Supply Cord	If the supply cord is damaged, it must be replaced by the manufacturer or its service
Replacement	agent or a similarly qualified person in order to avoid a hazard.
Warning	Do not modify or extend the Power Cord length.
Don’t store	It will cause electric shock or fire.
	Don’t store or use gasoline or other flammable
	vapor and liquids in the vicinity of this or any other appliance.
	3

	Introduction
Child entrapment	DANGER: Risk of child entrapment.
warning	Before you throw away your old refrigerator or freezer:
	Take off the doors but leave the shelves in place so that children may not easily climb
	inside.
Warning	This appliance is not intended for use by persons (including children) with reduced
	physical, sensory or mental capabilities, or lack of experience and knowledge, unless
	they have been given supervision or instruction concerning use of the appliance by a
	person responsible for their safety.
Warning	Children should be supervised to ensure that they do not play with the appliance.
Grounding (Earthing)	In the event of an electric short circuit, grounding (earthing) reduces the risk of electric
warning	shock by providing an escape wire for the electric current.
	In order to prevent possible electric shock, this appliance must be grounded
	improper use of the grounding plug can result in an electric shock. Consult a qualified
	electrician or service person if the grounding instructions are not completely
	understood, or if you have doubts on whether the appliance is properly grounded.
	Identification of parts

Automatic

Icemaker

Shelf

Lamp

Shelf

Door rack

Drawer (2 or 3)

Door rack

Lower cover

Freezer

Compartment

Refrigerator

Compartment

Milk product corner

Lamp

Shelf

Wine holder (Plastic or wire)

Door Rack

Shelf

Can Server (Optional) Snack drawer (Optional)

Shelf (Folding or Normal)

Refreshment center (Optional)

Egg Box

Vegetable Drawer (1 or 2)

Humidity switch

Miracle Zone (Optional) Fresh compartment (Optional)

Door Rack

Conversion switch (Meats/Vegetables) (Optional)

NOTE

• Parts, features, and options vary by model. Your model may not include every option.

4

Installation

	Where to Install
Select a good	1. Place your appliance where it is easy to
location		use.
	2.	Avoid placing the unit near heat sources,
		direct sunlight or moisture.
	3.	To ensure proper air circulation around the
		fridge -freezer, please maintain sufficient
		space on both the sides as well as top and
		maintain at least 2 inches (5 cm) from the
		rear wall.
	4.	To avoid vibrations, the appliance must
		be leveled.
	5.	Don't install the appliance below 5°C. It may cause affect the performance.
Disposal of the	This appliance contains fluid (refrigerant, lubricant)and is made of parts and materials
old appliance	which are reusable and/or recyclable.
	All the important materials should be sent to the collection center of waste material
	and can be reused after rework (recycling). For take back, please contact with the
	local agency.

5

Installation

		Door removal
	Warning	Electric Shock Hazard
		Disconnect electrical supply to refrigerator before installing.
		Failure to do so could result in death or serious injury.
		If your access door is too narrow for the
		refrigerator to pass through, remove the		Lower cover
		refrigerator door and pass the refrigerator laterally.
	Remove lower
		Remove the lower cover by lifting upward, and then
	cover and	pull up the feed water tube while pressing area
	then feed water	shown in the figure to the right.		Feed water tube
	tube
		NOTE
		• If a tube end is deformed or abraded, cut the part away.
			Hinge	Connection
			cover
	Remove the	1) Removing the hinge cover by loosening the		wires
	freezer	screws. Separate all connection wires except
	compartment	for the earth line after.		Earth line
	door	Upper hinge
				Upper hinge
		2) Remove the keeper by rotating it counter	Keeper

clockwise ( ) and then lifting the upper hinge up ( ).

NOTE

• When removing the upper hinge, be careful that the door does not fall forwards .

3) Remove the freezer compartment door by

lifting it upward. This time, the door should be lifted enough for the feed water pipe tube to be completely pulled out.

Lower hinge

NOTE

•Move the refrigerator compartment door passing through the access door and lay it down, but be careful not to damage the feed water pipe

Remove the	1) Loosen the hinge cover screws and remove
refrigerator	the cover. Remove connection wire, if any,
door	except for the earth line.	Connection
		wires
		Upper hinge	Keeper

2) Remove keeper by rotating it clockwise ( ) and then remove the upper hinge by lifting it up ( ).

3)Remove the refrigerator compartment door by lifting it up.

6

Lower hinge

Installation

Pass the Pass the refrigerator laterally through the access refrigerator door as shown in the right figure.

Door replacement

Mount them in the reverse sequence of removal after they pass through the access door.

Feed water pipe installation

Before Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5 installation kgf/cm2) (That is, an instant paper cup (180 cc) will be fully filled within 3 sec.).

If water pressure does not reach the rating 147 kPa (1.5 kgf/cm2) or below, it is necessary to purchase a separate pressure pump for normal automatic icing and cool water feed.

Keep the total length of the feed water pipe tube within 8 m and be careful for the tube not be bent. If the tube is 8 m or longer it may cause trouble in water feed owing to the drain water pressure.

Install the feed water pipe tube at a place free from heat.

Warning

Connect to potable water supply only.

Refer to instructions with water filter kit for installation.

7

Installation

Height adjustment

If the freezer

Level the door by inserting flat ( - type) driver into the groove of the left height adjusting

compartment door

screw and rotate it clockwise ( ).

is lower than the

refrigerator

compartment door

If the freezer

Level the door by inserting flat ( - type) driver into the groove of the right height

compartment door

adjusting screw and rotate it clockwise ( ).

is higher than the

refrigerator

compartment door

After leveling the	The refrigerator doors will close smoothly by heightening the front side by adjusting
door height	the height adjusting screw. If the doors do not close correctly, performance may be
	affected.

Next 1. Wipe off all dust accumulated during shipping and clean your appliance thoroughly.

2.Install accessories such as the ice cube box, cover evaporating tray, etc., in their proper places. They are packed together to prevent possible damage during shipping.

3.Connect the power supply cord (or plug) to the outlet. Don't double up with other appliances on the same outlet.

8

Operation

Starting

When your refrigerator is first installed, allow it to stabilize at normal operating temperatures for 2-3 hours prior to filling it with fresh or frozen foods.

If operation is interrupted, wait 5 minutes before restarting.

Adjusting the temperatures and functions

Refreshment Center

Button

Refreshment Center

(hidden)

Function display board

Display Power Saving Mode

NOTE

• Your model may not include every option.

9