Lexmark C76X User Manual

Lexmark™ C76x

Maximum stack height indicator

LT.LG

Quick Reference

Loading paper and specialty media

Loading 500-sheet trays

1 Remove the tray and place it on a flat, level

surface.

2 Squeeze the front guide lever and slide the

guide to the front of the tray.

5 Place the paper in the tray as shown, print side

down.Do not load bent or wrinkled paper.

Loading the 2000-sheet tray

1 Pull open the tray. 2 Squeeze the side guide lever, lift the guide, and

place it into the appropriate slot for the size paper you are loading.

3 Squeeze the side guide lever and slide the

guide to the correct position for the size paper you are loading. Icons along the back of the tray indicate paper sizes.

4 Flex the sheets back and forth to loosen them,

and then fan them. Do not fold or crease the paper. Straighten the edges of the stack on a level surface.

6 Squeeze the front guide lever and slide the

guide until it firmly touches the stack of paper.

7 Reinstall the tray. 8 Make sure the tray is pushed completely into

the printer.

3 Squeeze the two front guide levers and slide the

guide to the correct position for the size paper you are loading.

4 Slide the bottom support toward the front of the

tray until it touches the front guide.

5 Flex the sheets back and forth to loosen them,

and then fan them.

Do not fold or crease the paper. Straighten the edges of the stack on a level surface.

6 Place the paper against the back left corner of

the tray, print side down.

Do not load bent or wrinkled print media.

7 Close the tray.

Make sure the tray is pushed completely into the printer. Do not exceed the maximum stack height. Overfilling the tray may cause paper jams.

Loading the multipurpose feeder

1 Open the multipurpose feeder.

2 Squeeze the paper guide lever and slide the

guide all the way toward the front of the printer.

3 Flex the specialty media back and forth to

loosen the stack, and then fan the stack. Do not fold or crease the media. Straighten the edges of the stack on a level surface.

4 Arrange the stack of paper or specialty media

correctly for the size, type, and print method you are using.

5 Place the paper or specialty media, print side

up, along the left side of the multipurpose feeder, and then push it in as far as it will easily go.

Do not force the media.

Note: Do not exceed the maximum stack

height. Overfilling the feeder may cause jams.

6 Squeeze the paper guide lever and slide the

guide until it lightly touches the side of the stack.

7 If you are loading a different type of media than

was previously loaded in the tray, change the Paper Type setting for that tray on the operator panel.

+ 1 hidden pages