LG DW-EN500W User manual

DISHWASHER

Please read this manual carefully before operating your
dishwasher. Retain it for future reference.

OWNER'S MANUAL

MODEL : D1420W(L,M,T,B,C,D,A)F(B,U)

D1421W(L,M,T,B,C,D,A)F(B,U)
WZ-6805WF
WZ-6805MF

ONTENTS

C

SAFETY AND CAUTION 3

INSTALLATION INSTRUCTIONS 5

PARTS NAME 9

FUNCTION OF CONTROL BUTTON 10

BEFORE USING FOR THE FIRST TIME 13

HOW TO USE AND OPERATE 15

OPERATING SEQUENCE 21

PROGRAM 22

USER MAINTENANCE INSTRUCTIONS 23

TROUBLE SHOOTING GUIDE 24

SPECIFICATION

3

AFETY AND CAUTION

S

• Please read this manual carefully before using
the dishwasher for the first time.

• This manual contains very important notes
regarding the installation, use and maintenance
of your dishwasher.

• The manufacturer can not be responsible for
problems caused by ignoring these safety and
caution instructions.

• This dishwasher is designed for normal
household use.

• Do not use the dishwasher for industrial and
commercial use, or other purpose.

• The appliance is not intended for use by young
children or infirm persons without supervision.

• Check packaging and dishwasher immediately
for signs of transport damage. If the appliance
is damaged, do not put it into use but contact
your supplier without delay.

During installation

• Electrical connection must be in accordance
with the rating label.

• Electrical safety is only guaranteed when the
earth system of your house is in accordance
with the related local regulations.(Do not use
an extension cable or cord.)

• If the hot water exceeds 65ºC, adjust the water
heater setting. If the hot water temperature can
not be maintained below 65ºC, the dishwasher
must be connected to cold water.

• If power supply cord is damaged, it must only
be replaced by the manufacturer or its service
agent or a similar qualified person in order to
avoid a hazard.

• This appliance must be positioned so that the
plug is accessible.

• The appliance is to be connected to the water
mains using new hose-sets and that old hose­sets should not be reused.

During use

• Only suitable household utensils should be
placed in the dishwasher.
(Please avoid utensils; that are non­heatresistant, metal decorated, etc.)

• Do not use any kinds of solvent in your
dishwasher. They may cause an explosion or
fire.

• Do not spray water on the appliance.
It may cause the failure of electric parts or
electric shock.

• Do not push down or sit on the inner door
when the door opened. It may cause the
deformation or failure of your dishwasher.

• Do not use the detergent for hand washing.
The detergent for dishwasher should be used
for normal operation.

• This appliance is fitted with a safety function
that automatically stops the operation of the
dishwasher when it is exposed to heavy
disturbance on its mains.

• Dishwasher detergents are strongly alkaline.
They can be extremely dangerous if
swallowed. Avoid contact with skin and eyes
and keep children away from the dishwasher
when the door is open.
Check that the detergent receptacle is empty
after completion of the wash cycle.

Child Safety

• Controls may be locked using “Child Lock”
mode to prevent from all the setting from
being changed by a child.

• Keep children away from detergents and rinse­aids.

• Do not allow children to operate the
dishwasher.

• Young children should be supervised to ensure
that they do not play with the appliance.

IMPORTANT SAFETY INSTRUCTIONS

WARNING

- When using your dishwasher, follow basic precautions,
including the following:

AFETY AND CAUTION

S

4

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of a malfunction or breakdown, grounding will
reduce the risk of electric shock by providing a path of least resistance for electric current. This
appliance is equipped with a cord having an equipment-grounding conductor and a grounding
plug. The plug must be plugged into an appropriate outlet that is installed and grounded in
accordance with all local codes and ordinances.

WARNING - Improper connection of the equipment-grounding conductor can result in a risk of
electric shock. Check with a qualified electrician or service representative if you are in doubt
whether the appliance is properly grounded. Do not modify the plug provided with the appliance;
if it will not fit the outlet have a proper outlet installed by a qualified electrician.

SAVE THESE INSTRUCTIONS

concerning the Power Cord

Most appliances recommend they be placed upon a dedicated circuit; that is, a single outlet circuit
which powers only that appliance and has no additional outlets or branch circuits. Check the
specification page of this owner's manual to be certain.
Do not overload wall outlets. Overloaded wall outlets, loose or damaged wall outlets, extension cords,
frayed power cords, or damaged or cracked wire insulation are dangerous. Any of these conditions
could result in electric shock or fire. Periodically examine the cord of your appliance, and if its
appearance indicates damage or deterioration, unplug it, discontinue use of the appliance, and have the
cord replaced with an exact replacement part by an authorized servicer.
Protect the power cord from physical or mechanical abuse, such as being twisted, kinked, pinched,
closed in a door, or walked upon. Pay particular attention to plugs, wall outlets, and the point where the
cord exits the appliance.

The instructions shall state the substance of the following :

This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.

Disposal of your old appliance

1. When this crossed-out wheeled bin symbol is attached to a product
it means the product is covered by the European Directive
2002/96/EC.

2. All electrical and electronic products should be disposed of
separately from the municipal waste stream via designated
collection facilities appointed by the government or the local
authorities.

3. The correct disposal of your old appliance will help prevent
potential negative consequences for the environment and human
health.

4. For more detailed information about disposal of your old appliance,
please contact your city office, waste disposal service or the shop
where you purchased the product.

CAUTION

CAUTION

5

NSTALLATION INSTRUCTIONS

I

Unit:mm

Step 1 :

PREPARE CUPBOARD OPENING

Step 2 :

PREPARATION FOR ELECTICAL WIRING

1

2

3

This appliance must be supplied with
correct rating voltage and hertz as shown
on instruction manual, and connected to
an individual, properly earthed branch
circuit, protected by a minimum 15 amp
circuit breaker or time delay fuse.
Wiring must be 2 wire with Earth.

The power plug must be in a accessible
location adjacent to and not behind the
dishwasher and within 1.2 meters of the
dishwasher side.(See page 7 Fig.A)

The power plug must be correctly
earthed, if in doubt, have it checked by a
qualified Electrician. No other appliance
should be connected to the same plug
outlet by a double adapter or similar
plug.

CAUTION

For personal safety, remove house
fuse or open circuit breaker before
installation. Do not use an extension
cord or adapter plug with this
appliance. Electrical and earthing
connections must comply with the
national electrical code/provincial and
municipal code and/or other local
codes.

Any bare wood surrounding the
dishwasher should be sealed with a
waterproof paint or sealant to prevent
swelling.

Dangerous voltage

To indicate hazards arising
from dangerous voltages.

Note – In case of application
in a warning sign the rules
according to ISO 3864 shall
be adhered to.

WARNING

A qualified electrician/plumber or competent person should carry out any electrical/plumbing
work required to install this appliance.

1

2

3

4

This dishwasher is designed to fit the size
shown as below.

Select a location as close to sink as
possible for ease of connection to the
water and drain pipes.

To ensure good drainage, the dishwasher
should not be installed more than 3 meters
away from the sink.

If dishwasher is installed in a corner, a
minimum of 5cm of space is required
between the washer and an adjacent
cabinet or wall.

NSTALLATION INSTRUCTIONS

I

6

Step 3 :

PREPARING THE DISHWASHER
FOR INSTALLATION

1
2

Lay the dishwasher on its back.

Adjust the legs to the required height
as shown in below figure.

Step 4 :

INST ALLING THE
DISHWASHER IN CUPBOARD

1

2

Before sliding the dishwasher into the
cupboard opening, all necessary height
and balancing adjustments should be
made using a spanner.

Slide the dishwasher into the cabinet
opening carefully. Make sure that the
drain hose inside the cabinet is not
kinked or stretched.

CAUTION

If the height of the cupboard is below
850mm, you should remove the top table
by unscrewing the 2 screws. (Two of rear)

Adjust
leg

7

NSTALLATION INSTRUCTIONS

I

Step 5 :

DRAIN LINE CONNECTION

1

2

3

If the end of drain hose does not fit to
the drain line, use a rubber
connector(not supplied) that is
resistant to heat and detergent.

This should be available from a
plumbing shop or DIY merchants.

There are two typical connections as
shown in Figure A, B.

The “S” trap spigot must be drilled out
cleanly and free of obstruction to its
maximum internal diameter, if used for
drainage.

To prevent siphoning, one of the following
methods must be used:

When the drain hose is connected to a
sink “s” trap or waste disposal unit, the
hose must be looped up to the underside
of the bench top and secured.

When the drain hose is connected to a
separate standpipe, it is essential that an
airtight connection be made.
Refer to Fig.B

Drain hose Extension

Extend drain hose as shown below.

Fig. A

Fig. B : Drainage connection - stand pipe.

CAUTION

When you connect or extend drain hose,
make sure that drain hose is not kinked.
(Bends should have a 40 mm radius.)

NSTALLATION INSTRUCTIONS

I

8

Step 6 :

WATER SUPPLY CONNECTION

1

2

Connect the water supply hose to the
water tap as shown.(Some models
consist of an inlet valve and hose.)
This dishwasher may be fed with either
hot or cold water. If the water can not be
maintained below 65ºC, the dishwasher
must be connected to cold water.

When connecting, the sealant tape or
sealing compound to avoid water leaks.

Make sure that the line is not kinked or
sharply bent.

The new hose-sets supplied with the
appliance are to be used and that old
hose-sets should not be reused.

Water tap

Water supply
hose

Step 7 :

FINAL CHECK AND ASSEMBLING

1

2

Securely hand tighten supply hose to the
water supply.
Plug the power supply cord into an earthed
electrical point and switch on.

After installing and prior to using the
dishwasher with crockery, we recommend
that you use the dishwasher on ‘Quick’
mode to rinse through. At this stage it is
useful to ensure that there are no operating
problems or water leaks.

When the dishwasher is used for the first,
there may be a loud noise, if this happens,
turn off the power and restart the
dishwasher.

Step 8 :

HOW TO LEVEL THE DISHWASHER

After installing the dishwasher, you may
notice a slight sticking of the door to the
dishwasher, when you open or close the door.
If this does happen you need to adjust the level
of the dishwasher.

• If the door slants to the right, see fig, C and
follow these instructions:

1) Unscrew(counter-clockwise) the left leg of

the back side and correct the level.

2) Check the opening of door and repeat if

necessary until the door opens and closes
properly.

• When the product is correctly leveled, There
should be no slant , stickiness or friction
sound.

• If the door slants to the left, see fig. D and
follow these instructions:

1) Check the opening of door if there still

remains sticky or friction sound.

2) Check the opening of door and repeat if
necessary until the door opens and closes
properly.

• When the product is correctly leveled, There
should be no slant , stickiness or friction
sound.

Fig. C

Fig. D

Case 1. In case the door is slanted to the right

Case 2. In case the door is slanted to the left

9

ARTS NAME

P

1. Control Panel

2. Door Handle

3. Front Cover

4. Lower Cover

5. Display Window

6. Power Button

7. Drain Hose

8. Inlet Hose

9. Power Cord

10. Adjustable Leg

11. Upper Rack

12. Cutlery Basket

13. Detergent And Rinse Aid Dispenser

14. Vapor Vent Cover

15. Upper Spray Arm

16. Lower Spray Arm

17. Filter ASM

18. Lower Rack

19. Salt Container Cap

20. Cutlery Rack

The appearance and specifications may vary without notice.

Funnel