Lezyne Mini GPS, power gps, super gps User Manual

1

Information

For more information on Lezyne products, visit: http://lezyne.com

WEEE Notice & Product Disposal:

The symbol of the crossed waste container means that, in accordance with2002/96/EC
Waste Electrical and Electronic Equipment Directive (WEEE),once the product reaches
the end of its lifecycle, in the European Union it is subject to special waste disposal. In
addition to the present device, this rule is also applied to all items carrying such a symbol.
Do not dispose of these products as undifferentiated urban waste but put away for material
differentiated recycling.
CE RF Compliance—Meets the EU Requirements:

The equipment complies with the RF Exposure Requirement 1999/519/EC, Council

Recommendation of 12 July 1999 on the limitation of exposure of the general public to
electromagnetic fields (0–300 GHz). Changes or modifications to this product not authorized
by the manufacturer could void the EMC compliance and negate your authority to
operate the product. This product has demonstrated EMC compliance under conditions
that included the use of compliant peripheral devices and shielded cables between system
components. It is important that you use compliant peripheral devices and shielded
cables between system components to reduce the possibility of causing interference to
radios, televisions, and other electronic devices. We, hereby, declare that this cellular,
Wi-Fi radio is in compliance with the essential requirements and other relevant provisions

of Directive 1999/5/EC. Products with CE marking comply with the EMC Directive

(2004/108/EC) and the Low Voltage Directive (2006/95/EC) issued by the Commission of
the European Community. Compliance with these directives implies conformity to the
following European Norms (in parentheses are the equivalent international standards).
FCC & IC User Warning Notice:
Any changes or modifications not expressly approved by the party responsible for compliance
could void your authority to operate the equipment.

Note:

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.

Labeling Requirement Notice:

This device complies with Part 15 of the FCC Rules and Industry Canada license-exempt

RSS standard(s). Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
FCC:

1. This Transmitter must not be co‐located or operating in conjunction with any
other antenna or transmitter.

2. This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20 centimeters between the radiator
IC:
This device complies with the Canada portable RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as described in this manual.
The further RF exposure reduction can be achieved if the product can be kept as far as
possible from the user body or set the device to lower output power if such function is
available.

Lezyne is a trademark of Lezyne USA, Inc. and registered both in the United States and
internationally Any unauthorized use is expressly prohibited

2

Warranty

Lezyne GPS devices carry a one (1) year warranty from the original purchase date to the original owner (proof of purchase is required.) This warranty covers materials and manufacturing defects

on the GPS housing, electronics, and the mounting bracket supplied. Issues not covered by the warranty include normal wear and tear, consumable parts, such as batteries, unless product
damage has occurred due to defect in material or manufacturing, improper installation, attempting to access electronics, modifying electronics, damage or failure due to accident, misuse, abuse,
or neglect.

Because of possible user resealing error of the USB port, this product is not warrantied against water in the housing from improper sealing or any resulting damage. Please review and follow the
instructions carefully when sealing the housing.

This product is intended to be used only as a cycling aid and must not be used for any purpose requiring precise measurement of direction, distance, location or topography. Lezyne makes no
warranty as to the accuracy or completeness of map data in this product.

In no event shall Lezyne be liable for incidental or consequential damages for any traffic fines or citations, relating to or resulting from the use of this product or any of its parts. Lezyne assumes

no liability for any accident, injury, death, loss, or other claim related to or resulting from the use of this product.

Important

Do not be come distracted by the device—always operate vehicles in a safe manner.
Lezyne USA, Inc. does not accept any liability for injuries or other damages resulting from
the use of this product in any circumstances.

DO NOT SUBMERGE UNDER WATER

Lezyne GPS devices are water resistant under normal conditions, but are not waterproof. If moisture gets inside device body, air-out until completely dry.

DO NOT ATTEMPT TO REMOVE ELECTRONICS

Doing so will void warranty.
Do not operate or store outside of temperature range (-20–60° C). Battery lifemay be affected at temperature extremes.
Location and surroundings may affect GPS signal. For best results, use the device outdoors

with an unobstructed view of the sky. It may take up to 60 seconds to acquire GPS

signals.

This GPS device is not a calibrated measuring tool. It should not be used for surveying
purposes. GPS based elevation measurements may vary. Calorie readings are an estimation

for reference only.

CA PROPOSITION 65 WARNING:

This product may contain chemicals known to the State
of California to cause cancer and birth defects or other reproductive harm (California law
requires this warning to be given to customers in the State of California). For more info:
www.lezyne.com/prop65

3

Table of Contents

• Getting Started

– Buttons
– Screen Icons
– Charging GPS
– Installing GPS
– Turning on GPS
– GPS Satellite Signal
– Starting a Ride
– Ending a Ride
– Uploading a Ride to your Computer

• Screen Set up

– Layout
– Fields
– Unit Format
– Brightness (Backlight)

• Auto/Preset Notification Set up

– Scroll
– Pause
– Lap
– Light (Backlight)

• Alert Set up

– Ride Distance
– Ride Time
– Calories

• Records

– Erase All
– Erase Oldest
– Memory
– Reset Trip 1
– Reset Trip 2
– Reset Odo (Odometer)

• Time Set up

– Time Format
– Time Zone*
– Daylight Saving*

• Personal Set up

– Sport Type
– Language*
– Age*
– Weight*
– Height*
– Gender*

• Info

– Device
– Firmware
– GPS
– Sats

• Specifications

• Data Metrics Explained

• Troubleshooting

– Updating Software
– Support
– Resetting the Device

4

Getting Started

Buttons

ENTER Hold for 2 seconds to turn ON/OFF the device

MENU Hold to access the MENU screen

LAP Press to start a ride

Ride Screen Button Functions

Press to ENTER a selection in the menu screen
During a ride, Press to turn Backlight ON/OFF

Press to move UP in the menu screen

During a ride, Press to Scroll bottom data line

Hold to end a ride
Press to move DOWN in the menu screen
During a ride, Press to mark a LAP

Press

Hold

Scroll

Menu

Backlight

On/Off

Start/Lap

Pause

5

Getting Started

Menu and Pause Screen Button Functions

Press
Hold

Select

Screen Icons

GPS Status Battery Status

Up

Down

6

Getting Started

Charging

Before using your Lezyne GPS device for the first time, fully charge battery

and it is also recommended to visit lezyne.com/gpsroot/gps_downloads.php and update your GPS

device to the latest software.

1. Remove exterior moisture

2. Open USB cover

3. Connect micro USB cable and device to powered USB port.
For best results, use the supplied Lezyne cable

If device does not display charging symbol when plugged in, selected USB
port may not be powered – try another USB port.

Open USB cover for charging

Mounting

To attach the X-Lock mount:

1. Align the shim with the bottom of the mount

2. Attach the X-Lock mount securely using the two bands
the best fit your mounting location

To connect the device to the X-Lock mount:

1. Align the tabs on the back of the device with the mount

2. Press down and turn the device until it locks into place

Mounting tabs

7

Getting Started

Turning on the GPS

Turn on your Mini GPS by holding the left button.

GPS Satellite Signal

Before a ride can start there must be a GPS signal present. This can take 30 to 90
seconds. For best results:

1. Go outside to an open and clear area

2. Place the GPS device so its not obstructed from the sky

3. Wait for a GPS status dots to fill in
*a pop up

Press and hold for 2

seconds to turn on

notice will appear if you try to start a ride before a GPS signal is present.

GPS Signal

8

Getting Started

Starting a Ride

1. At least 1 GPS status dots will fill solid
when ready.

2. Start recording by pressing the bottom
right button.

3. Ride data is recorded when the timer is
running

4. Press to see other ride metrics

Ending a Ride

Enter the pause menu by holding the bottom right button . To continue
recording, select the option RESUME by pressing the left button ENTER or scroll
through other options by pressing one of the top or bottom right buttons

Select the option END to go to the file menu. Now choose to SAVE or DISCARD
your file

Press to start
recording a ride

Press and hold to
end ride

9