Test Report No.: GETEC-E3-05-030
FCC Class B Certification
APPENDIX H
: USER’S MANUAL
EUT Type: 37” LCD TV/Monitor
FCC ID : BEJ37LDA
LCD TV
OWNER’S MANUAL
MODELS: 26LX1D |
|
32LX1D |
|
|
26LX2D |
|
32LX2D |
|
|
|
|
|
||
32LP1D |
|
37LP1D |
|
42LP1D |
|
|
Internet Home Page : http://www.lge.com
http://www.lg.ca
TM
Please read this manual carefully before operating your set. Retain it for future reference.
Record model number and serial number of the set. See the label attached on the back cover and quote this information to your dealer
when you require service.
P/NO : 3828TUL309D (0503-REV00)
Printed in Korea
Warning
Warning
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
NOTE TO CABLE/TV INSTALLER:
This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the National Electric Code (U.S.A.). The code provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of the cable entry as practical.
REGULATORY INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
CAUTION:
Do not attempt to modify this product in any way without written authorization from LG Electronics Corporation. Unauthorized modification could void the user’s authority to operate this product.
U.S.A. only -----------------------------------------------
COMPLIANCE:
The responsible party for this product’s compliance is: LG Electronics U.S.A., Inc.
1000 Sylvan Avenue, Englewood Cliffs, NJ 07632 Phone: 1-201-816-2000
http://www.lgusa.com
---------------------------------------------------------------
Introduction
Controls (Model Name: 32/37/42LP1D)
-This is a simplified representation of front panel.
-Here shown may be somewhat different from your TV.
Logo Display Lamp
1394
IEEE
Channel Display
Power Standby Indicator
Illuminates red when the TV is in standby mode. When the TV is switched on, blinks green and then illuminates green.
DTV, CADTV mode |
HDMI mode |
TV, CATV, DTV, CADTV mode |
IEEE1394 |
1394 |
|
IEEE |
|
Video1-2 mode |
|
Component1-2 mode |
Stereo mode |
|
|
PC mode |
mode |
Remote Control Sensor
CH |
VOL |
MENU |
TV/VIDEO/ |
TV |
ON/OFF |
R |
AUDIO |
L/MONO |
VIDEO |
S-VIDEO |
GUIDE |
|
|
IN2 |
|
||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
ON/OFF Button |
|
|
|
|
|
|
|||
|
Memory |
|
Card Slot |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|||||||||
|
|
|
|
|
|
|
|
|
|
TV GUIDE Button |
|
|
|
|
|
|
|||||||||||||||
|
(For |
|
|
|
|
mode) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
TV/VIDEO / |
Button |
|
|
|
|
|
||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
S-VIDEO Input |
||||||||
|
|
|
|
|
|
|
CHANNEL (E, D) Buttons |
|
MENU Button |
|
Audio/Video Input 2 |
||||||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|||
|
|
|
|
|
|
|
|
|
|
|
|
|
VOLUME (F,G) Buttons |
|
|
|
|
|
|
|
|
|
Introduction
Connection Options (Model Name: 32/37/42LP1D)
COMPONENT2
VIDEO COMPONENT2
(VIDEO / AUDIO Input)
L
AUDIO
AC IN |
DIGITAL AUDIO OUTPUT |
MONITOR OUT |
||||||||||
/ DVI INPUT |
||||||||||||
|
G-LINKTM Port |
/ COMPONENT1 INPUT |
|
|
HDMI / IEEE1394 Port |
|||||||
|
|
|
||||||||||
|
AUDIO/VIDEO INPUT1 |
|
|
CableCARDTM Slot |
||||||||
|
|
|
||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
CableCARD
HDMI
AC IN
IEEE 1394
|
DIGITAL AUDIO |
|
|
|
R AUDIO L (MONO) VIDEO |
|
|
|
|
MONITOR |
|
G-LINK |
(OPTICAL) |
|
|
S-VIDEO |
|
|
|
OUT |
|||
|
|
OUTPUT |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
CABLE |
|
|
|
|
|
VIDEO1 |
REMOTE |
RS-232C INPUT |
DVI |
|
|
|
CONTROL |
(CONTROL/SERVICE) |
|
|
|
|
INPUT |
|
COMPONENT1 |
|||
|
|
|
|||
PC AUDIO |
RGB INPUT |
COMPONENT1 |
R |
L |
ANTENNA |
|
|
||||
INPUT |
(PC/DTV INPUT) |
INPUT |
|
|
|
AUDIO INPUT |
VIDEO INPUT |
RS-232C INPUT (CONTROL/SERVICE) / |
ANTENNA Input |
|
RGB INPUT (PC/DTV INPUT) |
||
|
CABLE Input
PC AUDIO INPUT
REMOTE CONTROL Port |
COMPONENT1 (VIDEO / AUDIO INPUT) |
|
*The HDMI port can receive video via High-Definition Multimedia Interface (HDMI) or the Digital Visual Interface (DVI). Note: An adapter or special cable is required to plug DVI into an HDMI port (available at home theater or computer stores).
Installation
External Equipment Connections
Antenna or Cable Connection
Analog and Digital TV signals provided on antenna
-Antenna or Cable Service without a Cable Box Connection.
-For optimum picture quality, adjust antenna direction if needed.
Multi-family Dwellings/Apartments (Connect to wall antenna socket)
Wall Antenna Socket
ANTENNA
RF Coaxial Wire (75 ohm)
VHF Antenna
Turn clockwise to tighten.
UHF Antenna
Outdoor Antenna
Single-family Dwellings /Houses (Connect to wall jack for outdoor antenna)
Analog and Digital TV signals provided on cable
Bronze Wire
Be careful not to bend the bronze wire when connecting the antenna.
Cable TV Wall Jack
RF Coaxial Wire (75 ohm)
Turn clockwise to tighten.
Analog and Digital TV signals provided on cable and antenna
Bronze Wire
Cable TV Wall Jack
RF Coaxial Wire (75 ohm)
Turn clockwise to tighten.
Antenna
RF Coaxial Wire (75 ohm)
CABLE
CABLE
ANTENNA
Bronze Wire
signal
amplifier
ANTENNA
•In a poor signal area to improve picture quality, purchase and install a signal amplifier.
•If the antenna needs to be split for two TV’s, install a “2-Way Signal Splitter” in the connections.
•If the antenna is not installed properly, contact your dealer for assistance.
21