Lenoxx Electronics CD-210 User Manual

COMPACT DISC PLAYER

AM/FM STEREO CASSETTE RECORDER

MODEL CD-210

OPERATING INSTRUCTIONS

PLAYS ALL MUSIC COMPACT DISCS



DIGITAL TUNING WITH 20 RADIO PRESETS



FULLY PROGRAMMABLE CD PLAYER WITH REPEAT



RECEIVES AM/FM STEREO BROADCASTS



BASS BOOST SYSTEM



RECORDS FROM CD, RADIO, OR BUILT-IN MICROPHONE



2 WAY POWER - AC/DC



REQUIRES 8 SIZE C BATTERIES



PLEASE READ CAREFULLY BEFORE USE

CD-210SN021800 v.1 E

SAFETY INSTRUCTIONS

CAUTION

RISK OF ELECTRIC

SHOCK

DO NOT OPEN

The lightning flash and

arrow head within the

triangle is a warning

sign alerting you of

dangerous voltage

inside the product.

SEE BOTTOM OF THE SET

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT

EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

THESE IMPORTANT SAFETY INSTRUCTIONS ARE INCLUDED, AS APPLICABLE TO THE

APPLIANCE, CONVEYING TO THE USER THE INFORMATION ITEMIZED BELOW:

1.Read Instructions - All the safety and operating instructions should be read before

the appliance is operated.

2. Retain Instructions - The safety and operating instructions should be retained for

future reference.

3. Heed Warnings - All warnings on the appliance and in the operating instructions

should be adhered to.

4. Follow Instructions - All operating and use instructions should be followed.

5.Water and Moisture - The appliance should not be used near water - for example near

a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming

pool, and the like.

6.Wall or Ceiling Mounting - The appliance should not be mounted to a wall or ceiling.

7.Ventilation - The appliance should be situated so that its location or position does not

interfere with its proper ventilation. For example, the appliance should not be situated

on a bed, sofa, rug, or similar surface that may block the ventilation openings; or,

placed in a built-in installation, such as a bookcase or cabinet that impede the flow of

air through the ventilation openings.

8.Heat - The appliance should be situated away from heat sources such as radiators,

heat registers, stoves, or other appliances (including amplifiers) that produce heat.

9. Power Sources - The appliance should be connected to a power supply only of the

type described in the operating instructions or as marked on the appliance.

10. Grounding or Polarization - Precautions should be taken so that the grounding or

polarization means of an appliance is not defeated.

11. Power Cord Protection - Power supply cords should be routed so that they are not

likely to be walked on or pinched by items placed upon or against them, paying particular

attention to cords at plugs, convenient receptacles, and the point where they exit

from the appliance.

12. Cleaning - The appliance should be cleaned only as recommended by the manufacturer.

13. Nonuse periods - The power cord of the appliance should be unplugged from the

outlet when left unused for a long period of time.

CAUTION: TO REDUCE THE

RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR

BACK). NO USER SERVICEABLE

PARTS INSIDE. REFER

SERVICING TO QUALIFIED

SERVICE PERSONNEL.

The exclamation point

within the triangle is a

warning sign alerting you of

important instructions

accompanying the product.

SAFETY INSTRUCTIONS

14.Object and Liquid Entry - Care should be taken so that objects do not fall and liquids

are not spilled into the enclosure through openings.

15.Damage Requiring Service - The appliance should be serviced by qualified service

personnel when:

A. The power supply cord or the plug has been damaged; or

B. Objects have fallen, or liquid has been spilled into the appliance; or

C. The appliance has been exposed to rain; or

D. The appliance does not appear to operate normally or exhibits a marked change in

performance; or

E. The appliance has been dropped, or the enclosure damaged.

16.Servicing - The user should not attempt to service the appliance beyond that described

in the operating instructions. All other servicing should be referred to qualified service

personnel.

17.Power lines - An outdoor antenna should be located away from power lines.

18.Outdoor Antenna Grounding - If an outside antenna is connected to the receiver, be

sure the antenna system is grounded so as to provide some protection against voltage

surges and built up static charges. Section 810 of the National Electrical Code, ANSI/

NFPA 70 provides information with respect to proper grounding of the mast and supporting

structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding

conductors, location of antenna-discharge unit, connection to grounding electrodes,

and requirements for the grounding electrode. See Figure.

EXAMPLE OF ANTENNA GROUNDING AS PER

NEC - NATIONAL ELECTRICAL CODE

ANTENNA

LEAD IN WIRE

GROUND

CLAMP

ANTENNA DISCHARGE UNIT (NEC

SECTION 810-20)

ELECTRIC

SERVICE

EQUIPMENT

POWER SERVICE GROUNDING

ELECTRODE SYSTEM

(NEC ART 250, PART H)

GROUNDING CONDUCTORS

(NEC SECTION 810-21)

GROUND CLAMPS

It is the intent of Lenoxx that this product be used in full compliance with the

Do not apply oil or petroleum products or solvents to any part of this set.

CAUTION

Use of controls or adjustments or performance of procedures other than those

specified herein may result in hazardous radiation exposure.

This compact disc player is classified as CLASS 1 LASER PRODUCT as stated on

the bottom of the set.

BATTERY SAFETY INSTRUCTIONS

CAUTION: TO REDUCE THE RISK OF FIRE OR PERSONAL INJURY OR DAMAGE TO YOUR

1. Use only the type and size of batteries mentioned in the operating instructions

booklet (batteries are not included with this set, please buy the proper batteries).

2. Do not dispose the batteries into a fire. The cells may explode. Check with local

codes for possible special disposal instructions.

3. Do not open or mutilate the batteries. Released electrolyte is corrosive and may

cause damage to the eyes or skin. It may be toxic if swallowed.

4. Be careful when handling batteries in order not to short the battery with conducting

materials such as rings, bracelets and keys. The battery or conductor may over

heat and cause burns.

5. Do not attempt to recharge non-rechargeable batteries. The batteries may leak

corrosive electrolyte or explode.

6. Do not attempt to rejuvenate the batteries identified for use with this product by

heating them. Sudden release of the battery electrolyte may cause burns or

irritation to eyes or skin.

7. All batteries should be replaced at the same time. Mixing fresh and discharged

batteries could increase internal cell pressure and rupture the batteries.

8. When inserting batteries into this product, the proper polarity ( and ) or

direction must be observed. Reverse insertion of some or all of the batteries may

result in battery eletrolyte leakage or explosion.

9. Remove the batteries from this product if the product will not be used for a long

period of time (several months or more) since during the period the batteries could

leak, damaging the product.

10. Discard weak or dead batteries as soon as possible since they are more likely to

leak in the product. Batteries should be replaced (depending on the product) when

the display gets dim or if the Low Battery Indicator shows or if the sound gets

distorted.

11. Do not store this product in high temperature areas. Batteries that are stored in a

freezer or refrigerator for the purpose of extending shelf life should be protected

from condensation during storage and defrosting. Batteries should be stabilized at

room temperature prior to use after cold storage.

12. If this product does not operate normally, see TROUBLE SHOOTING in this

instruction manual. If you cant resolve the problem, or if the product is damaged,

refer to the LENOXX WARRANTY INFORMATION. Opening or removing covers

may expose you to dangerous voltages or other risks. Incorrect reassembly can

cause electric shock when the appliance is subsequently used.

13. If liquid leaks from the batteries, carefully wipe this liquid. Do not allow it to touch

your skin, and discard the leaking batteries.

14. Do not mix batteries (OLD and NEW or CARBON and ALKALINE, etc.).

15. The use of rechargeable batteries is not recommended for this set because their

voltage and life is lower than standard batteries.

16. Installation of batteries should be done by an adult only.

SET, READ AND FOLLOW THESE INSTRUCTIONS.

SAVE THESE INSTRUCTIONS

CHOOSING THE POWER SOURCES

You can use the AC power or batteries as a power source.

2. Battery compartment

TIP

If the plug of the AC power

cord does not match your

outlet, do not force it.

Reverse it and try again. The

plugs are polarized and only

fits one way into the wall

outlet and back of the set.

TIP

Replace the batteries when

the POWER lamp dims or

when the player stops

operating. Replace all the

batteries with new ones.

Before you replace the

batteries, be sure to take out

the CD from the player and

remember to check the

Battery Safety Instructions

on Page 3.

AC SOCKET

1. To a wall outlet

1. Connecting the AC power

cord

Insert one end of the supplied AC power cord to the

socket located at the rear of the player, and the

other end to the wall outlet.

2. Using the player on batteries

Insert 8 size C batteries (not supplied) into the

battery compartment.

To use the player on batteries, disconnect the AC

power cord from the player.

cccc

LOWER

cccc

UPPER

LISTENING TO THE RADIO

Connect the supplied AC power cord or batteries (see page 4).

Press the POWER switch, the

POWER indicator will turn on.

Press the RADIO switch, the

RADIO indicator will turn on.

BAND

Press the AM/FM BAND switch to

select the desired wave band.

Tune into the station you prefer

using the TUNING UP or DOWN

button. Each time the button is

pressed, the frequency changes.

Keep the button pressed, the

station will change rapidly

(automatic tuning), release the

button and it will stop at the next

strong station.

(NOTE: For FM stations, stretch

the FM antenna out.)

If you tune into a FM stereo station,

FM STEREO will show in the

display.

To hear more BASS sounds, press

the BASS BOOST button.

PRESETTING STATIONS

1-3

4&6

Connect the supplied AC power cord or batteries (see page 4).

Follow Steps 1 to 3 (LISTENING

TO THE RADIO on the previous

page) to select a station.

PGM

Press the STORE button, 

will show and 

in the display for about 6 seconds.

While the 

press the PRESET button to

choose a memory location (01-10).

PROGRAM

PRESET

 will flash

 is flashing,

PRESET PROGRAM



PRESET PROGRAM

PGM

TIP: UP TO 10 AM AND 10 FM STATIONS CAN BE STORED INTO THE PRESET

MEMORY LOCATIONS. (THEY WILL REMAIN IN MEMORY AS LONG AS

THE BATTERIES ARE INSTALLED, OR AC POWER CORD IS CONNECTED.)

Press the STORE button again to

confirm, the station now

broadcasting is stored into that

preset memory location. 

disappears from the display.

NOTE: Steps 4-6 should be done quickly.

Repeat the above steps to store

other 9 stations into memory.

PROGRAM

PRESET



+ 14 hidden pages