Lenoxx Electronics PH-5562 User Manual

13 MEMORY JUMBO DISPLAY CALLER ID

SPEAKERPHONE

MODEL PH-5562

OPERATING INSTRUCTIONS

CALLER ID SHOWS YOU CALLER’S NAME & NUMBER

•

81 NAME & NUMBER CALLER ID MEMORY

•

HANDS-FREE SPEAKERPHONE WITH LED INDICATOR

•

INCOMING CALL INDICATOR

•

TONE/PULSE SWITCHABLE DIALING

•

AUTOMATIC TIME & DATE DISPLAY

•

ONE-TOUCH CALLER ID CALL BACK

•

13 MEMORY TELEPHONE (3 ONE-TOUCH & 10 TWO-TOUCH)

•

WALL/DESK USABLE

•

REQUIRES 4 SIZE “AA” BATTERIES (NOT INCLUDED)

•

TO USE THE CALLER ID FEATURE OF THIS PHONE, YOU MUST

SUBSCRIBE TO CALLER ID SERVICE FROM YOUR PHONE COMPANY,

AND REMEMBER TO INSTALL BATTERIES

NOTE: READ AND FOLLOW THESE INSTRUCTIONS BEFORE USING YOUR TELEPHONE

IB-PH5562-WM-E-010807

IB-PH5562-WM-E-010807.pmd1/23/2007, 5:08 PM1

IMPORTANT SAFETY INSTRUCTIONS

When using your telephone equipment, basic safety precautions should always be followed
to reduce the risk of fire, electric shock and personal injury, including the following:

1.Read and follow all instructions and warnings.

2.Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or
aerosol cleaners. Use a slightly dampened cloth only.

3.Do not use this product near water, for example, near a bathtub, wash bowl, kitchen
sink, or laundry tub, in a wet basement, or near a swimming pool.

4.Do not place this product on an unstable cart, stand or table. The product may fall,
causing serious damage to the phone.

5.Slots and openings in back or bottom of the phone are for ventilation, and should not
be blocked or covered. The openings should never be blocked by placing the product
on the bed, sofa, rug, or other similar surface. This product should never be placed near
or over a radiator, heat register or a built-in installation such as a bookcase or cabinet
unless proper ventilation is provided.

6.Never push objects of any kind into this product through cabinet slots as they may
touch dangerous voltage points or short out parts that could result in risk of fire or
electric shock. Never spill liquid of any kind on the product.

7.To reduce the risk of electric shock, do not take this telephone apart. When service or
repair work is required, take it to a qualified service representative, opening or
removing covers may expose you to dangerous voltage or other risks. Incorrect
reassembly can cause electric shock when the appliance is subsequently used.

8.Unplug this product from the wall outlet and refer servicing to qualified service
personnel under the following conditions:
A.When the cord or plug is damaged or frayed.
B.If liquid has been spilled into the product.
C.If the product has been exposed to rain or water.
D.If the product does not operate normally by following the operating instructions.

Adjust only those controls that are covered by the operating instructions because
improper adjustment of other controls may result in damage and will often require

extensive work by a qualified technician to restore the product to normal operation.
E.If the product has been dropped or the cabinet has been damaged.
F.If the product exhibits a distinct change in performance.

9.Avoid using a telephone (other than a cordless type) during an electrical storm. There
may be a remote risk of electric shock from lightning.

10.Do not use the telephone to report a gas leak in the vicinity of the leak.

11.Do not allow anything to rest on the telephone cord. Do not locate this product where
the cord will be damaged by persons walking on it.

12.Never install telephone wiring during a lightning storm.

13.Never install telephone jacks in wet locations unless the jack is specially designed for
wet locations.

14.Never touch uninsulated telephone wires or terminals, unless the telephone line has
beendisconnected at the network interface.

15.Be careful when installing or modifying telephone lines.

CAUTION: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK

AND PERSONAL INJURY, DO NOT OPEN CABINET.

IB-PH5562-WM-E-010807.pmd1/23/2007, 5:08 PM2

1

IB-PH5562-WM-E-010807

BATTERY SAFETY INSTRUCTIONS

CAUTION: TO REDUCE THE RISK OF FIRE OR PERSONAL INJURY, READ AND

FOLLOW THESE INSTRUCTIONS.

1.Use only the following type and size of batteries: 4 size “AA” alkaline batteries (not

included).

2.Do not dispose of the batteries into a fire. The cells may explode. Check with local
codes for possible special disposal instructions.

3.Do not open or mutilate the batteries. Released electrolyte is corrosive and may cause
damage to the eyes or skin. It may be toxic if swallowed.

4.Exercise care in handling batteries in order not to short the battery with conducting
materials such as rings, bracelets and keys. The battery or conductor may over heat
and cause burns.

5.Do not attempt to recharge the batteries that are used with this product. The batteries
may leak corrosive electrolyte or explode.

6.Do not attempt to rejuvenate the batteries identified for use with this product by heating
them. Sudden release of the battery electrolyte may cause burns or irritation to eyes or
skin.

7.All batteries should be replaced at the same time. Mixing fresh and discharged batteries
could increase internal cell pressure and rupture the batteries.

8.When inserting batteries into this product, the proper polarity or direction must be
observed. Reverse insertion of batteries may result in leakage or explosion.

9.Remove the batteries from this product if the product will not be used for a long period
of time (several months or more) since during this time the batteries could leak, damaging
the product.

10.Discard weak or dead batteries as soon as possible since they are more likely to leak in
the product. Batteries should be replaced when the display gets dim or if the Low
Battery Indicator appears in the display.

11.Do not store this product in high temperature areas. Batteries that are stored in a
freezer or refrigerator for the purpose of extending shelf life should be protected
from condensation during storage and defrosting. Batteries should be stabilized at
room temperature prior to use after cold storage.

12.If this product does not operate normally, see TROUBLE SHOOTING on pages 9 and

10. If you cannot resolve the problem, or if the product is damaged, refer to the
LENOXX WARRANTY INFORMATION on the last page. Opening or removing covers
may expose you to dangerous voltages or other risks. Incorrect reassembly can cause
electric shock when the appliance is subsequently used.

13. Installation of batteries should only be done by an adult for safety.

SAVE THESE INSTRUCTIONS

IB-PH5562-WM-E-010807.pmd1/23/2007, 5:08 PM3

2

IB-PH5562-WM-E-010807

CHECKING THE PACKAGE CONTENTS

As you unpack this set, make sure you have the following items in the package.

HANDSET

STRAIGHT TELE-

PHONE LINE CORD

TELEPHONE BASE

COILED HANDSET CORD

WALL MOUNT ADAPTOR (attach
to the back of the base for both
desk use and wall mounting)

POWERING THE PHONE

Before you connect the phone cords, follow these steps to install the batteries:

1.Insert a flat blade screwdriver or coin like a quarter into the slot and pry out (lift) the

battery door (FIG. 1).

2.Insert 4 size “AA” alkaline batteries as shown inside the battery compartment (FIG. 2).

3.Replace the battery door and snap it shut (FIG. 3).

FIG. 2FIG. 3FIG. 1

CAUTION

Replace the batteries when the low battery indicator

•

When the batteries are dead, the display will not show. You can still make or receive calls,
but you can’t use the Caller ID or memory dialing.

•

When the battery level is low, the speakerphone may not work properly, your data and
settings could also be erased.

IB-PH5562-WM-E-010807.pmd1/23/2007, 5:08 PM4

appears in the display..

3

IB-PH5562-WM-E-010807

ATTACHING THE BRACKET FOR DESK USE

The plastic bracket should be installed correctly for proper
desk use.

1.Arrange the bracket on the correct position of the bottom

of the base, please note the arrow on the bracket.

2.Insert the two lower tabs on the bracket into the corresponding

slots on the bottom of the base.

3.Push the two upper tabs on the bracket to insert them into

the corresponding slots on the bottom of the base.

4.To separate the bracket from the base, push the two upper

tabs on the bracket and pull the bracket out.

CONNECTING THE TELEPHONE

HANDSET

WALL JACK

REAR OF THE

TELEPHONE

SETTING UP LCD CONTRAST, LANGUAGE, AREA CODE, TIME AND DATE

You may need to set up the LCD contrast level, language, area code, time and date for your
telephone when you power your phone for the first time or when you move to an area that
has a different area code. Area code setting is necessary because the phone must distinguish
local or long distance calls to properly dial calls from the Caller ID list.

Press and hold the DELETE button down, then press the DOWN button, the following will
show in the display (FIG. 1). Release the DELETE button, press the UP or DOWN button to
choose the LCD contrast level (1-5). Press the DELETE button to confirm and accept. In
general, you can press the DISPLAY button directly to set the LCD contrast. Then the
display will come to the language setting.

FIG. 1FIG. 2FIG. 3

The default language “E” (“E” = English; “F” = French; “S” = Spanish) will flash (FIG. 2).
Press the UP or DOWN button to choose your desired language (flashing). Press the
DELETE button to confirm and accept.

4

IB-PH5562-WM-E-010807.pmd1/23/2007, 5:08 PM5

IB-PH5562-WM-E-010807