V
I
ET
N
A
M
MFL68609498
Rev.00_010819
Copyright © 2019 LG Electronics Inc. All Rights Reserved
Automatic Icemaker
Switching the Automatic Icemaker On and Off
14
21
Using LG SmartThinQ Application (Optional)
22
24
24
25
27
Risk of Fire and Flammable Materials
This symbol alerts you to flammable materials that can ignite and cause a
fire if you do not take care.
• This appliance contains a small amount of isobutane refrigerant (R600a), but it is also
ensure combustible. When transporting and installing the appliance, care should be
taken to that no parts of the refrigerating circuit are damaged.
• If a leak is detected, avoid any naked flames or potential sources of ignition and air
the room in which the appliance is standing for several minutes. In order to avoid the
creation of a flammable gas air mixture if a leak in the refrigerating circuit occurs, the
size of the room in which the appliance is used should correspond to the amount of
refrigerant used. The room must be 1 m² in size for every 8 g of R600a refrigerant inside
the appliance.
• When positioning the appliance, ensure the supply cord is not trapped or damaged.
• Do not locate multiple portable socket-outlets or portable power supplies at the rear of
the appliance.
If there is a gas leakage (isobutane, propane,
natural gas, etc.), do not touch the appliance
or power plug and ventilate the area
immediately. This appliance uses a refrigerant
gas (isobutane,R600a). Although it uses a
small amount of the gas, it is still combustible
gas. Gas leakage during appliance transport,
installation or operation can cause fire,
explosion or injury if sparks are caused.
Do not place glass containers,
bottles or cans (especially
those containing carbonated
drinks) in the freezer
compartment, shelves or ice
bin that will be exposed to
temperatures below freezing.
Ambient Temperature
The appliance is designed to operate within a
limited range of ambient temperatures, depending
on the climate zone. Do not use the appliance at
a temperature exceeding the limit.
The internal temperatures could be affected by the
location of the appliance, the ambient temperature,
the frequency of door opening and so on.
The climate class can be found on the rating
label.
Climate Class
SN (Extended
Temperate)
N (Temperate) +16 - +32
ST (Subtropical) +16 - +38
T (Tropical) +16 - +43 / +10 - +43*
*Australia, India, Kenya
Ambient Temperature
Range ºC
+10 - +32
NOTE
• The appliances rated from SN to T are
intended to be used at an ambient
temperature between 10 ºC and 43 ºC.
If the appliance is equipped with a lock (some countries only), keep the key out of reach of children.
6. After installing the appliance, connect the power
plug into a socket outlet. Before moving and
discarding the appliance,disconnect the plug from
the socket outlet.
Dimensions and Clearances
Too small of a distance from adjacent items
may result in degradation of freezing capability
and increased electricity costs. Allow over
50mm clearance from each adjacent wall when
installing the appliance.
B
C
A
D
EFG
H
1335 mm
(Optional)
(Optional)
Auto Icemaker
5
Reglage du Congélateur
5
5
Emplacement recommandé
5
5
5
5
(Fill the tank above the minimum level)
If you fill the tank below the minimun level,ice
and dispensing water amount will be reduced.
30-40
3
1
2
3
4
If you are leaving the appliance turned off for an
extended period of time, remove all food and
unplug the power cord. Clean the interior, and
leave the doors slightly ajar to prevent mold
from growing in the appliance.
Symptoms Reason Solution
• Find the Wi-Fi network connected to
your smartphone and remove it, then
register your appliance on LG
SmartThinQ
• Turn off the Mobile data of your
smartphone and register the
appliance using the Wi-Fi network.
• The wireless network name (SSID)
should be a combination of English
letters and numbers. (Do not use
special characters.)
• Only a 2.4 GHz router frequency is
supported. Set the wireless router to
2.4 GHz and connect the appliance
to the wireless router. To check the
router frequency, check with your
Internet service provider or the
router manufacturer.
• If the distance between the
appliance and the router is too far,
the signal may be weak and the
connection may not be configured
correctly. Move the location of the
router so that it is closer to the
appliance.
Your home appliance
and smartphone is
not connected to the
Wi-Fi network.
The password for the Wi-Fi
that you are trying to connect
to is incorrect.
Mobile data for your
smartphone is turned on.
The wireless network name
(SSID) is set incorrectly.
The router frequency is not 2.4
GHz.
The distance between the
appliance and the router is too
far.
Using LG SmartThinQ
Application(Optional)
• For appliances with the or logo
The LG SmartThinQ application allows you to
communicate with the appliance using a
smartphone
Things to check before using LG
SmartThinQ
Check the distance between the appliance
1
and the wireless router (Wi-Fi network).
• If the distance between the appliance and
the wireless router is too far, the signal
strength becomes weak. It may take a
long time to register or installation may
fail.
Turn off the Mobile data or Cellular Data
2
on your smartphone.
• For iPhones, turn data off by going to
Settings → Cellular → Cellular Data.
Connect your smartphone to the wireless
3
router.
NOTE
• To verify the Wi-Fi connection, check that
Wi-Fi icon on the control panel is lit.
• The appliance supports 2.4 GHz Wi-Fi
networks only. To check your network
frequency, contact your Internet service
provider or refer to your wireless router
manual.
• LG SmartThinQ is not responsible for any
network connection problems or any faults,
malfunctions, or errors caused by network
connection.
• If the appliance is having trouble connecting to
the Wi-Fi network, it may be too far from the
router. Purchase a Wi-Fi repeater (range
extender) to improve the Wi-Fi signal strength.
• The Wi-Fi connection may not connect or may
be interrupted because of the home network
environment.
• The network connection may not work
properly depending on the Internet service
provider.
• The surrounding wireless environment can
make the wireless network service run slowly.
• The appliance cannot be registered due to
problems with the wireless signal
transmission. Unplug the appliance and wait
about a minute before trying again.
• If the firewall on your wireless router is
enabled, disable the firewall or add an
exception to it.
• The wireless network name (SSID) should be
a combination of English letters and numbers.
(Do not use special characters.)
• Smartphone user interface (UI) may vary
depending on the mobile operating system
(OS) and the manufacturer.
• If the security protocol of the router is set to
WEP, you may fail to set up the network.
Please change it to other security protocols
(WPA2 is recommended) and register the
product again.
Installing LG SmartThinQ
Search for the LG SmartThinQ application from
the Google Play Store or Apple App Store on a
smart phone. Follow instructions to download
and install the application.
LG SmartThinQ Application
Features for Wi-Fi modes
Communicate with the appliance from a smart
phone using the convenient smart features.
Firmware Update
Keep the appliance performance updated.
Smart Diagnosis™
If you use the Smart Diagnosis function, you will
be provided with the useful information such as
a correct way of using the appliance based on
the pattern of use.
Settings
Allows you to set various options on the
refrigerator and in the application.
NOTE
• If you change your wireless router, Internet
service provider, or password, delete the
registered appliance from the LG SmartThinQ
application and register it again.
• The application is subject to change for
appliance improvement purposes without
notice to users.
• Functions may vary by model.
Connecting to Wi-Fi
The Wi-Fi button, when used with the LG
SmartThinQ application, allows the refrigerator
to connect to a home Wi-Fi network. The Wi-Fi
icon shows the status of the refrigerator’s
network connection. The icon illuminates when
the refrigerator is connected to the Wi-Fi
network.
NOTE
• To disable the Wi-Fi function, press and hold
the Wi-Fi button for 3 seconds. Wi-Fi icon will
be turned off.
Open Source Software Notice
Information
To obtain the source code under GPL, LGPL,
MPL, and other open source licenses, that is
contained in this product, please visit http://
opensource.lge.com.
In addition to the source code, all referred
license terms, warranty disclaimers and
copyright notices are available for download.
LG Electronics will also provide open source
code to you on CD-ROM for a charge covering
the cost of performing such distribution (such as
the cost of media, shipping, and handling) upon
email request to opensource@lge.com. This
offer is valid for a period of three years after our
last shipment of this product. This offer is valid
to anyone in receipt of this information.
Initial Appliance Registration
Run the LG SmartThinQ application and follow
the instructions in the application to register the
appliance.
Re-registering the Appliance or
Registering Another User
Press and hold the Wi-Fi button for 3 seconds
to temporarily turn it off. Run the LG
SmartThinQ application and follow the
instructions in the application to register the
appliance.
Using Smart Diagnosis
• For appliances with the or logo
Loading...