Level One WAB-6010 User Manual

English

Español

Deutsch

Português

Français

Italiano

LevelOne

Managed Wireless Access Point

Quick Installation Guide

V1.1_20170921

Figure 1

LAN

WAN/POE

Reset

DC

Power

WAN

LAN

5G

Signal Strength

Figure 2

WAB-5010

-1-

LEDs

Full Name

Description

Signal
Strength

Signal
Strength

Blink when runs properly
On without blink showing signal strength on
WDS and Repeater mode or under reboot

5G

5.8G WIFI

On 5.8G WIFI is on

WIFI

2.4G WIFI

On 2.4G WIFI is on

LAN

LAN Light

On LAN is connected

WAN

WAN Light

On WAN is connected

Power

Power Light

On Device is powered on

Power

WIFI

WAN

LAN

Figure 3

WAB-6010

-2-

Port

Description

WAN/P
OE

The WAN/POE port is used to connect to network devices,
such as a switch OR POE adapter to power the device

LAN

The LAN port is used to connect to network devices, such as a
switch or PC

Reset

WAB-5010

With the AP powered on, press the Reset button
for 10 seconds until the Signal Strength LED blink
faster than ever. The AP will restart itself and
reset the device to factory default settings.

WAB-6010

With the AP powered on, press the Reset button
for 10 seconds and release. When WIFI LED off,
the AP will restart itself and reset the device to
factory default settings.

Power

To power the device by DC

-3-