LG CF-20J3WG Owner’s Manual

Installation

Power

This set operates on an AC mains supply, the voltage is as indicated on the label on the back cover. Never apply DC power to the set. In the event of thunder- storms or powercuts, please pull out the aerial and mains plugs.

Warning

To prevent fire or shock hazard, do not expose the set to rain or moisture.

Service

Never remove the back cover of the set as this can expose you to very high volt- age and other hazards. If the set does not operate properly, unplug it and call your dealer.

Aerial

Connect the aerial cable to the socket marked +75Ω on the back cover. For the best reception an outdoor aerial should be used.

Location

Position your set so that no bright light or sunlight falls directly onto the screen. Care should be taken not to expose the set to any unnecessary vibration, mois- ture, dust or heat. Also ensure that the set is placed in a position to allow a free flow of air. Do not cover the ventilation openings on the back cover.

Battery installation

The remote control handset is powered by two AAA type batteries. To load the batteries, turn the remote control handset over and open the battery compart-

ment. Install two batteries as indicated by the polarity symbols ( + and	)
marked inside the compartment.

Note : To avoid damage from possible battery leakage, remove the batteries if you do not plan to use the remote control handset for an extended period of time.

Connection of external equipment

You can connect additional equipment, such as VCRs, camcorders etc. to your set.

Aerial socket

1.Connect the RF out socket of the VCR to the aerial socket on the back of the set.

2.Connect the aerial cable to the RF aerial in socket of the VCR.

3.Store the VCR channel on a desired programme number using the 'Manual programme tuning' section.

4.Select the programme number where the VCR channel is stored.

5.Press the PLAY button on the VCR.

Audio/Video sockets (option)

1.Connect the audio/video out sockets of the VCR to audio/video in sockets of the set and in sockets of the VCR to out sockets of the set.

2.Press the TV/AV button to select AV.

3.Press the PLAY button on the VCR.

The VCR playback picture appears on the screen.

You can also record programmes received by the TV on video tape via audio/video out sockets.

Euro scart socket (option)

1.Connect the Euro scart socket of the VCR to the Euro scart socket of the set and in sockets of the VCR to out sockets of the set

2.Press the PLAY button on the VCR.

If your VCR outputs a switching voltage the set will switch to AV mode auto- matically.

Otherwise press the TV/AV button on the remote control handset to select AV. The VCR playback picture appears on the screen.

You can also record programmes received by the TV on video tape.