LG 520SI, CB550BN DISASSEMBLY

DISASSEMBLY

- 8 -

2. BACK COVER REMOVAL

1) Remove four screws (a) from the Back Cover.

2) Slide the Back Cover away from the Front Cabinet of the monitor.

3. TOTAL CHASSIS ASSEMBLY REMOVAL

1) Disconnect P902 (Degaussing pin) and P501 (DY pin).

2) Remove two screws (a) from the Total Chassis Assembly.

3) Remove the Total Chassis Assembly.

4. VIDEO BOARD ASSEMBLY REMOVAL

1) Remove three pins (a).

2) Remove CDT earth connector (b).

3) Carefully separate the Video Board Assembly from the CDT neck.

4) Discharge the remaining static electricity by shorting between the Anode Cap and the CDT ground.

5) Disconnect the Anode Cap from the CDT.

Anode Cap

(a)

(b)

(a)

CDT Assembly

(a)

Main Bracket

1. TILT/SWIVEL REMOVAL

1) Set the monitor faces downward.

2) Pressing the latch (a), carefully remove the Tilt/Swivel by pulling it upward.

- 9 -

5. BOTTOM BRACKET REMOVAL

1) Remove three screws (a).

2) Remove the Bottom Bracket.

6. MAIN BOARD ASSEMBLY REMOVAL

1) Remove three screws (a).

2) Remove five screws (b).

3) Release four latches (c) from the Main Board Assembly.

(a)

Bottom Bracket

(c)

(b)

(a)

Main PCB Assembly