Lennox SPDML45C, APDL35SP, APDML30C, SPDML40C, APDL40SP User Manual

...

LENNOX HEARTH PRODUCTS

KITS AND ACCESSORIES

INSTALLATION INSTRUCTIONS FOR OPTIONAL STYLE VIEW DOOR KITS FOR USE WITH

LENNOX (ELDV) ELITE™ SERIES AND (MPLDV) MERIT™ PLUS SERIES GAS FIREPLACES

STYLE VIEW DOOR KITS

Cat. No. Model Description Model Series

ARCH PANE DESIGN KITS

H3970 APDL35C 35” Arch Doors, Charcoal

H3971 APDL35SP 35” Arch Doors, Satin Pewter

H3973 APDL40C 40” Arch Doors, Charcoal

H3974 APDL40SP 40” Arch Doors, Satin Pewter

H3976 APDL45C 45” Arch Doors, Charcoal

H3977 APDL45SP 45” Arch Doors, Satin Pewter

SQUARE PANE DESIGN KITS

H3979 SPDL35C 35” Square Doors, Charcoal

H3980 SPDL35SP 35” Square Doors, Satin Pewter

H3982 SPDL40C 40” Square Doors, Charcoal

H3983 SPDL40SP 40” Square Doors, Satin Pewter

H3985 SPDL45C 45” Square Doors, Charcoal

H3986 SPDL45SP 45” Square Doors, Satin Pewter

Table 1

KIT CONTENTS

ITEM QUANTITY DESCRIPTION

1 1 ea. Door, Left

2 1 ea. Door, Right

3 1 ea. Doorframe Assembly

4 1 ea. Instruction Sheet

TOOLS REQUIRED - None

Read and understand all instructions and warnings in this

document before beginning the installation.

ELDV35

ELDV40

ELDV45

ELDV35

ELDV40

ELDV45

750,215M REV. B 08/2007

STYLE VIEW DOOR KITS

Cat. No. Model Description Model Series

ARCH PANE DESIGN KITS

H6104 APDML30C 30” Arch Doors, Charcoal

H6105 APDML30SP 30” Arch Doors, Satin Pewter

H6106 APDML35C 35” Arch Doors, Charcoal

H6107 APDML35SP 35” Arch Doors, Satin Pewter

H6108 APDML40C 40” Arch Doors, Charcoal

H6109 APDML40SP 40” Arch Doors, Satin Pewter

H6110 APDML45C 45” Arch Doors, Charcoal

H6111 APDML45SP 45” Arch Doors, Satin Pewter

SQUARE PANE DESIGN KITS

H6096 SPDML30C 30” Square Doors, Charcoal

H6097 SPDML30SP 30” Square Doors, Satin Pewter

H6098 SPDML35C 35” Square Doors, Charcoal

H6099 SPDML35SP 35” Square Doors, Satin Pewter

H6100 SPDML40C 40” Square Doors, Charcoal

H6101 SPDML40SP 40” Square Doors, Satin Pewter

H6102 SPDML45C 45” Square Doors, Charcoal

H6103 SPDML45SP 45” Square Doors, Satin Pewter

CHARCOAL AND SATIN PEWTER

STYLE VIEW DOOR KITS

MPLDV30*

MPLDV35

MPLDV40

MPLDV45

MPLDV30*

MPLDV35

MPLDV40

MPLDV45

Table 2

KIT CONTENTS

ITEM QUANTITY DESCRIPTION

1 1 ea. Door, Left

2 1 ea. Door, Right

3 1 ea. Doorframe Assembly

4 2 ea. Door Clip

5 1 ea. Instruction Sheet

*30” Doors Feature A Single Piece Non-Operable Facade Panel

Arch Pane Design

Square Pane Design

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Arch Pane Door/Facade Design

Square Pane Door/Facade Design

GENERAL INFORMATION

These decorative screen doors are offered in two attractive ﬁnishes and ﬁt on the face of the appliance over the glass doorframe. If you encounter any problems, need clariﬁcation of these instructions or are not qualiﬁed to properly install this kit, contact you local distributor or dealer.

WARNINGS

Hot! Do not touch!

The decorative screen doors and the glass behind the screen doors will become hot during operation heat for a while after shutting off the appliance

and will retain

. Severe burns may result. Carefully supervise children in the same room as appliance.

* NOTE: The ﬁreplace is equipped with a unit-mounted ON/OFF switch.

In most installations this switch is not used. If you desire to use the switch and want to install these Style View Doors, you may desire to relocate the switch into the bracket provided on the door frame. This is OPTIONAL. If you desire to relocate the switch complete the optional procedures indicated by the asterisks below. Steps 2, 4 and 5 refer to ELDV Models only. For MPLDV Models, purchase a Rocker Switch kit model FRS (80L41).

*2. Remove the Piezo / Switch Bracket from ﬁreplace control compartment

by pulling it forward as shown in Figure 2 (also see Figure 6).

• These decorative screen doors are NOT heat guards and are not intended to prevent burns.

• Operate the doors by only using the door handles. Avoid touching the doorframe, screens, or the glass enclosure, if the door is opened.

• Use care when opening doors. Avoid exerting any downward pressure on the doors when they are in an open position. Excessive force can cause the doors to come loose or be damaged.

• INSTALL ONLY WHEN THE FIREPLACE IS OFF AND COLD!

INSTALLATION INSTRUCTIONS:

1. Remove and retain the Lower Panel per instructions in Figure 1.

Retain the lower panel for future use in case the Style View Door Kit is ever removed.

Piezo & Switch

Bracket

Piezo & Switch

Locating Bracket

Figure 2

*3. Disconnect the black and white wires from the ON/OFF switch. *4. Remove the ON/OFF switch from the bracket by squeezing the ﬂex

catches on sides of switch until it releases from bracket.

*5. Reinstall the bracket with the piezo (reverse Step 2).

6. Remove Doorframe from packaging. Install as follows: *a. Position switch wires in front, inside of control compartment (so

they can easily be reached after doorframe is in position).

b.Position the bottom of the doorframe so that the bracket on the

inside of the doorframe locks behind the cabinet bottom ﬂange as shown in Figure 4.

*c. Feed the switch wires through the switch mounting bracket on

doorframe as shown in Figure 3.

Wires for

Switch Mounting

Remove this lower panel by lifting it up and out.

Figure 1

Figure 3

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Bracket on Doorframe

ON/OFF switch

+ 2 hidden pages