Lenovo MW600-B-LO User Manual

Version 1.0 2008.12

www.lenovo.com

MW600-B-LO

Wireless 802. 11b/g wireless PCI-E Adapter Card

User Manual

31036026

31036026_MW600_UG_FM_EN.indd 1 2008.11.7 11:00:14 AM

Contents

Federal communication commission interference statement .............1

FCC caution ..................................................................................1

Important note: ..............................................................................1

FCC radiation exposure statement: ...............................................1

Users manual of the end product: ........................................................

Label of the end product: ......................................................................

Important note: ..............................................................................3

Important information ...........................................................................3

What’s new ...................................................................................3

Features ........................................................................................3

System hardware requirements .....................................................4

Hardware driver compatability .......................................................4

LED Indicators ...............................................................................5

Fast ﬂashing: WiFi trafﬁc

Introduction ............................................................................................5

Overview of the product .................................................................5

Features .........................................................................................5

Wireless conﬁguration methods ......................................................5

Appendix A Speciﬁcations ................................................................. 15

31036026_MW600_UG_EN.indd 1 2008.11.7 10:59:26 AM

31036026_MW600_UG_EN.indd 2 2008.11.7 10:59:26 AM

MW600-B-LO Wireless 802. 11b/g wireless PCI-E Adapter Card

Federal communication commission interference statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from thatto which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:

Any changes or modiﬁcations not expressly approved by the

party responsible for compliance could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Important note:

FCC radiation exposure statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

IEEE 802.11b or 802.11g operation of this product in the U.S.A. is ﬁrmware-limited to channels 1 through 11.

When using the device in the in United States (or where FCC rules apply), it is the

31036026_MW600_UG_EN.indd 1 2008.11.7 10:59:26 AM

MW600-B-LO Wireless 802. 11b/g wireless PCI-E Adapter Card

responsibility of the professional installer to ensure to control the output power not grater then the application.

Manual Information To the End User

The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module.

The end user manual shall include all required regulatory information/warning as show in this manual.

Users manual of the end product:

In the users manual of the end product, the end user has to be informed to keep at least 20cm separation with the antenna while this end product is installed and operated. The end user has to be informed that the FCC radio-frequency exposure guidelines for an uncontrolled environment can be satisﬁed. The end user has to also be informed that any changes or modiﬁcations not expressly approved by the manufacturer could void the user’s authority to operate this equipment.

The FCC part 15.19 statement below has to also be available in the manual:

This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.

Label of the end product:

The ﬁnal end product must be labeled in a visible area with the following “Contains TX FCC ID: N89-MW600BLO”.

This device is intended only for OEM integrators under the following conditions:

1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and

2) The transmitter module may not be co-located with any other transmitter or antenna,

31036026_MW600_UG_EN.indd 2 2008.11.7 10:59:26 AM

MW600-B-LO Wireless 802. 11b/g wireless PCI-E Adapter Card

3) For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for 2.4G band by supplied ﬁrmware programming tool. OEM shall not supply any tool or info to the end-user regarding to Regulatory Domain change.

As long as 3 conditions above are met, further

transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.).

Important note:

In the event that these conditions can not be met (for example

certain laptop conﬁgurations or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not

be used on the ﬁnal product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.

Manual Information To the End User

The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module.

The end user manual shall include all required regulatory information/warning as show in this manual.

Important information

Please read the information below before using the MW600-B-LO 11b/g wireless PCI- Express card on your system.

What’s new

The latest generation PCI (Peripheral Component Interconnect) bus architecture called PCI Express, uses a 2.5- GHz serial Input/Output structure for higher bandwidth and better scalability than its previous architectures. .

Features

• PCI Express PCIe interface.

• X1-lane 2.5Gbps PCI Express host interface, Low proﬁle

• IEEE 802.11g compliant.

31036026_MW600_UG_EN.indd 3 2008.11.7 10:59:27 AM

+ 13 hidden pages