Lexmark N4050E User Manual

Safety Information

Use only the power supply provided with this product or the manufacturer

•

• Connect the power cord to a properly grounded electrical outlet tha

• Refer service or repairs, other than those described in the user d

CAUTION: Do not set up this product or make any electrical or cabling co

t is near the product and easily accessible.

ocumentation, to a professional service person.

’s authorized replacement power supply.

nnections during a lightning storm.

N4050e

1

About the setup process

Read all instructions before proceeding with setup.

Before your printer can be connected to your wireless network, the print server must first
be configured for use on the network by connecting it to your computer and running the
N4050e Setup Utility CD.

Once the print server is configured, you must disconnect the print server from your
computer and attach it to your printer. After your printer is connected, use the drivers or
printer software CD that came with your printer to install your printer on your wireless
network (this will require selecting the network path when running the CD).

Connect the print server to your computer USB port using the USB cable.

2

Federal Communications Commission (FCC) Information

This device complies with Part 15 of the FCC rules. Refer to the

User’s Guide

Before setting up your wireless print server, make sure your printer has been set up
correctly.

For help setting up your printer, refer to your printer’s documentation.

on the N4050e Setup Utility

Note: Refer to the N4050e User’s Guide on the Setup Utility CD for alternate setup

information when installing the print server with third party printers.

• The toner or print cartridges are installed.

• Paper is loaded.

• Your printer is plugged in and powered on.

• Your printer is ready to be installed.

Insert the N4050e Setup Utility CD, install the software, and run the Wireless

3

Setup Wizard.

CD for more information.

P/N 14T0109 E.C. 5D0006
© 2004 Lexmark International, Inc. All rights reserved.

*14T0109*

www.lexmark.com

Following the instructions on screen, disconnect the USB cable from your

4

computer and the print server. Turn the cable around and use it to connect the print

server to your printer as pictured below. Click

Next to continue.

Once the Wireless Setup Wizard has completed, remove the N4050e Setup Utility

5

CD and insert and run the printer drivers or printer software CD that came with your
printer. Follow the
printer.

Network printer install path to complete the installation of your