Lenovo B510 User Manual

Initial setup instructions

All-in-One Desktop PC

31 2

4 65

Unpack

If the computer is configured with a wireless keyboard and mouse, setup the keyboard and mouse wireless connection.(For more details refer to the back of this poster).

Adjust the angle for the best viewing experience. It can be rotated between 15 degrees and 35 degrees from the vertical position.

The computer stand must remain installed at all times to ensure maximum system stability. Make sure the angle of the computer is at least 15 degrees from the vertical position; otherwise the computer will be unstable and could fall over. To open the computer stand, refer to the illustration:

Version: 2.0

1. Computer 2. Mouse 3. Power cord 4. Keyboard 5. User manual

6. Remote control (Selected models only)

Connect the power cord to the computer and the electrical outlet as shown below.

Press the power button on the side of the computer to turn it on.

15° min.

35°

max.

31040254C

31044806

If the computer is configured with a wired keyboard and mouse, connect the keyboard and mouse cables to the appropriate keyboard (PS/2 connector) and mouse connectors (USB connector).

Touch buttons

The buttons located at the bottom-right-side of the screen are touch buttons. Press on any of the buttons ONCE to turn the indicator light ON to activate them. The buttons remain active while the indicator light is ON. Now, press on any of the buttons to change settings as desired. The indicator light turns off automatically after 10 seconds of inactivity.

31044806_IC_B5_QR_V2.0_(EN)(R).indd 1 2010-7-21 14:23:12

Computer instructions

Wireless keyboard and mouse configuration

—

Optical drive

—

Power button

—

Card reader

—

USB ports (2)

—

Headphone connector

—

Microphone connector

—

AV-IN connector

(Selected models only)

—

PS/2 Keyboard connector

—

Ethernet connector

—

USB ports (2)

—

TV-Tuner connector

(Selected models only)

—

eSATA port

—

Wireless reset button

—

Power connector

Put 2 AA batteries in the keyboard's battery compartment.

2 AA batteries

Battery compartment

Put 2 AA batteries in the battery compartment, making sure the position of the polarities is identical to the image.

Notes:

1) When establishing a wireless connection, it is recommended to keep the distance from the keyboard/mouse to the computer less than 25 cm (10 inches)

2) The effective working distance of the wireless keyboard and mouse is 10 m (33 feet) (depending on the computer's working environment).

If the wireless device does not work, do the following:

1. Be sure there is no physical obstacle between the wireless device and the computer.

2. Restart the computer, and verify that the system devices are functional.

3. Repeat the procedure for establishing a Bluetooth connection.

4. Replace the batteries.

5. Do not place the computer under a metal surface or table.

6. Make sure there are no electronic devices close by, such as speakers, remote controls of electronic toys or mobiles, which might create high electromagnetic fields that could interrupt the wireless connection.

7. Place the keyboard, mouse and remote control the right way up.

8. Remove the batteries from the keyboard, mouse and remote control if you do not plan to use them for a long time.

9. If the batteries in the keyboard, mouse or remote control leak, clean the battery compartments as soon as possible and insert new batteries.

10. Use batteries of good quality to ensure the proper function.

11. When battery power becomes low, the battery indicator light on the keyboard will change from orange to red.

Camera

Built-in microphone

Volume down

Volume up

Brightness down

Brightness up

LCD On/Off

Indicator lights ON/OFF button

If connection is not established successfully, refer to "Wireless keyboard and mouse instructions" in the User Guide.

The wireless keyboard and mouse are pre-synchronized, for your convenience, to work with your Lenovo PC. The keyboard and mouse should work immediately after you install the batteries, and then turn on the mouse and keyboard.

1. Install the batteries.

When the battery indicator light blinks red, it means that the battery power becomes low.

When the battery indicator light blinks white, it means that the keyboard or mouse is being connected.

LV T

LV T :

After entering Windows, press this key to launch the LVT (Lenovo Vantage Technology) program, Lenovo's pre-loaded Home PC software. In addition to its own functions, the LVT program will allow you to start other Windows compatible software, specially configured to run on this model of computer.

You may need to manually synchronize the wireless keyboard or mouse if they are not functioning. To synchronize them, do the following:

2. Turn on the power switch.

After installing the batteries, turn on the power switch on the side of the keyboard.

Turn on the mouse power switch.

If you do not plan to use the mouse for a long time, turn off the mouse power switch to save battery life.

1. Press the wireless connect button.

connect

Press the wireless connect buttons on the back of the keyboard and mouse.

2. Make sure the indicator lights blink and press the wireless reset button.

When the keyboard and mouse wireless indicator lights blink white, press and hold the wireless reset button for over 5 seconds until the indicator lights of the keyboard and mouse turned off.

31044806_IC_B5_QR_V2.0_(EN)(R).indd 2 2010-7-21 14:23:15