LG DW-EN300T User manual

DISHWASHER

Please read this manual carefully before operating your

dishwasher. Retain it for future reference.

OWNER'S MANUAL

MODEL : D1422W(L,M,T,B,C,D,A)F(B,U)

D1423W(L,M,T,B,C,D,A)F(B,U)

WZ-6807WFL

WZ-6807MFL

ONTENTS

SAFETY AND CAUTION 3

INSTALLATION INSTRUCTIONS 5

PARTS NAME 9

FUNCTION OF CONTROL BUTTON 10

BEFORE USING FOR THE FIRST TIME 13

HOW TO USE AND OPERATE 15

OPERATING SEQUENCE 21

PROGRAM 22

USER MAINTENANCE INSTRUCTIONS 23

TROUBLE SHOOTING GUIDE 24

SPECIFICATION

AFETY AND CAUTION

• Please read this manual carefully before using

the dishwasher for the first time.

• This manual contains very important notes

regarding the installation, use and maintenance

of your dishwasher.

• The manufacturer can not be responsible for

problems caused by ignoring these safety and

caution instructions.

• This dishwasher is designed for normal

household use.

• Do not use the dishwasher for industrial and

commercial use, or other purpose.

• The appliance is not intended for use by young

children or infirm persons without supervision.

• Check packaging and dishwasher immediately

for signs of transport damage. If the appliance

is damaged, do not put it into use but contact

your supplier without delay.

During installation

• Electrical connection must be in accordance

with the rating label.

• Electrical safety is only guaranteed when the

earth system of your house is in accordance

with the related local regulations.(Do not use

an extension cable or cord.)

• If the hot water exceeds 65ºC, adjust the water

heater setting. If the hot water temperature can

not be maintained below 65ºC, the dishwasher

must be connected to cold water.

• If power supply cord is damaged, it must only

be replaced by the manufacturer or its service

agent or a similar qualified person in order to

avoid a hazard.

• This appliance must be positioned so that the

plug is accessible.

• The appliance is to be connected to the water

mains using new hose-sets and that old hose-

sets should not be reused.

During use

• Only suitable household utensils should be

placed in the dishwasher.

(Please avoid utensils; that are non-

heatresistant, metal decorated, etc.)

• Do not use any kinds of solvent in your

dishwasher. They may cause an explosion or

fire.

• Do not spray water on the appliance.

It may cause the failure of electric parts or

electric shock.

• Do not push down or sit on the inner door

when the door opened. It may cause the

deformation or failure of your dishwasher.

• Do not use the detergent for hand washing.

The detergent for dishwasher should be used

for normal operation.

• This appliance is fitted with a safety function

that automatically stops the operation of the

dishwasher when it is exposed to heavy

disturbance on its mains.

• Dishwasher detergents are strongly alkaline.

They can be extremely dangerous if

swallowed. Avoid contact with skin and eyes

and keep children away from the dishwasher

when the door is open.

Check that the detergent receptacle is empty

after completion of the wash cycle.

Child Safety

• Controls may be locked using “Child Lock”

mode to prevent from all the setting from

being changed by a child.

• Keep children away from detergents and rinse-

aids.

• Do not allow children to operate the

dishwasher.

• Young children should be supervised to ensure

that they do not play with the appliance.

IMPORTANT SAFETY INSTRUCTIONS

WARNING

- When using your dishwasher, follow basic precautions,

including the following:

AFETY AND CAUTION

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of a malfunction or breakdown, grounding will

reduce the risk of electric shock by providing a path of least resistance for electric current. This

appliance is equipped with a cord having an equipment-grounding conductor and a grounding

plug. The plug must be plugged into an appropriate outlet that is installed and grounded in

accordance with all local codes and ordinances.

WARNING - Improper connection of the equipment-grounding conductor can result in a risk of

electric shock. Check with a qualified electrician or service representative if you are in doubt

whether the appliance is properly grounded. Do not modify the plug provided with the appliance;

if it will not fit the outlet have a proper outlet installed by a qualified electrician.

SAVE THESE INSTRUCTIONS

concerning the Power Cord

Most appliances recommend they be placed upon a dedicated circuit; that is, a single outlet circuit

which powers only that appliance and has no additional outlets or branch circuits. Check the

specification page of this owner's manual to be certain.

Do not overload wall outlets. Overloaded wall outlets, loose or damaged wall outlets, extension cords,

frayed power cords, or damaged or cracked wire insulation are dangerous. Any of these conditions

could result in electric shock or fire. Periodically examine the cord of your appliance, and if its

appearance indicates damage or deterioration, unplug it, discontinue use of the appliance, and have the

cord replaced with an exact replacement part by an authorized servicer.

Protect the power cord from physical or mechanical abuse, such as being twisted, kinked, pinched,

closed in a door, or walked upon. Pay particular attention to plugs, wall outlets, and the point where the

cord exits the appliance.

The instructions shall state the substance of the following :

This appliance is not intended for use by persons (including children) with reduced physical, sensory or

mental capabilities, or lack of experience and knowledge, unless they have been given supervision or

instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

Disposal of your old appliance

1. When this crossed-out wheeled bin symbol is attached to a product

it means the product is covered by the European Directive

2002/96/EC.

2. All electrical and electronic products should be disposed of

separately from the municipal waste stream via designated

collection facilities appointed by the government or the local

authorities.

3. The correct disposal of your old appliance will help prevent

potential negative consequences for the environment and human

health.

4. For more detailed information about disposal of your old appliance,

please contact your city office, waste disposal service or the shop

where you purchased the product.

CAUTION

NSTALLATION INSTRUCTIONS

Unit:mm

Step 1 :

PREPARE CUPBOARD OPENING

Step 2 :

PREPARATION FOR ELECTICAL WIRING

This appliance must be supplied with

correct rating voltage and hertz as shown

on instruction manual, and connected to

an individual, properly earthed branch

circuit, protected by a minimum 15 amp

circuit breaker or time delay fuse.

Wiring must be 2 wire with Earth.

The power plug must be in a accessible

location adjacent to and not behind the

dishwasher and within 1.2 meters of the

dishwasher side.(See page 7 Fig.A)

The power plug must be correctly

earthed, if in doubt, have it checked by a

qualified Electrician. No other appliance

should be connected to the same plug

outlet by a double adapter or similar

plug.

CAUTION

For personal safety, remove house

fuse or open circuit breaker before

installation. Do not use an extension

cord or adapter plug with this

appliance. Electrical and earthing

connections must comply with the

national electrical code/provincial and

municipal code and/or other local

codes.

Any bare wood surrounding the

dishwasher should be sealed with a

waterproof paint or sealant to prevent

swelling.

Dangerous voltage

To indicate hazards arising

from dangerous voltages.

Note – In case of application

in a warning sign the rules

according to ISO 3864 shall

be adhered to.

WARNING

A qualified electrician/plumber or competent person should carry out any electrical/plumbing

work required to install this appliance.

This dishwasher is designed to fit the size

shown as below.

Select a location as close to sink as

possible for ease of connection to the

water and drain pipes.

To ensure good drainage, the dishwasher

should not be installed more than 3 meters

away from the sink.

If dishwasher is installed in a corner, a

minimum of 5cm of space is required

between the washer and an adjacent

cabinet or wall.

NSTALLATION INSTRUCTIONS

Step 3 :

PREPARING THE DISHWASHER

FOR INSTALLATION

Lay the dishwasher on its back.

Adjust the legs to the required height

as shown in below figure.

Step 4 :

INST ALLING THE

DISHWASHER IN CUPBOARD

Before sliding the dishwasher into the

cupboard opening, all necessary height

and balancing adjustments should be

made using a spanner.

Slide the dishwasher into the cabinet

opening carefully. Make sure that the

drain hose inside the cabinet is not

kinked or stretched.

CAUTION

If the height of the cupboard is below

850mm, you should remove the top table

by unscrewing the 2 screws. (Two of rear)

Adjust

leg

NSTALLATION INSTRUCTIONS

Step 5 :

DRAIN LINE CONNECTION

If the end of drain hose does not fit to

the drain line, use a rubber

connector(not supplied) that is

resistant to heat and detergent.

This should be available from a

plumbing shop or DIY merchants.

There are two typical connections as

shown in Figure A, B.

The “S” trap spigot must be drilled out

cleanly and free of obstruction to its

maximum internal diameter, if used for

drainage.

To prevent siphoning, one of the following

methods must be used:

When the drain hose is connected to a

sink “s” trap or waste disposal unit, the

hose must be looped up to the underside

of the bench top and secured.

When the drain hose is connected to a

separate standpipe, it is essential that an

airtight connection be made.

Refer to Fig.B

Drain hose Extension

Extend drain hose as shown below.

Fig. A

Fig. B : Drainage connection - stand pipe.

CAUTION

When you connect or extend drain hose,

make sure that drain hose is not kinked.

(Bends should have a 40 mm radius.)

NSTALLATION INSTRUCTIONS

Step 6 :

WATER SUPPLY CONNECTION

Connect the water supply hose to the

water tap as shown.(Some models

consist of an inlet valve and hose.)

This dishwasher may be fed with either

hot or cold water. If the water can not be

maintained below 65ºC, the dishwasher

must be connected to cold water.

When connecting, the sealant tape or

sealing compound to avoid water leaks.

Make sure that the line is not kinked or

sharply bent.

The new hose-sets supplied with the

appliance are to be used and that old

hose-sets should not be reused.

Water tap

Water supply

hose

Step 7 :

FINAL CHECK AND ASSEMBLING

Securely hand tighten supply hose to the

water supply.

Plug the power supply cord into an earthed

electrical point and switch on.

After installing and prior to using the

dishwasher with crockery, we recommend

that you use the dishwasher on ‘Quick’

mode to rinse through. At this stage it is

useful to ensure that there are no operating

problems or water leaks.

When the dishwasher is used for the first,

there may be a loud noise, if this happens,

turn off the power and restart the

dishwasher.

Step 8 :

HOW TO LEVEL THE DISHWASHER

After installing the dishwasher, you may

notice a slight sticking of the door to the

dishwasher, when you open or close the door.

If this does happen you need to adjust the level

of the dishwasher.

• If the door slants to the right, see fig, C and

follow these instructions:

1) Unscrew(counter-clockwise) the left leg of

the back side and correct the level.

2) Check the opening of door and repeat if

necessary until the door opens and closes

properly.

• When the product is correctly leveled, There

should be no slant , stickiness or friction

sound.

• If the door slants to the left, see fig. D and

follow these instructions:

1) Check the opening of door if there still

remains sticky or friction sound.

2) Check the opening of door and repeat if

necessary until the door opens and closes

properly.

• When the product is correctly leveled, There

should be no slant , stickiness or friction

sound.

Fig. C

Fig. D

Case 1. In case the door is slanted to the right

Case 2. In case the door is slanted to the left

ARTS NAME

1. Control Panel

2. Door Handle

3. Front Cover

4. Lower Cover

5. Display Window

6. Power Button

7. Drain Hose

8. Inlet Hose

9. Power Cord

10. Adjustable Leg

11. Upper Rack

12. Cutlery Basket

13. Detergent And Rinse Aid Dispenser

14. Vapor Vent Cover

15. Upper Spray Arm

16. Lower Spray Arm

17. Filter ASM

18. Lower Rack

19. Salt Container Cap

The appearance and specifications may vary without notice.

Funnel

+ 19 hidden pages