Levante ECOPANELS500, ECOPANELS1000, ECOPANELS1500, ECOPANELS2000 Operation Manual

levante-products.com

Slimline Digital Panel Heater

Operation Manual

Note: These instructions must be read fully before commencing use of the heater.

Please retain these instructions for future reference.

FOR INDOOR USE ONLY

Models: ECOPANELS500, ECOPANELS1000, ECOPANELS1500, ECOPANELS2000

Levanté - DN4 5FB, UK

LEV0549_ECOPANELS_Instructions Manual.indd 1 03/07/2018 14:17

LEV0549/Page 1 of 8/Issue 1/07.18

levante-products.com

IMPORTANT SAFEGUARDS

Before use, please read and follow these instructions carefully, even if you feel you are familiar with the product.
They contain important information concerning the operation, safety and maintenance when using the product.
Please retain these instructions for future use and reference.

• When first installed you may experience a burning
smell or a little smoke, this is normal and will fade
within a few minutes.

• The surface temperature of this heater can be very
hot, do not touch when the heater is turned on.

• Only connect the product if the voltage indicated
on the product label(s) corresponds with the
mains voltage.

• The heater must not be located directly below a
wall socket.

• Do not unplug the product by pulling on the cord.
To unplug grasp the plug, not the cord.

• This product has an overheat protection safeguard
that turns off the heater whenever it begins to
overheat. If it does overheat switch off the heater,
remove mains plug from wall socket and allow to
cool down for 45 minutes. The heater will work
again when cooled. Carefully check prior to using
again that the reason for overheating was not
curtains, clothing, furniture etc covering any of the
heaters air vents.

• Turn off the appliance and unplug from socket when
not in use. Allow to cool down prior to cleaning. Use
a damp cloth for clean and a dry cloth to dry. Do not
use cleaning chemicals.

• Do not use the product in areas where petrol, paint
or flammable liquids are used or stored.

• If the power cord is damaged it must be replaced by
a service agent or a equivalent qualified electrician.
Do not continue to use until repaired, as it may
cause a hazard.

• This appliance is not intended to be used by young
children or disabled persons unless they have been
adequately supervised by a responsible adult to
ensure the appliance is used correctly and safely.

• Young children should be supervised to ensure they
do not play with the product.

• To protect against fire, electrical shock and injury to
persons, do not immerse the appliance power cord
or plug in water or other liquid.

• This appliance is intended for use indoor only. Avoid
overheating do not cover the heater with towels,
curtains, clothing etc.

• Never use the heater to dry clothing or similar items,
or handle the plug with wet hands.

• Ensure the heater is installed so that the switches
and other controls cannot be touched by a person in
the bath or shower.

• Ensure the appliance is securely fixed to the wall and
is correctly positioned level. The appliance should be
placed no less than 150mm from a barrier/wall on all
sides - top, bottom, left and right.

• Always unplug, wait for appliance to cool down, and
store if not to be used for prolonged periods of time.

Models covered by this instruction guide:

ECOPANELS500

Suggested room size: up to 5m
Dimensions: 385 x 280 x 72mm

ECOPANELS1000

Suggested room size: 5 - 10m
Dimensions: 540 x 280 x 72mm

ECOPANELS1500

Suggested room size: 10 - 15m
Dimensions: 790 x 280 x 72mm

ECOPANELS2000

Suggested room size: 15 - 20m
Dimensions: 1140 x 280 x 72mm

LEV0549_ECOPANELS_Instructions Manual.indd 2 03/07/2018 14:17

- 500W c/w digital programmer

- 1000W c/w digital programmer

- 1500W c/w digital programmer

- 2000W c/w digital programmer

2

2

2

2

Warning

In order to avoid overheating,
do not cover the heater.

LEV0549/Page 2 of 8/Issue 1/07.18

levante-products.com

INSTALLATION GUIDE

1. When mounting the
heater on to the wall
ensure the heater is
unplugged from the
mains socket and all
power switches are
turned off. A suitable
wall mounting area
requires at least
150mm of empty clearance on ALL four sides.

3. Position the bracket on
the wall in the desired
location and mark the
holes on the wall for
drilling, making sure
the bracket is level.
Drill holes to a suitable
depth and secure the
mounting bracket to
the wall with the four mounting screws supplied.
For masonry walls use the wall plugs with
screws provided.

2. Detach the mounting
bracket from the back
of the panel heater
by pushing down on
the top bracket and
then pulling the top
brackets out. The
bottom section will
then slide down and
out, releasing the mounting bracket.

4. Hang up the heater
on the brackets and
secure; Firstly locate
the heater onto the
lower bracket and
push back to locate
and click the upper
brackets into position.
Check heater is secure
and plug heater into
mains socket.

LOT20 Compliant

Item Symbol Value Unit

HEAT OUTPUT - ECOPANELS500

Nominal Heat Output P

Minimum Heat Output (Indicative) P

Maximum Continuous Heat Output P

HEAT OUTPUT - ECOPANELS1000

Nominal Heat Output P

Minimum Heat Output (Indicative) P

Maximum Continuous Heat Output P

HEAT OUTPUT - ECOPANELS1500

Nominal Heat Output P

Minimum Heat Output (Indicative) P

Maximum Continuous Heat Output P

HEAT OUTPUT - ECOPANELS2000

Nominal Heat Output P

Minimum Heat Output (Indicative) P

Maximum Continuous Heat Output P

AUXILIARY ELECTRICITY CONSUMPTION

At Nominal Heat Output el

At Minimum Heat Output el

In Standby Mode el

0.50 kW

nom

0.25 kW

min

0.48 kW

max,c

1.00 kW

nom

0.50 kW

min

0.90 kW

max,c

1.50 kW

nom

0.75 kW

min

1.40 kW

max,c

2.00 kW

nom

1.00 kW

min

1.90 kW

max,c

N/A kW

max

N/A kW

min

0.00 kW

SB

Item Unit

Type of heat input, for electric storage local space heaters only (Select one)

Manual Heat Charge Control, with Integrated Thermostat [No]

Manual Heat Charge Control with Room and/or Outdoor Temperature Feedback [No]

Electronic Heat Charge Control with Room and/or Outdoor Temperature Feedback [No]

Fan Assisted Heat Output [No]

Type of heat output/room temperature control (Select one)

Single Stage Heat Output and No Room Temperature Control [No]

Two or More Manual Stages, No Room Temperature Control [No]

With Mechanical Thermostat Room Temperature Control [No]

With Electronic Room Temperature Control [No]

Electronic Room Temperature Control Plus Day Timer [No]

Electronic Room Temperature Control Plus Week Timer [Yes]

Other control option (Multiple selections possible)

Room Temperature Control, with Presence Detection [No]

Room Temperature Control, with Open Window Detection [Yes]

With Distance Control Option [No]

With Adaptive Start Control [No]

With Working Time Limitation [No]

With Black Bulb Sensor [No]

LEV0549/Page 3 of 8/Issue 1/07.18

LEV0549_ECOPANELS_Instructions Manual.indd 3 03/07/2018 14:17