Lenovo ThinkStation 6427, ThinkStation 6493 installation instructions [ja]

ThinkStation machine types 6427, 6493 rack installation
safety and installation instructions

Note

Before using this information and the product it supports, be sure to read and
understand the Safety and Warranty Guide for this product and .

CAUTION:

Two persons are required to lift or move this product.

Do not install this unit in a rack where the internal rack ambient temperatures will
exceed 40 degrees C.

Do not install this unit in a rack where the air flow is compromised. Any side,
front or back of the unit used for air flow through the unit must not be in direct
contact with the rack.

Care should be taken to insure that a hazardous condition is not created due to
uneven mechanical loading when installing this unit in a rack. If the rack has a
stabilizer it must be firmly attached before installing or removed this unit.

Consideration should be given to the connection of the equipment to the supply
circuit so that overloading of the circuits does not compromise the supply wiring
or overcurrent protection. To provide the correct power connection to the rack,
refer to the rating labels located on the equipment in the rack to determine the
total power requirement of the supply circuit.

An electrical outlet that is not correctly wired could place hazardous voltage on the
metal parts of the system or the devices that attach to the system. It is the
responsibility of the customer to ensure that the outlet is correctly wired and
grounded to prevent an electrical shock.

Since the design and configuration of rack enclosures varies, consideration must be
given to the placement of Lenovo products into third party racks and third party
products into Lenovo racks. It is the customer’s responsibility to ensure the
product can be safely mounted in the rack and the rack enclosure adequately
provides proper ventilation/cooling, proper stability, and sufficient structural
integrity for the product when installed in the rack.

Installation procedures

Use the following instructions to install a rail system and machine types 6427 and
6493 in a rack.

1

Rail Kit Installation

TM

Figure 1. Page one of two installation instructions

2 Untitled