Lexmark N8052 User Manual

Wireless Notice

In some environments, the use of wireless devices may be restricted. Such restrictions
may apply aboard airplanes, in hospitals, near explosives, in hazardous locations, etc. If
you are uncertain of the policy that applies to the use of this device, please ask for
authorization to use it prior to turning it on.

FCC Statement

Lexmark International Inc. declares that this device, Lexmark MarkNet N8050, Model
Number 4034-850, complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.

Any questions regarding this declaration should be directed to:
Director of Lab Operations

Lexmark International, Inc.
740 West New Circle Road
Lexington, KY 40550
[phone]

This product has been tested and complies with the specifications for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used according to the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or

television reception, which is found by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment or devices

• Connect the equipment to an outlet other than the receiver's

• Consult a dealer or an experienced radio/TV technician for assistance

Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this equipment
not expressly approved by the manufacturer may cause harmful interference and void
your authority to operate this equipment. Use of supplied data cable is required to comply
with the Class B limits of Part 15 of the FCC Rules.

This product does not contain any user serviceable components and is to be used with
approved antennas only. Any product changes or modifications will invalidate all
applicable regulatory certifications and approvals.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
20cm between the radiator and your body.

Industry Canada (Canada)

This Class B digital apparatus meets all requirements of the Canadian Interference­Causing Equipment Regulations.

This Class B digital apparatus complies with Canadian ICES-003.
This device complies with Industry Canada specification RSS-210. Operation is subject

to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired
operation of the device.

To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (EIRP) is not more than that
required for successful communication.

This device has been designed to operate with an antenna having a maximum gain of 4
dBi. Antenna having a higher gain is strictly prohibited per regulations of Industry
Canada. The required antenna impedance is 50 ohms.

To prevent radio interference to the licensed service, this device is intended to be
operated indoors and away from windows to provide maximum shielding. Equipment (or
its transmit antenna) that is installed outdoors is subject to licensing.