LG AJ-LAN1 User Manual

AJ-LAN1
AJ-LAN1
LAMP OWNER’S MANUAL
P/N : 3828VA0584D
* Contact your dealer for replacing a new lamp.
The projector lamp usually lasts for about 4000 hours. You can see the used lamp time in the Selecting Function section. You must replace the lamp when:
The projected image gets darker or starts to be deteriorated.
The message “Replace the lamp” appears on the screen
when turning the projector lamp on.
Lamp indicators
<Front panel of the Projector>
Be careful when replacing lamp
Press the POWER button on the control panel or remote control to cut off the power.
- If the operation indicator LED is orange and blinking, do not disconnect the mains supply until the operation indicator LED is lit up constantly (orange).
- Allow the lamp to cool for 1 hour before replacing it.
- Replace only with the same type lamp from a LG Electronics Service Center using and other lamp may cause damage to the Projector and lamp.
- Pull out the lamp only when replacing the lamp.
- Keep the lamp unit out of reach of children or and heat sources such as radiators, stoves.
- To reduce the risk of fire, lamp shall not be exposed to liquids or foreign material.
- Do not place the lamp near any heat source.
- Make sure the new lamp is securely tightened with screws. If not, the image may be dark or there could be a risk of fire.
- Never touch the lamp unit glass or otherwise image quality may be worse or lamp life may be reduced.
Loading...
+ 2 hidden pages