LG FB915BU DISASSEMBLY

DISASSEMBLY
- 11 -
(b)
(b)
(a)
(a)
3. TOP SHIELD REMOVAL
1) Remove two screws (a).
2) Remove four screws (b).
3) Remove two screws (c).
4) Remove two screws (d).
5) Remove two screws (e).
2. BACK COVER REMOVAL
1) Remove two screw covers (a).
2) Remove four screws (b) from the Back Cover.
3) Slide the Back Cover away from the Front Cabinet of the monitor.
(a)
(c)
(b)
(b)
(d)
(b)
(d)
(e)
(e)
(a)
(b)
(c)
(a)
(b)
1. TILT/SWIVEL REMOVAL
1) Set the monitor face downward.
2) Remove screw (a).
3) Pressing the latch (b), carefully remove the Tilt/Swivel by pulling it upward.
- 12 -
5. VIDEO PCB ASSEMBLY REMOVAL
1) Disconnect P201, P202 and Pin (a) from the
Video PCB.
2) Remove screw (b).
3) Remove the Video PCB Assembly from the
interface Assembly.
(a)
(a)
(a)
(b)
(b)
(a)
(a)
P733
P932
P101-P207
P931
6. INTERFACE & CONTROL PCB ASSEMBLY REMOVAL
1) Remove five screws (a).
2) Carefully remove the interface Assembly from the Main PCB Board.
3) Disconnect P101-P207.
4) Remove two screws (b).
5) Remove the control PCB Assembly.
4. TOTAL CHASSIS ASSEMBLY REMOVAL
1) Disconnect P903, P904 (Degaussing pin), P704 (DY pin), P613 (Tilt pin), P610and P611, P612 (Purity pin) from the Main PCB.
2) Disconnect P306 (GND Wire) from the Video PCB.
3) Carefully separate the CDT Board Assembly from the CDT neck.
4) Discharge the remaining static electricity by shorting between the Anode Cap and the CDT ground.
5) Disconnect the Anode Cap from the CDT.
6) Remove three screws (a).
7) Remove two screws (b).
8) Remove the Total Chassis Assembly from the Cabinet.
(b)
P201
(a)
P202
Loading...
+ 1 hidden pages