Page 1
Quick Installation Guide
English
Installation diagram
Deutsch
Installationsschema.
Français
Schéma d'installation.
Español
Diagrama de instalación.
Italiano
Diagramma di installazione.
Português
Diagrama de instalação.
PoE Switch
POR-Series
PD Device
100 m
100 m
Maximum Range
Connect with Standard 15.4W PSE
End to end distance
100m
200m
300m
400m
500m
Daisy-Chaining
( POR-1100)
0 1 2 3 4
Power Available
≦10.9 W
≦6.5 W
≦3.84 W
Data only
No power
Connect with Hi-Power 30W PSE
End to end distance
100m
200m
300m
400m
500m
600m
700m
800m
Daisy-Chaining
(POR-1100)
0 1 2 3 4 5 6
7
Power Available
≦25.5W
≦21W
≦16.5W
≦12W
≦7.5W
≦3.84W
Data only
No Power
Connect with Hi-Power 40W PSE
End to end distance
100m
200m
300m
400m
500m
600m
700m
800m
900m
Daisy-Chaining
(POR-1100)
0 1 2 3 4 5 6 7 8
Power Available
≦28W
≦25.5W
≦21W
≦16.5W
≦12W
≦7.5W
≦3.84W
Data only
No Power
PD Device≦6.5W
POE
Ethernet Switch
100 m
100 m
100 m
POWER
POWER
POWER
CE Marking Warning
CE marking is a certification mark that indicates conformity with health, safety, and
environmental protection standards for products sold within the European Economic Area
(EEA).The CE marking is also found on products sold outside the EEA that have been
manufactured to EEA standards. This makes the CE marking recognizable worldwide even to
people who are not familiar with the European Economic Area.
WEEE
WEEE is waste electrical and electronic equipment. It is end-of-life electrical and electronic
equipment and covers virtually everything with a plug or battery. ... The EC introduced the
WEEE Directive in 2002 to address the environmental impacts of unwanted electrical and
electronic equipment at end-of-life disposal.
FCC Certifications
This Equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received; including interference that may cause undesired
operation.
Loading...