®
MODEL 9190M
PERSONAL AM/FM
STEREO CASSETTE PLAYER
Operating Instructions
RECEIVES AM/FM BROADCASTS
STEREO HEADPHONES INCLUDED
BUILT-IN BELT CLIP
REQUIRES 2 SIZE AA BATTERIES
( NOT INCLUDED)
IB-9190M(MX)-WM-E-090902
LOCATION OF CONTROLS
21
10
3
4
5
6
7
1. FUNCTION SWITCH - Select TAPE, AM, or FM function.
2. TUNING CONTROL - Tune the stations.
3. STEREO HEADPHONE JACK - Plug headphones into
this.
4. VOLUME CONTROL - Adjust volume.
5. FAST FORWARD BUTTON (FAST F.) - Advance the tape
quickly.
6. PLAY BUTTON - Play the tape.
7. STOP BUTTON - Stop the tape.
8. CASSETTE DOOR - Insert the tape from here.
9. BELT CLIP (at the back of the set)
10.BATTERY DOOR - Slide to open (at the back of the set).
AUTOMATIC STOP - This set will automatically shut
itself off when the tape has finished playing, and the
PLAY button will pop up.
9
8
--- 1---
IB-9190M(MX)-WM-E-090902
Congratulations! You now own a personal radio cassette
player, which is able to offer personal listening with your
headphones.
BATTERY INSTALLATION
Slide the BATTERY DOOR in the direction shown by
the arrow to open the door and insert 2 AA batteries,
taking care not to reverse the positive and negative
polarities.
NOTE:
Remove the batteries during long periods (about
30 days or more) of non-use, possible battery
leakage and corrosion can damage the set.
If the sound becomes weak and unclear, the
batteries may be weak. Replace both batteries at
once.
Alkaline batteries are recommended
and will normally provide more playing
time.
Do not mix old and new
batteries.
Do not mix alkaline, standard
(Carbon-Zinc) or rechargeable
(Nickel-Cadmium) batteries.
LISTENING TO THE RADIO
You may listen to the radio through the stereo headphones.
1.Insert the headphone plug into the HEADPHONE
jack.
2.Set the FUNCTION switch to AM or FM position.
3.Select the desired station with the TUNING control
(Adjust for clearest sound).
4.Adjust the VOLUME control for the most pleasing
sound.
5.When listening is completed, set the FUNCTION
switch to TAPE (RADIO OFF ) position.
As the headphone cord functions as the FM antenna, do
not bunch it up. Unwind and extend the cord as much as
possible.
--- 2 ---
IB-9190M(MX)-WM-E-090902
TO INSERT THE TAPE
1. Open the cassette door by holding the door as
shown and gently pulling it to you.
2. Insert the tape into the cassette holder ON THE
DOOR.
3. Close the cassette door gently till it clicks shut.
TAPE PLAYING
DIRECTION
FULL REEL ON
THE RIGHT SIDE
CAUTION: Do not pull the door too strongly or you may
damage the door, treat this set with care
and it will last a long time.
TAPE PLAY
1. Check whether or not the tape is tight before it is
inserted.
2. Open the cassette door by hand, face the side to be played
toward you, and insert the cassette tape. Close the cassette
door.
3. Connect the headphones to the HEADPHONE jack
and adjust the headphone band for proper fit.
4. Press the PLAY button.
5. Adjust the VOLUME to control the sound level as you
like.
6. To skip portions of the cassette tape, press the FAST
FORWARD button.
7. To stop playing the cassette tape, press STOP button,
and the power source is also turned off.
(This set has a built-in auto-stop and the tape mechanism
will stop playing and shut off when it reaches the end of
the tape.)
8. To hear the other side of tape, flip it over and press
PLAY.
TO HEAR THE SAME SONG AGAIN
1. Remove the tape, flip it around to the other side and insert it.
2. Press FAST FORWARD button for a short time.
3. Remove tape, flip it around to the original side, re-insert and
press PLAY.
To keep the tape from tangling,
firmly wind the tape before
inserting it into the player.
Use of a cassette with more
than 90 minutes, such as C120 (120 minutes), is not
recommended. The extreme
thinness of this tape may
damage this set.
--- 3 ---
IB-9190M(MX)-WM-E-090902
CLEANING TAPE HEAD
If the sound drops out or
excessive noise occurs, clean
the magnetic head, capstan
and pinch roller with a cotton
PINCH ROLLER
MAGNETIC HEAD
swab moistened with alcohol.
SPEAKER USE
To use the speakers as a desk-top cassette, simply plug the
speakers plug into the Headphone Jack of the player. Adjust
the Volume to the level you like.
REO
E
T
S
EO
R
E
T
S
CAPSTAN
NOTE: These are not
amplified speakers. This
means the sound will not be very
loud. Also the typical battery life
with speakers is about 3 hours
of cassette playing time.
COTTON SWAB
TROUBLE SHOOTING
PROBLEM CHECK THE FOLLOWING
Is the headphone plugged into the jack?
- Plug it in now.
No sound
PLAY button will
not stay down
AM / FM
reception weak
Poor quality play
back after using
tape play for a
long time
Tape stops
during normal
play
Tape jamming or
tangling
NORMAL BATTERY LIFE USING ALKALINE BATTERIES IS
ABOUT 6 HOURS OF CASSETTE PLAYING.
Is the VOLUME control at minimum?
- Raise the volume.
Are the batteries old or dead?
- Replace both batteries.
The tape has reached the end. Remove
the tape, flip it over to the other side and
insert into door and press PLAY.
Rotate the set for better AM or bring it
closer to a window. For FM, extend the
headphone wire straight.
1. Check if batteries are fresh and inserted
correctly.
2. Use a tape cleaning cassette tape to
clean the head (available at most radio
stores).
Try a different tape. Tape may be damaged.
Also try fast forwarding tape till the end.
1. Use only better quality tapes.
2. Do not use a cassette with more
than 90 minutes.
3. Make sure there are no loose layers of
tape visible before inserting the
cassette.
--- 4 ---
IB-9190M(MX)-WM-E-090902
GENERAL SPECIFICATION
Output power (Max)
Power source : 2 AA Alkaline batteries
Tape Section
Speed deviation
Frequency response
Radio Section
Frequency range:
: More than 20 mw/ch
: +3% -2%
:Standard normal bias cassette tape
70Hz - 10kHz
FM: 88 - 108 MHz
AM: 530 - 1700 kHz
We warrant this product to be free from defects in material
LIMITED WARRANTY
and workmanship under normal use for a period of 90 days
after purchase and we will repair it free of charge or replace it
at no charge, should it become defective under this warranty,
providing you submit proof of purchase (sales slip) with the
set.
During the initial 90 day period after original purchase, we
will service or exchange, at no charge, the set that is returned
to LENOXX ELECTRONICS CORP. After the initial 90 day
period expires, and for a period of 12 months from original
purchase, we will repair the unit covering any part(s) that
need to be replaced at no charge, but will charge for the cost
of labor, return postage paid by LENOXX.
This warranty does not apply to any products which have
been subject to misuse, neglect or accident. This warranty
does not cover broken headphones or cabinet. UNDER NO
CIRCUMSTANCES WILL LENOXX ELECTRONICS CORP. BE
LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL
DAMAGES. Some states do not allow the exclusion or limitation
of incidental or consequential damages, so the above
limitations or exclusions may not apply to you.
This warranty gives you specific legal rights, and you may
also have other rights which vary from state to state. The
following charges apply to repairs beyond the warranty period:
$6.00. Be sure to pack carefully and return postage paid
insured together with your money order (personal checks will
not be accepted) and sales receipt to:
LENOXX ELECTRONICS CORP., 2 GERMAK DRIVE,
CARTERET N.J. 07008
© 2001 LENOXX ELECTRONICS CORP.
2 GERMAK DRIVE
CARTERET, N.J. 07008
MADE & PRINTED IN CHINA
--- 5 ---
IB-9190M(MX)-WM-E-090902
Loading...