DISASSEMBLY
- 8 -
2. BACK COVER REMOVAL
1) Remove four screws (a).
2) Slide the Back Cover away from the Front
Cabinet of the monitor.
1. TILT/SWIVEL REMOVAL
1) Set the monitor face downward.
2) Pressing the latch (a), carefully remove
the Tilt/Swivel by pulling it upward.
Anode Cap
MENU
SELECT
(b)
(b)
P701
P501
to Tilt coil
(P501)
Degaussing pin
(P902)
P902
3. TOTAL CHASSIS ASSEMBLY REMOVAL
1)
Remove connector (a) from the DY Assembly screw.
2) Carefully separate the CDT Board Assembly
from the CDT neck.
3) Discharge the remaining static electricity
by shorting between the Anode Cap
and the CDT ground.
4) Disconnect the Anode Cap
from the CDT.
5) Disconnect P902
(Degaussing pin),
P701 (DY pin) and P501 from
the Main PCB.
6) Remove two screws (b).
7) Remove the Total Chassis
Assembly from the Main Frame.
(a)
(a)
(a)
(a)
(a)
(a)
(b)
(a)
P302
P301
4. VIODEO PCB ASSEMBLY REMOVAL
1) Disconnect P301, P302 from the Video PCB.
2) Remove three connects (a).
3) Remove screws (b).
4) Remove the Video PCB Assembly.
5. BOTTOM BRACKET REMOVAL
1) Remove two Holder (a).
2) Remove two Bracket (b).
3) Remove four screw (c).
4) Remove the Bottom Bracket.
(c)
(c)
(b)
(a)
(c)
(c)
(a)
(b)