Leupold P4815, HP92 User Manual
P4815
PLUG
PLAY
&
hp92
19-inch Color Monitor
18.0-inch Viewable Image
User’s Guide
Notice
The information contained in this document is subject to change without notice.
Hewlett-Packard makes no warranty of any kind with regard to this material,
including, but not limited to, the implied warranties of merchantability and fitness
for a particular purpose.
Hewlett-Packard shall not be liable for errors contained herein or for incidental or
consequential damages in connection with the furnishing, performance, or use of
this material.
Hewlett-Packard assumes no responsibility for the use or reliability of its software
on equipment that is not furnished by Hewlett-Packard.
This document contains proprietary information that is protected by copyright. All
rights are reserved. No part of this document may be photocopied, reproduced, or
translated to another language without the prior written consent of HewlettPackard Company.
HP France 38053 Grenoble Cedex 9 France © 2002 Hewlett-Packard
Company
Full scan screen that gives
r
i
an edge-to-edge image
0.26 mm dot pitch for
excellent graphics
Non-glare, anti-stat
screen coating
On/Off Switch
Status Indicato
Image adjustment controls to operate
on-screen display menus
hp 92
P4815
19-inch Color Monitor
(18.0-inch Viewable Image)
User’s Guide
HP 19” Color Monitor User’s Guide
Important Safety Instructions
Important Safety Instructions
WARNING For your safety always connect equipment to a grounded wall outlet.
Always use a power cord with a properly grounded plug, such as the one
provided with the equipment, or one in compliance with your national
safety standards. This equipment can be disconnected from the power
by removing the power cord from the power outlet. This means the
equipment must be located close to an easily accessible power outlet.
To avoid electrical shock, do not open the monitor's cover. There are no
user-serviceable parts inside. Only qualified service personnel should
service these parts.
Make sure your computer is powered off before connecting or
disconnecting a display peripheral.
Working in
Comfort
CAUTION The monitor is quite heavy (the weight is shown in the technical
!
Thank you for selecting HP monitor equipment.
To optimize your comfort and productivity, it's important that you set
up your work area correctly and use your HP equipment properly. With
that in mind, we have developed some setup and user recommendations
for you to follow based on established ergonomic principles.
You can consult the online version of Working in Comfort preloaded on
the hard disk of HP computers, or visit HP's Working in Comfort web
site at:
http://www.hp.com/ergo/
specifications). We recommend you ask the assistance of a second
person when lifting or moving it.
The lightning flash with arrowhead symbol, situated within an equilateral
triangle, is intended to alert the user to the presence of uninsulated
"dangerous voltage" which may be of sufficient magnitude to constitute
a risk of electric shock.
The exclamation point within an equilateral triangle is intended to alert
the user to the presence of important operating and servicing
instructions in the literature accompanying the appliance.
2 EnglishEnglish
HP 19” Color Monitor User’s Guide
What Your New Monitor Offers
What Your New Monitor Offers
Your HP monitor is a 19-inch (18.0-inch viewable image), high
resolution, multi-synchronous color monitor. Multi-synchronous
means that the monitor supports a range of video modes. It is
optimized for use with all Hewlett-Packard computers.
Your HP color monitor has the following features:
•
A 19-inch flat square tube with a 18.0-inch viewable image.
0.26mm dot pitch for excellent graphics and anti-static and antiglare coating to minimize reflection.
•
Support for Ultra VGA 1600 x 1200 at 75 Hz refresh rate.
•
Image adjustment using on-screen display menus. Includes color
adjustment to optimize the quality of the image.
•
Monitor power management system (VESA1 standard) controlled
from suitably equipped HP computers to automatically reduce the
power consumption of the monitor. Complies with the Energy Star
Computers Program initiated by US EPA
HP has determined that this product meets the ENERGY STAR
guidelines for energy efficiency
•
Monitor Plug and Play capability (VESA DDC1/2B standard) that
3
.
enables the monitor to identify itself to suitably equipped HP
computers.
•
Compliance with ISO 9241-3/-7/-8 ergonomic standards.
•
Complies with MPRII and MPRIII level B guidelines for upper limits
of electrostatic and magnetic field emissions from the Swedish
National Board for Measurement and Testing.
•
Your monitor complies with TCO99 requirements. (Refer to
“TCO99 Ecology Energy Emission Ergonomics” on page 17).
•
Your monitor is Blue Angel compliant. Its cathode ray tube does
not contain cadmium.
•
HP guarantees the availability of spare parts for a period of 5 years
after production stop of the model.
2
. As an ENERGY partner,
1. VESA is the Video Electronics Standards Association.
2. The US EPA is the United States Environmental Protection Agency.
3. ENERGY STAR is a US-registered service mark of the US EPA.
English
English
3
HP 19” Color Monitor User’s Guide
Setting Up Your Monitor
Setting Up Your Monitor
Attaching the Tilt and Swivel Base
Your display has a tilt and swivel base. To fit the swivel base:
1
Turn the monitor on its side (never on the screen). Identify the front
of the base.
2
Locate the slots in the underside of the monitor.
3
Slide the base towards the front of the monitor until the locking tab
on the base clicks into place.
1
2
3
Where to Place the Monitor
Place your monitor on a flat sturdy surface. Ensure the operating site is
free from excessive heat, moisture, dust and sources of electromagnetic
fields. Sources of electromagnetic fields include transformers, motors,
and other monitors. Avoid exposing the monitor to direct sunlight.
4 EnglishEnglish
Loading...