Page 1
Material Safety Data Sheet
PN 12A7360
_____________________________________________________________________________________________
T630, T632, T634, X630, X632 Print Cartridge
_____________________________________________________________________________________________
Lexmark has determined that Material Safety Data Sheets are not required for print cartridges. For customer
convenience, Lexmark provides product information in this familiar format.
Section 1 - Product and Company Identification
Product Name:
T630, T632, T634, X630, X632 Print
Manufacturer:
Lexmark International, Inc.
Cartridge
Product ID:
Chemical
12A7360
740 West New Circle Road
Toner Cartridge Lexington, KY 40550
Family:
Application: Laser Printer
Prepared By: Product Environmental Programs
Information: 1-859-232-3000
Emergency: 1-859-232-3333
Section 2 - Composition / Information on Ingredients
Ingredients Percent (wt.) CAS No. OSHA PELS ACGIH TLV
Polyester Resin
65-85 Trade Secret None None
NJTSRN 80100286-6001P
Carbon Black 1-10 1333-86-4 3.5 mg/m³ TWA 3.5 mg/m³ TWA
Iron Oxide 6-12 1317-61-9 None None
Polymer Wax
1-5 Trade Secret None None
NJTSRN 80100451-5016
Amorphous Silica (modified)
1-3 Trade Secret None None
NJTSRN 80100451-5015
Section 3 - Hazards Identification
The following information is based on testing of the product as a whole and/or characteristics of components.
Hazard Information: Primary Routes of Exposure: Dust inhalation, skin contact.
Inhalation: Low acute inhalation toxicity. As with exposure to high concentrations of any dust,
minimal irritation of the respiratory tract may occur. Exposure not probable with
intended use.
Skin Contact: Not an irritant. Low dermal toxicity. Not a dermal sensitizer.
Eye Contact: Toner may act as a mechanical irritant.
Ingestion: Low acute oral toxicity. Exposure not probable with intended use.
Section 4 - First Aid Measures
Inhalation: If symptoms, such as shortness of breath or persistent coughing are experienced,
Skin Contact: Wash with soap and water. Should irritation occur, seek medical attention.
remove source of contamination and move individual to fresh air. If symptoms
persist, seek medical attention.
12A7360
Revision Date: 11/03/2004
Page 1 of 4
Page 2
Eye Contact: Do not rub eyes. Flush immediately with plenty of water. Remove contact lenses
and continue flushing for at least 15 minutes. If irritation develops and persists,
seek medical attention.
Ingestion: Do not induce vomiting. Slowly dilute with 1-2 glasses of water or milk and seek
medical attention. Never give anything by mouth to an unconscious person.
Aggravated Conditions: Exposure to high airborne dust concentrations, including toner, may aggravate
existing respiratory conditions.
Notes to Physician: No specific antidote.
Section 5 - Fire Fighting Measures
Flash Point/Range (°C): Solid, not applicable
Autoignition Temperature (°C): Not applicable
Flammable Limits in Air UEL: Not determined
Flammable Limits in Air LE L: Not determined
Extinguishing Media: Carbon dioxide, water spray or fog, dry chemical or foam
Hazardous Combustion
Carbon monoxide, carbon dioxide, unidentified organics
Products:
Special Exposure Hazards: Like many finely divided materials, toner dust, in high concentrations can form an
explosive mixture in air which, if ignited, could result in a dust explosion.
Special Protective Equipment: Fire fighters should wear full protective clothing, including self-contained breathing
apparatus, if a large number of cartridges are involved.
NFPA Rating: Health: 1 Flammability: 1 Reactivity: 0
HMIS Classification: Health: 1 Flammability: 1 Reactivity: 0
Section 6 - Accidental Release Measures
Personal Precautionary
None required for intended use in printer.
Measures:
Environmental Precautionary: Disposal is subject to national, state, regional, or provincial regulations.
Procedure for Cleaning/
Absorption:
If a dust cloud is possible due to a spill, remove all sources of ignition such as
open sparks, flames, or static discharge to prevent the ignition of the dust.
Minimize dust generation during clean up. Sweep up spill with non-metallic broom
and dustpan. Contain for disposal. Oil permeated sweeping compound may be
useful in cleaning up spills.
Section 7 - Handling and Storage
Handling: To avoid damage to cartridge and accidental contact with toner
KEEP OUT OF REACH OF CHILDREN.
Storage: Store in a cool, dry place. Store away from oxidizing material.
Section 8 - Exposure Controls / Personal Protection
Engineering Controls: None required. Use in a well ventilated area.
Respiratory Protection: None required for intended use in printer.
Gloves: None required for intended use in printer.
Page 2 of 4
Revision Date: 11/03/2004
12A7360
Page 3
Skin Protection: None required for intended use in printer.
Eyes: None required for intended use in printer.
Section 9 - Physical and Chemical Properties
Physical State:
Color:
Solid powder
Black
Odor: Faint plastic-like odor
Specific Gravity: Not determined
Solubility in Water: Insoluble
Freezing Point/Range (°C):
Melting Point:
Vapor Density (Air=1): Not applicable
% Volatiles: Not determined
Evaporation Rate: Not applicable
Not applicable
Not determined
Section 10 - Stability and Reactivity
Chemical Stability: Stable
Hazardous Polymerization: Will not occur
Conditions to Avoid: High temperatures and flame
Materials to Avoid: Strong oxidizers
Hazardous Decomposition
Carbon monoxide, carbon dioxide, unidentified organics
Products:
Additional Guidelines: None
Section 11 - Toxicological Information
Primary Routes of Expos ure: Inhalation of dust, skin contact.
Ingestion: Low acute oral toxicity. Exposure not probable with intended use.
Acute Toxicity Oral Rat LD50
>5000
(mg/kg):
Inhalation: Low acute inhalation toxicity. As with exposure to high concentrations of any dust,
minimal irritation of the respiratory tract may occur. Pure carbon black, a minor
component of this product, has been listed by IARC as a group 2B (possible
carcinogen). This classification is based on rat "lung particulate overload" studies
performed with airborne particulate carbon black. Toner is not listed by IARC, NTP,
or OSHA.
Aggravated Conditions: Exposure to high airborne dust concentrations, including toner, may aggravate
existing respiratory conditions.
Carcinogenicity Comment: Neither this product nor any of its components present above 0.1% are listed by
IARC, NTP, or OSHA as known carcinogens.
Section 12 - Ecological Information
Mobility: Not determined
Persistence: Not determined
Bioaccumulative: Not determined
Other Information: None
Revision Date: 11/03/2004
12A7360
Page 3 of 4
Page 4
Section 13 - Disposal Considerations
Waste Disposal:
This product is not a listed hazardous waste in accordance with Federal Regulation 40 CFR Part 261. If discarded in
its purchased form, this product would not be a hazardous waste either by listing or by characteristic. However, under
RCRA, it is the responsibility of the product user to determine at the time of disposal whether a material has been
contaminated and should be classified as a hazardous waste. Disposal is subject to local, state and federal
regulations.
Section 14 - Transport Information
DOT Status:
Not classified as a hazardous material or substance under US
DOT.
DOT Shipping Name:
Hazard Class: Not applicable
Not applicable
DOT Reportable Quantity: Not applicable
DOT Packing Group: Not applicable
Section 15 - Regulatory Information
TSCA (USA) All ingredients are listed on the Toxic Substances Control Act (TSCA) inventory,
have been registered, or are exempt.
SARA / EPCRA (USA): None of the ingredients in this product has a final reportable quantity (RQ) under
Emergency Planning and Community Right-to Know Act (EPCRA)- Section 302:
Extremely Hazardous Substances (EHS) or notification requirements for EHS
under Section 304.
California Proposition 65: This product contains no known materials at levels which the State of California
has found to cause cancer, birth defects or other reproductive harm - California
Proposition 65.
DSL (Canada): All ingredients are listed on the Canadian Domestic Substances List (DSL), have
been registered on the Non-Domestic Substances List (NDSL), or are exempt.
EINECS (Europe) All ingredients are listed on the European Inventory of Existing Commercial
Substances (EINECS) list, have been registered on the European List of New
Chemical Substances (ELINCS), or are exempt.
ENCS (Japan): All ingredients are listed on the Japanese Existing and New Chemical Substances
(ENCS) list, have been registered, or are exempt.
AICS (Australia): All ingredients are listed in Australian Inventory of Commercial Substances (AICS),
have been registered, or are exempt.
ECL (Korea): All ingredients are listed on the Korean Existing Chemicals List (ECL), have been
registered, or are exempt.
WHMIS Hazard Class (Canada): Not a WHMIS controlled product.
Section 16 - Other Information
The following has been revised
since the last issue of this MSDS: No significant revisions to health and safety information.
Additional Information: None
Data are most current known to Lexmark at the time of preparation and are believed to be accurate. No warranty as to
their accuracy or completeness is expressed or implied.
***END OF MSDS***
Revision Date: 11/03/2004
12A7360
Page 4 of 4
Loading...