Lex Lightning Dualex II User Manual
Lex Lighting Safety Instructions
1. Please keep this User Manual for future reference and be sure to pass this manual on to
anyone using the xture.
2. Always make sure that you are connecting to the proper voltage as stated on the decal or rear
panel of the xture.
3. This product is intended for indoor use only! To prevent risk of re or shock, do not expose
xture to rain or moisture.
4. Make sure there are no ammable materials close to the unit while operating.
5. The unit must be installed in a location with adequate ventilation, atleast 20inches (50 cm)
from adjacent surfaces. Be sure that no ventilation slots are blocked.
6. Always disconnect from power source before servicing or replacing fuse and be sure to
replace with same fuse rating.
7. Secure xture to fastening device using a safety chain.
8. Maximum ambient temperature (Ta) is 104° F (40° C). Do not operate xture at temperatures
higher than this.
9. In the event of a serious operating problem, stop using the unit immediately. Never try to
repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or
malfunction and will void your warranty. Please contact the nearest authorized technical
assistance center.
10. Never connect the device to a dimmer pack.
11. Make sure the power cord is never crimped or damaged.
12. Never disconnect the power cord by pulling or tugging on the cord.
13. Never carry the xture directly from the cord. Always use the hanging/mounting bracket.
14. Avoid direct eye exposure to the light source while it is on.
Congratulations on purchasing your new lighting effect
from Lexlighting. Reading through this manual will ensure
trouble free and long life operation of the unit.
Features:
- 96 High Brightness LED’s (Red, Green & Blue)
- Sound To Light (Inbuilt Microphone)
- Full DMX
- Master/Slave Mode (up to 4 slaves)
- Digital Settings Display
- Package Spec: D400cm W310cm H230cm
- Package Weight: 3kg Approx
Contents:
- Light Unit Dualex II
- IEC Mains Cable UK Plug
- Hanging Bracket
- User Manual
Sound to Light (Music Trigger Mode)
To put your xture in sound-to-light mode:
G-1-
MODE ENTER
UP DOWN
Press the MODE button until the rst letter in the display shows “G”.
Then using the UP and DOWN buttons, select “G-1-” and press
the ENTER button. Your light is now in sound to light and will run
through Programmed chases (patterns) one by one, activated by
sound using the built in Microphone.
Auto Mode
Auto mode will run through the programmed chases (patterns) one
by one regardless of any sound input. As above, simply Press the
MODE button until “G” is displayed. Using the UP and DOWN buttons select “G-2-” and press the ENTER button. Your light is now
in AUTO Mode. Selecting “G-3-” will stop the Auto Chase Mode.
Master/Slave Mode
Your Dualex allows you to connect it to other Dualex units (max 4
slaves) to create a stunning in-sync light show. This is achieved by
linking XLR cables(sold seperatley) from each xture using the DMX
IN and DMX OUT ports. Please observe the diagram below.
IN
OUT
IN
OUT
IN
OUT
IN
OUT
IN
OUT
MASTER
SLAVE 1 SLAVE 2 SLAVE 3 SLAVE 4
G-1- s-1- s-2- s-3- s-4-
Display Settings
Dualex’s
The above example shows the master units mode set on Sound Active. The 4 slaves will now also be sound active and be in-sync with
the master.
Digital Display
DMX IN
DMX OUT
IEC Power
Input
Fuse
Mode Button
Enter Button
Up Button
Down Button
Loading...