Lennox LSVFSD-24, LSVFSD-30, LSVFSD-8 User Manual
Middle Log
Left Top Twig
Left Top Log
Right Top Log
Rear Log
Left Front Log
Front Ember Bed
Right Front Log
Rear Ember Bed
Center Top Log
HEARTH PRODUCTS
TM
KITS AND ACCESSORIES
LOG PLACEMENT INSTRUCTIONS FOR
SHADOWDANCE™ SERIES GAS LOGS SETS
GENERAL INFORMATION
This log placement instructions addendum has been prepared to assist in
the placement of new or replacement log sets. The information provided
here is to be used in conjunction with the Installation and Operation
manual. Please read the Care and Operation Instructions completely
before completing the procedures detailed in this placement guide. If
you encounter any problems, need clarification of these instructions
or are not qualified to properly install this log set, contact you local
distributor or dealer.
Read this instruction sheet in its entirety before beginning the
installation.
RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
READ IMPORTANT WARNINGS BEFORE PROCEEDING.
750,239M
REV. B 11/2007
Cat. No Model Description
H5137 LSVFSD-18 Shadowdance™ 18" Log Set
H5138 LSVFSD-24 Shadowdance 24" Log Set
H5139 LSVFSD-30 Shadowdance 30" Log Set
LOG SET
WARNINGS
• Do not attempt to install the logs until the appliance installation has been completed, the
gas line connected and tested for leaks and the
initial burner operation has been checked out.
• If logs are not installed according to the log installation instructions, flame impingement and improper
combustion could occur and result in soot and/or
excessive production of carbon monoxide (CO), a
colorless, odorless, toxic gas.
• The size and position of the log set was engineered to give the appliance a safe, reliable and
attractive flame pattern. Any attempt to use a
different log set with the Shadowdance series gas
train models, LSVFSD-NG OR LSVFSD-LP will
void the warranty and will result in incomplete
combustion, sooting, and poor flame quality.
• Do not add extra logs or ornaments such as pine
cones, vermiculite or rock wool. Using these
added items can cause sooting.
• Do not place any lava rock on logs or burners.
This may cause sooting. Only place lava rock
on floor of fireplace.
• All warnings and precautions in the installation
and operation manual provided with the appliance apply to these instructions.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
*
The twig indicated is included in the 24" and 30" log sets only.
*
• The 30" log set also includes 2 ember chunks (shown in
Figure 9).
1
LOG PLACEMENT INSTRUCTIONS
1. Place rear ember bed as shown in Figure 1.
4. Place left and right front logs onto front grate locating pins as
shown in Figure 4.
Install
Ember bed
from behind
top burner
Locating
Pins
Top Burner
Rear Ember Bed
Position Ember Bed All the Way
Forward in Gas Train Assembly
Figure 1 - Install Rear Ember Bed
2. Place rear log onto the two rear grate locating pins as shown
in Figure 2 (the locating pins are outlined in Figure 1).
Rear Log
Rear Locating Pins
On Grate Assembly
Left Front Log
Locating Pins Indicated by Arrows
Right Front Log
Figure 4 - Install Left and Right Front Logs
5. Place left top log onto rear log and middle log locating pins
as shown in Figure 5.
Left Top Log
Locating Pins
Figure 2 - Install Rear Log
3. Place middle log onto left middle grate locating pin and the
rear ember bed locating pin as shown in Figure 3.
Middle Log
Locating Pins
Figure 3 - Install Middle Log
2
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Figure 5 - Install Left Top Log
6. Place the center top log onto the rear log locating pin and
middle log locating pin as shown in Figure 6.
Center Top Log
Locating Pins
Figure 6 - Install Center Top Log
Loading...