Lennox MPE-27 User Manual 2

HEARTH PRODUCTS

KITS AND ACCESSORIES

750,245M REV. N/C 02/2007

MPE-27 LEVELING

LEG FIELD FIX KIT

INSTALLATION INSTRUCTIONS FOR MPE-27 LEVELING LEG FIELD FIX KIT (CATALOG NUMBER - H5808)

GENERAL INFORMATION

This kit was designed to provide an alternate leg configuration for use when previously used bracketed legs may interfere with tightly framed installations.

Kit Contents:

Rubber Legs - Four (4), Sheet Metal Screws - Four (4), Instruction Sheet - One (1).

Tools Required:

Phillips screwdriver, or Drill-Driver with Phillips Bit.

INSTALLATION INSTRUCTIONS

Disconnect power and allow the electric fireplace to cool before starting any work.

Step 1. Tilt the unit back and rest it on its rear panel. Step 2. Unscrew the eight (8) screws and remove the four (4) leveling brackets with legs from both sides of the fireplace ( Step 3. Remove the four existing screws from the bottom of the fireplace and discard.

see Figure 1

Step 4. Attach the provided rubber legs with provided sheet metal screws to the fireplace bottom, using the existing mounting location ( Step 5. Return the fireplace to its upright position.

Existing Mounting Hole And Location Of New Rubber Leg

Figure 1

Unit Resting On Rear Panel

Existing Leveling Leg With Bracket

Figure 1

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information.

P/N 750,245M REV. N/C 02/2007

LHP 1110 West Taft Avenue Orange, CA 92865