Lenoxx HT377 Instruction

RED

WHITE

RED

SPEAKERS

QUICK INSTRUCTIONS

MODEL HT-377

A. PREPARATION

1.Battery installation

REMOTE control requires 2 size “AAA” alkaline batteries (included). Insert batteries as shown.

2.Remote control operating range

Point the REMOTE CONTROL (within 20 feet) at the HOME THEATER SYSTEM [SUBWOOFER] (not your TV set or DVD player).

3.System Connections

Connect the supplied speaker system by matching the colors of the terminals to those of the cords.

IMPORTANT: Before making connections, make sure the power is off.

QUICK SETUP DIAGRAM

IMPORTANT NOTE FOR DVD USE: This Home Theater

system only improve the sound of your DVD player; for your DVD’s video output, connect the video output jack to your TV’s video input jack.

WHITE

RED

REDWHITE

GREEN

RED

Remember to flip the main switch to the on position.

NOTE: In order to have TV sound come through your home theater system, your TV must have AUDIO OUTPUT jacks. These jacks will always be in the rear of the TV (and not in the front). If your TV does not have these output jacks, you have to use a cable box or a satellite receiver to get the audio.

QI-HT377-WM-E-050405

ON/STANDBY

STANDBY

B. BASIC PLAY

QUICK INSTRUCTIONS

REMOTE CONTROL

MUTE button

VOLUME -

button

MUTE

SOURCE

ON/STANDBY

button

SOURCE

button

VOLUME +

button

CONTROL PANEL

(ON THE FRONT OF THE SUBWOOFER)

ON/STANDBY

button

VOLUME +

button

SOURCE

button

MP3 indicator

VOL

SOURCE

DVD

MP3

ON/STANDBY

indicator

VOLUME -

button

DVD

indicator

1Make sure the POWERswitch on the back of the main set is at “ON” position. Next press the ON/STANDBY button on the

front of the main set or on the REMOTE CONTROL to turn the set on (or standby).

NOTE: The STANDBY indicator has 2 modes: flashing and steadily on (slow flashing indicates the set is in standby

mode, steadily on indicates the set is on). When the set is on, pressing the ON/STANDBY button on the main set or on the REMOTE CONTROL will turn the set to the standby mode, the indicator will become slow flashing.

2Press the SOURCE button on the front panel of the main set or on the REMOTE CONTROL to select one of the audio input

sources, the corresponding indicator will light, the factory’s default input source is DVD, when the set is turned on, the

DVD indicator will be on.

3For volume adjustments, press the volume control buttons on the Remote control, the ON/STANDBY indicator will flashs

to show you that the remote signal is received .

NOTE: Every time you turn the set on, the VOLUME will go back to the factory’s default setting; and whenever you press the SOURCE button on the main unit or on the REMOTE, the VOLUME will go back to the factory’s default setting. This avoids sudden very loud sounds from startling you.

4To momentarily shut off the sound, press the MUTE button. The source indicator (DVD or MP3) will flash. Press the MUTE

button again or press the VOLUME buttons to restore the sound.

NOTE: Flip the POWER switch on the back of the main set to “OFF” if the set will not be used for a long period of

time (several days or more).

QI-HT377-WM-E-050405