when the freezer door does not align with the height of the refrigerator door
Starting
Adjusting the temperatures and functions
Refreshment center (Applicable to some models only)
Wine holder
Ice making
Deodorizer(Applicable to some models only)
Egg box
Humidity control in the vegetable compartment
Convert into a vegetable or meat compartment
(Applicable to some models only)
Location of foods
Storing foods
How to dismantle parts
General information
Cleaning
Trouble shooting
Table of contents
Introduction
Installation
Operation
Suggestion on
food storage
Care and
maintenance
3
3
4
6
7
7
7
8
8
10
11
11
11
12
12
12
13
14
15
16
16
17
5
The working life of this set is 7 years since the date of delivery to consumer.
Introduction
Entry
The model and serial numbers are found on the inner case or back of refrigerator
compartment of this unit. These numbers are unique to this unit and notavailable
to oth ers. You should record requested information here and retain this guide as a
permanent record of your purchase. Staple your receipt here.
Date of purchase :
Dealer purchased from :
Dealer address :
Dealer phone no. :
Model no. :
Serial no. :
Important safety instruction
This refrigerator must be properly installed and located in accordance with the
installation instructions before it is used.
Never unplug your refrigerator by pulling on the power cord. Always grip plug
rmly and pull straight out from the outlet.
When moving your appliance away from the wall, be careful not to roll over or
damage the power cord.
Don’t use an
extension cord
Accessibility of
Supply Plug
After your refrigerator is in operation, do not touch the cold surfaces in the freezer
compartment, particularly when hands are damp or wet. Skin may adhere to these
extremely cold surfaces.
Unplug the power cord from the power plug for cleaning or other cares. Never
touch it with wet hands because you can get an electric shock or be hurt.
Never damage, process, severely bend, pull out, or twist power cord because
power cord damage may cause a fire or electric shock. You have doubts on
whether the appliance is properly grounded.
Never place glass products in the freezer because they may be broken when their
inner matters are frozen.
The appliance is not intended for use by young children or inrm persons without
supervision.
Young childeren should be supervised to ensure that they do not play with the
appliance.
Never allow anyone to climb, sit, stand or hang on the refreshment center door.
These actions may damage the refrigerator and even tip it over, causing severe
personal injury.
If possible, connect the refrigerator to its own individual electrical outlet to prevent
it and other appliances or household lights from causing an overload that could
cause a power outage.
The refrigerator-freezer should be so positioned that the supply plug is accessible
fo rquick disconnection when accident happens.
Supply Cord
Replacement
Warning
If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualied person in order to avoid a hazard.
Do not modify or extend the Power Cord length.
•
It will cause electric shock or re.
3
4
Introduction
DANGER: Risk of child entrapment.
Before you throw away your old refrigerator or freezer:
Take off the doors
Leave the shelves in place so that children may not easily climb inside.
The appliance is not intended for use by young children or infirm persons without
supervision.
Young children should be supervised to ensure that they do not play with the
appliance.
Don’t store or use gasoline or other flammable vapor and liquids in the vicinity of this
or any other appliance.
In the event of an electric short circuit, grounding (earthing) reduces the risk of electric
shock by providing an escape wire for the electric current.
In order to prevent possible electric shock, this appliance must be grounded
improper use of the grounding plug can result in an electric shock. Consult a qualified
electrician or service person if the grounding instructions are not completely
understood, or if you have doubts on whether the appliance is properly grounded.
Identification of parts
NOTE
• If you find some parts missing from your unit, they may be parts only used in other
models.
Child entrapment
warning
Don’t store
Grounding (Earthing)
Conversion switch
(Meat/Vegetables)
Installation
Where to install
Select a good
location
Disposal of the
old appliance
1. Place your appliance where it is easy to
use.
2. Avoid placing the unit near heat sources,
direct sunlight or moisture.
3. To ensure proper air circulation around the
fridge -freezer, please maintain sufcient
space on both the sides as well as top
and maintain at least 2 inches (5 cm) from
the rear wall.
4. To avoid vibrations, the appliance must be leveled.
5. Don't install the appliance below 5℃ . It may cause affect the performance.
This appliance contains fluid (refrigerant, lubricant)and is made of parts and materials which are reusable and/or recyclable.All the important materials should be sent to the collection center of waste materialand can be reused after rework (recycling). For take back, please contact with thelocal agency.
5
Installation
Lower
cover
Hinge
cover
Upper hinge
Keeper
Upper
hinge
Installation
Installation
Lowercover
Lower hinge
Keeper
wires
Hingecover
Upperhinge
Upper hinge
Keeper
Upperhinge
Warning
Remove lower
cover
Remove the
freezer
compartment
door
Door removal
Electric Shock Hazard
Disconnect electrical supply to refrigerator before installing.
Failure to do so could result in death or serious
injury.
If your access door is too narrow for the
refrigerator remove the refrigerator door and
pass the refrigerator laterally.
Remove the lower cover by lifting upward.
1) Loosen the hinge cover screws and remove
the cover.
2) Remove the keeper by rotating it to counter
clockwise (①) and then lifting the upper
hinge up(②).
NOTE
• When removing the upper hinge, be careful that the door does not fall forwards.
Remove the
refrigerator
Pass the
refrigerator
door
3) Remove the freezer compartment door by
lifting it upward.
1) Loosen the hinge cover screws and remove
the cover. Remove connection wire,if any,
except for the earth line.
2) Remove keeper by rotating it clockwise ( ① )
and then remove the upper hinge by
lifting it up ( ② ).
3) Remove the refrigerator compartment door by
lifting it up.
Pass the refrigerator laterally through access
door as shown in the right gure.
6
Installation
Door replacement
Mount them in the reverse sequence of removal after they pass through the access door.
Height adjustment
If the height of
freezer compart-
ment door is
different from the
height of Refrig-
erator compart-
ment door
lf the freezer compartment
door is lower than the refrigerator compartment door
Level the door by inserting flat(-type)
driver into the groove of the left
height adjusting screw and rotate it
clockwise(
① ).
If the freezer compartment
door is higher than the refrigerator compartment door
Level the door by inserting flat(-type)
driver into the groove of the right
height adjusting screw and rotate it
clockwise(
① ).
When the freezer door does not align with
the height of the refrigerator door
Even if the height can not be aligned by using the heightadjustment
screw, insert the transparent sheet supplied with the product.
After leveling the
door height
Next
• Separate the door with the lower height, use the (+) type screwdriver to
unscrew the screw at the bottom hinge as shown at Figure①, insert the
transparent sheet between the bottom hinge and the bottom bracket, and then
fix it with the screw as shown at Figure②.
• Insert more transparent sheets enough to align the height. (4 sheets ard supplied
in total.)
Bottom hinge
①
The refrigerator doors will close smoothly by heightening the front side by adjusting the
height adjusting screw.If the doors do not close correctly,performance maybe
1. Wipe off all dust accumulated during shipping and clean your appliance thoroughly.
2. Install accessories such as the ice cube box, cover evaporating tray, etc., in their
proper places. They are packed together to prevent possible damage during shipping.
3. Connect the power supply cord (or plug) to the outlet. Don't double up with other
appliances on the same outlet.
7
②
Bottom bracket
Transparent sheet
Operation
Starting
When your refrigerator is rst installed, allow it to stabilize at normal operating
temperatures for 2-3 hours prior to lling it with fresh or frozen foods.
If operation is interrupted, wait 5 minutes before restarting.
Adjusting the temperatures and functions
NOTE
• Your model may not include every option.
8
Operation
How to adjust
the temperature
in the freezer
compartment
How to adjust
the temperature
in the
refrigerator
compartment
Display Power Saving Mode
This function places the display into power saving mode until the next time the door
is opened.
Press the FREEZER and EXPRESS FRZ. buttons simultaneously and hold them for 5
seconds until the Ding sounds. All LED/LCDs will then turn ON, then OFF. When the
power saving mode is activated, the display will remain off until the next time the
door is opened. Then, it will come on whenever a door is opened or a button is
pressed and remain on for 20 seconds after the last door opening or button selection.
To deactivate the power saving mode, press the FREEZER and EXPRESS FRZ.
buttons simultaneously and hold them for 5 seconds until the Ding sounds.
You can adjust temperature of and freezer room and refrigerator room.
Express freezer
(Applicable to
some models
only)
Lock
(Applicable to
some models
only)
Door open alarm
Self-diagnosis
(fault detection)
function
* Whenever pressing button, setting is repeated in the order of (Middle)➔(Middle
Strong)➔(Strong)➔(Weak)➔(Middle Weak).
The actual inner temperature varies depending on the food status, as the
indicated setting temperature is a target temperature, not actual temperature
within refrigerator.
Refrigeration function is weak in the initial time. Please adjust temperature
as above after using refrigerator for minimum 2~3 days.
Please select this function for
promptfreezer.
off➔ on➔off is repeated
whenever pressing button.
The arrow mark graphic remains at the
"on" when selecting Special Refrigeration "on".
Prompt freezer function automatically turns off after a fixed time passes.
This button stops operation ofdifferent button.
Locking or Release is repeated whenever
the is pressed more than
3 seconds.
lf you use the button,
none of the other buttons will work
until you unlock them.
An alarm will sound 3 times when the refrigerator door is left open for more than 1minute.
This alarm will be rung at an intervals of 30 sec. and stop at the close of the door. If the
alarm sound does not stop even after the freezer and refrigerator compartment doors are
closed, contact the service center.
Self-diagnosis function operates when a problem occurs in the unit. When an erroro ccurs
in the unit. Immediately contact the service center without turning the power OFF. If the
power is OFF, it will take the engineer longer to nd out where the fault occurs.
The pressing of any function buttons will not alter the temperature setting when a fault
occurs.
9
Operation
Refreshment center(Applicable to some models only)
How to use
Use the
refreshment
center door as a
stand
Never take out
the inner
refreshment
center cove
Open the refreshment center door.
You can access the refreshment center
without opening refrigerator door and thus
saving electricity.
Inner lamp is lit in refrigerator compartment
when the refreshment center door opens.
Thus it is easy to identify the contents.
Never use the refreshment center door as a
chopping board and take care not to damage
it with sharp tools.
Never rest your arms or severely press on it.
The refreshment center can not function
normally without the cover.
Never place
heavy items on
the refreshment
center door or
allow children to
hang it on.
Not only can the refreshment center door
may be damaged, but also children may be
hurt.
10
Operation
Operation
Ice Making Box
Wine holder
adjustment
When making Ice
Wine holder
Bottles can be stored laterally with this wine
corner.
This can be attached to any shelf.
In case of inserting the wine holder :
Pull the wine holder downward as in②after
inserting it into the side anchoring part of the
shelf as in① by catching it upward as in① .
In case of separating the wine holder :
Pull the wine holder inward as in④after
holding it upward as in ③by catching it.
Ice Making
Fill water in ice making box of the ice
making corner.
If water is fully lled the ice will not be
separated well and water can be
dropped to make ice lumped.
How to use the
deodorizing
system
Ice will be dropped into the ice storage
bin by rotating ice separation handle of
ice making compartment.
NOTE
Rotating the ice separation handle before ice is fully frozen may cause the
remaining water drop into the ice storage bin to lump the ice together.
Deodorizer
(Applicable to some models only)
This system efciently absorbs strong odors
by using the optical catalyst. This system
does hot have any affect on stored food.
Since it is installed already installed onto the cool air intake duct from the
from the refrigerator compartment, you need no separate installation.
Please use closed containers to store food with pungent odors.
Otherwise, this oder can be absorbed by other food in the compartment.