CAUTION
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK
DO NOT REMOVE COVER(OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
Explanation Graphical Symbols:
The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the
dangerous voltage within the product s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to
persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
WARNING:
TO REDUCE THE RISK OF FIRE OF ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only.
CAUTION
Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus.
(FOR THE CUSTOMERS IN EUROPE)
If this product is marked with the CE-symbol, it means which is conformed to EMC regulation 89/336/EEC.
Laser component in this product is capable of emitting radiation exceeding the limit for Class 1.
CAUTION:
BEAM.
VARNING:
ATTENTION:
This label is located on the interior.
This Compact Disc player
CLASS 1 |
LASER PRODUCT |
is classified as a CLASS 1 |
||
|
|
|||
KLASSE 1 |
LASER PRODUKT |
LASER product. |
|
|
LUOKAN 1 |
LASER LAITE |
|
||
The CLASS 1 |
LASER |
|||
|
|
|||
KLASS 1 |
LASER APPARAT |
PRODUCT label is located |
||
|
|
|||
CLASSE 1 |
PRODUIT LASER |
on the exterior. |
|
|
|
|
|
(FOR CUSTOMERS IN CANADA)
CAUTION: TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD, RECEPTACLE, OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
This class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
WARNING:
SHOCK HAZARD DO NOT OPEN
MISE EN GARDE:
MISE EN GARDE
AVERTISSEMENT
RISQUE DE CHOC ELECTRIQUENE-PAS OUVRIR
(FOR CUSTOMERS IN THE UNITED STATES OF AMERICA)
Note to CATV system Installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.
NOTE:
The interference potential to the device.
This equipment generates and uses radio frequency energy and if not installed and used properly, that is in strict accordance with the manufacturer s instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the limits for a Class B computing device in accordance with the specifications in subparts J of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and in encouraged to try to correct the interference by one of more of the following measures:
Reorients or relocate the
Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an
(FOR CUSTOMERS IN THE UNITED KINGDOM) WIRING INSTRUCTIONS
This appliance is supplied with a BS1363 approved 3 amp fused mains plug. When replacing the fuse always use a 3 amp BS1362 approved type. Never use this plug with the fuse cover omitted. To obtain a replacement fuse cover contact your supplying dealer or LG ELECTRONICS U.K.LTD
If the mains sockets in your home differ, or are not suitable for the type of plug supplied, then the plug should be removed and a suitable type fitted. Please refer to the wiring instructions below:
Warning :
The mains plug severed from the mains lead of this appliance must be destroyed. A mains plug with bared wires is hazardous if engaged in a mains output line socket.
IMPORTANT
The wires in this mains lead are coloured in accordance with the following codes:
Blue |
: |
Neutral |
Brown |
: |
Live |
As the colour of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.
If a 13 amp BS1363 plug or any other type of plug is used, 3 amp BS1362 approved fuse must be fitted either in the plug or at the distribution board.
Warning :
Do not connect either wire to the earth pin, marked with the letter E or with the earth symbol or coloured green or green and yellow.
A note about your operating voltage
Before connecting the unit to an AC outlet, check that the operating voltage of the unit is identical with the voltage of your local power
Selector on the
back of the unit, set to it your required voltage.
2
? Outdoor Antenna Grounding If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges.
?Article 810 of the National Electrical Code,
ANSI/NFPA 70 provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.
?Power Lines An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing
|
an outside antenna system, extreme care should be |
|
taken not to touch such power lines or circuits as |
|
contact with them might be fatal. |
? |
Overloading Do not overload wall outlets, extension |
|
cords, or integral convenience receptacles, as this |
|
can result in a risk of fire or electric shock. |
? |
Object and Liquid Entry Never push objects of any |
|
kind into this product through openings as they may |
|
touch dangerous voltage points or short-out parts that |
|
could result in a fire or electric shock. Never spill |
|
liquid of any kind on the product. |
? |
Servicing Do not attempt to service this product |
|
yourself as opening or removing covers may expose |
|
you to dangerous voltage or other hazards. Refer all |
|
servicing to qualified service personnel. |
? |
Damage Requiring Service Unplug this product from |
|
the wall outlet and refer servicing to qualified service |
|
personnel under the following conditions: |
a)When the power-supply cord or plug is damaged.
b)If liquid has been spilled, or objects have fallen into the product.
c)If the product has been exposed to rain or water.
d)If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.
e)If the product has been dropped or damaged in any way.
f)When the product exhibits a distinct change in performance, this indicates a need for service.
?Replacement Parts When replacement parts are required, be sure the service technician has used
replacement parts specified by the manufacturer or have the same characteristics as the original parts. Unauthorized substitutions may result in fire, electric shock, or other hazards.
? |
Safety Check |
Upon completion of any service or |
|
repairs to this product, ask the service technician to |
|
|
perform safety checks to determine that the product is |
|
|
in proper operating condition. |
|
? |
Wall or Ceiling |
Mounting The product should be |
|
mounted to a wall or ceiling only as recommended by |
|
|
the manufacturer. |
|
? |
Heat The product should be situated away from heat |
|
|
sources such as radiators, heat registers, stoves, or |
other products (including amplifiers) that produce heat.
4