CASSETTE PLAYER
MODEL 822
Operating Instructions
1
2
3
4
8
1.STOP ( ) BUTTON
2.PLAY ( ) BUTTON
3.FAST F. ( ) BUTTON
4.HEADPHONES ( ) JACK
5. VOLUME CONTROL
6.BASS BOOST SWITCH
7. BATTERY DOOR (at back)
8.BELT CLIP (at back)
IB-822(CL)-WM-E-070506.pmd 7/6/2006, 11:57 AM1
5
6
7
--- 1 ---
IB-822(CL)-WM-E-070506
FCC NOTES
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This
device must accept any interference received, including
interference that may cause undesirable operation.
WARNING:
Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and
receiver.
-Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-Consult the dealer or an experienced radio / TV technician
for help.
IB-822(CL)-WM-E-070506.pmd 7/6/2006, 11:57 AM2
--- 2 ---
IB-822(CL)-WM-E-070506
READ THIS IMPORTANT INFORMATION BEFORE
USING YOUR HEADPHONES
This personal cassette player is one of the most exciting and
innovative consumer electronics products ever developed.
With it you can now enjoy listening to your favorite music
wherever you go, through the supplied headphones.
But, for YOUR comfort, health and safety be sure to observe
the following guidelines.
HEARING COMFORT & WELL-BEING
Do not play your headphones at a high volume. Hearing
•
experts advise against continuous extended play.
If you experience a ringing in your ears, reduce volume or
•
discontinue use.
TRAFFIC SAFETY
Do not use while operating a motorized vehicle. It may create
•
a traffic hazard and is illegal in many areas.
You should use extreme caution or temporarily discontinue
•
use in potentially hazardous situations.
Even if your headphones are an open-air type designed to
•
let you hear outside sounds, do not adjust the volume too
high so that you can hear what is around you.
IB-822(CL)-WM-E-070506.pmd 7/6/2006, 11:57 AM3
--- 3 ---
IB-822(CL)-WM-E-070506
BATTERY INSTALLATION
Slide the BATTERY DOOR in the direction shown by the arrow
to open the door and insert 2 “AA” batteries, taking care not to
reverse the positive and negative polarities.
Alkaline batteries are
recommended and will
normally provide more playing
time.
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc) or rechargeable
•
(nickel-cadmium) batteries.
NOTE:
Remove the batteries during long periods (about 30 days
•
or more) of nonuse, possible battery leakage and corrosion
can damage the set.
If the sound becomes weak and unclear, the batteries may
•
be weak. Replace both batteries at once.
TO INSERT THE TAPE
1.Open the CASSETTE DOOR by holding the door as shown
and gently pulling it to you.
2.Insert the tape into the cassette holder ON THE DOOR.
3.Close the CASSETTE DOOR gently till it clicks shut.
CAUTION: Do not pull door too strongly or you may damage
the door, treat this set with care and it will last a
long time.
IB-822(CL)-WM-E-070506.pmd 7/6/2006, 11:57 AM4
--- 4 ---
IB-822(CL)-WM-E-070506
TAPE PLAY
1.Check whether or not the tape is tight before it is inserted.
2.Open the CASSETTE DOOR by hand, face the side to be
played toward you, and insert the cassette tape. Close the
CASSETTE DOOR.
3.Connect the headphones to the jack and adjust the
headphones band for proper fit.
4.Press the PLAY button.
5.Adjust the VOLUME to control the sound level you like.
6.To skip portions of the cassette tape, press the FAST F.
button.
7.To stop playing the cassette tape, press the STOP button,
and the power source is also turned off.
(This set has a built-in auto-stop and the tape mechanism will
stop playing and shut off when it reaches the end of the tape.)
8.To hear the other side of tape, flip it over and press PLAY .
TO HEAR THE SAME SONG AGAIN
1.Remove the tape, flip it around to the other side and insert it.
2.Press the FAST F. button for a short time.
3.Remove tape, flip it around to the original side, reinsert and
press PLAY .
BASS BOOST SWITCH
This switch enhances the low frequency (bass) sound at low
listening levels. To suit your taste, rotate the BASS BOOST switch
upwards, the orange indicator appears inside the circle.
CLEANING TAPE HEAD
If the sound drops out or excessive
noise occurs, clean the magnetic
head, capstan and pinch roller with a
cotton swab moistened with alcohol.
To keep the tape from tangling, firmly
•
wind the tape before inserting it into the
player.
Use of a cassette with more than 90
•
minutes, such as C-120 (120
minutes), is not recommended. The
extreme thinness of this tape may
damage this set.
--- 5 ---
IB-822(CL)-WM-E-070506
IB-822(CL)-WM-E-070506.pmd 7/6/2006, 11:57 AM5
GENERAL SPECIFICATION
Tape function
Speed deviation
Frequency response
Output power (Max)
Power source
We warrant this product to be free from defects in material and
workmanship under normal use for a period of 90 days after purchase
and we will repair it free of charge or replace it at no charge, should
it become defective under this warranty, providing you submit proof
of purchase (sales slip) with the set.
During the initial 90 day period after original purchase, we will
service or exchange, at no charge, the set that is returned to LENOXX
ELECTRONICS CORP. After the initial 90 day period expires, and
for a period of 12 months from original purchase, we will repair the
unit covering any part(s) that need to be replaced at no charge, but
will charge for the cost of labor, return postage paid by LENOXX.
This warranty does not apply to any products which have been
subject to misuse, neglect or accident. This warranty does not cover
broken headphones or cabinet. UNDER NO CIRCUMSTANCES
WILL LENOXX ELECTRONICS CORP. BE LIABLE FOR ANY
INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do
not allow the exclusion or limitation of incidental or consequential
damages, so the above limitations or exclusions may not apply to you.
This warranty gives you specific legal rights, and you may also have
other rights which vary from state to state. The following charges apply
to repairs beyond the warranty period: $2.00. Be sure to pack carefully and
return postage paid insured together with your money order (personal
checks will not be accepted) and sales receipt to: LENOXX ELECTRONICS
CORP., 35 BRUNSWICK AVENUE, EDISON, N.J. 08817, USA
For customer service
Dial: 1-800-315-5885 (MONDAY - THURSDAY 8:00 AM - 5:00
PM, FRIDAY 8:00 AM - 1:30 PM EST)
or Visit Our Website: http://www.lenoxx.com
or Email: evergo@att.net
© 2006 LENOXX ELECTRONICS CORP.
: Play / Fast Forward / Stop
: +3% -2%
: 100Hz - 8kHz
: More than 20 mW/ch
: 2 “AA” Alkaline batteries (not included)
LIMITED WARRANTY
35 BRUNSWICK AVENUE
EDISON, N.J. 08817, USA
MADE & PRINTED IN CHINA
--- 6 ---
IB-822(CL)-WM-E-070506
IB-822(CL)-WM-E-070506.pmd 7/6/2006, 11:57 AM6
Loading...