Lenovo 41X8111 User Manual

Hardware Replacement Guide Lenovo 3000 J Series

Types 7387, 7388, 7389, 7393, 7394, 7395

Lenovo 3000 J Series

Second Edition (February 2007)

U.S. GOVERNMENT USERS – RESTRICTED RIGHTS: Our products and/or services are provided with RESTRICTED RIGHTS. Use, duplication or disclosure by the Government is subject to the GSA ADP Schedule contract with Lenovo Group Limited, if any, or the standard terms of this commercial license, or if the agency is unable to accept this Program under these terms, then we provide this Program under the provisions set forth in Commercial Computer Software–Restricted Rights at FAR 52.227-19, when applicable, or under Rights in Data-General, FAR 52.227.14 (Alternate III).

Overview . . . . . . . . . . . . . .v

Safety information . . . . . . . . . . . .v

Additional information resources . . . . . . .v

Tools required . . . . . . . . . . . . . .v

Handling static-sensitive devices . . . . . . .v

Chapter 1. Locations . . . . . . . . .1

Locating the connectors on the front of your

computer . . . . . . . . . . . . . . .1

Locating the connectors on the rear of your computer 2

Locating components . . . . . . . . . . .3

Identifying parts on the system board . . . . . .4

Chapter 2. Replacing hardware . . . . .7

Removing the cover . . . . . . . . . . . .7

Replacing a memory module . . . . . . . . .8

Replacing a PCI adapter . . . . . . . . . .9

Replacing a keyboard . . . . . . . . . . .11

Replacing a mouse . . . . . . . . . . . .11

Completing the parts replacement . . . . . . .12

Appendix. Notices . . . . . . . . . .15

Television output notice . . . . . . . . . .16

Trademarks . . . . . . . . . . . . . .16

iv Hardware Replacement Guide

Overview

This guide is intended to be used by customers who are replacing Customer Replaceable Units (CRUs). In this document, CRUs will be referred to as parts.

This guide does not include procedures for all parts. It is expected that cables, switches, and certain mechanical parts can be replaced by trained service personnel without the need for step-by-step procedures.

This guide contains instructions for replacing the following parts:

Note: Use only the parts provided by Lenovo™.

v Memory module

v PCI adapter card

v Keyboard

v Mouse

Safety information

Do not open your computer or attempt any repair before reading the “Important safety information” in the Safety and Warranty Guide that was included with your computer. To obtain a copy of the Safety and Warranty Guide, go to the World Wide Web at http://www.lenovo.com/support.

Additional information resources

If you have Internet access, the most up-to-date information for your computer is available from the World Wide Web.

You can find the following information:

v CRU removal and installation instructions v CRU removal and installation videos v Publications v Troubleshooting information v Parts information v Downloads and drivers v Links to other useful sources of information v Support phone list

access this information, point your browser to http://www.lenovo.com/support

Tools required

To replace some parts in your computer, you might need a flat-blade or Phillips screwdriver. Additional tools might be needed for certain parts.

Handling static-sensitive devices

Static electricity, although harmless to you, can seriously damage computer components and parts.

When replacing a part, do not open the static-protective package containing the new part until the defective part has been removed from the computer and you are ready to install the new part.

When you handle parts and other computer components, take these precautions to avoid static-electricity damage:

v Limit your movement. Movement can cause static electricity to build up around

you.

v Always handle parts and other computer components carefully. Handle

adapters, memory modules, system boards, and microprocessors by the edges. Never touch any exposed circuitry.

v Prevent others from touching the parts and other computer components.

v Before you replace a new part, touch the static-protective package containing the

part to a metal expansion-slot cover or other unpainted metal surface on the computer for at least two seconds. This reduces static electricity in the package and your body.

v When possible, remove the new part from the static-protective packaging and

install it directly in the computer without setting the part down. When this is not possible, place the static-protective package that the part came in on a smooth, level surface and place the part on it.

v Do not place the part on the computer cover or other metal surface.

vi Hardware Replacement Guide

+ 18 hidden pages