Lennox LSS-CA35 User Manual 2
LENNOX HEARTH PRODUCTS
INSTALLATION INSTRUCTIONS FOR CAST IRON FACADE KITS
Model Numbers LSS-CA35 (H0378) and LSS-CA40 (H0398)
FOR USE WITH SPECTRA LSS SERIES GAS FIREPLACES
HEARTH PRODUCTS
KITS AND ACCESSORIES
750,150M REV N/C 8/2002
CAST IRON
FACADE KITS
GENERAL INFORMATION
These cast iron facade kits are designed to be used in conjunction with
the grillwork kits. Together, when installed, these kits complete the front
aspect of the Spectra LSS series gas fireplaces. The kits contain one
of each of the following cast iron facade pieces: bottom, top, left and
right piece. They also contain four 1/2 inch long 1/4-20 facade holding
screws, four 1-1/2 inch long 1/4-20 facade holding screws and these
instructions.
INSTALLATION INSTRUCTIONS
Step 1. Install the top and bottom grills to their corresponding top
and bottom cast iron facade pieces as detailed in the
installation instructions provided with the grillwork kits.
Step 2. Install four kit-provided facade holding screws to each of the
two side pieces ensuring compliance with the gaps shown in
Figure 1
.
1/2 inch long Cast Iron Side Piece Holding Screws
3/32 inch
(2.38 mm)
1-1/2 inch long Cast Iron Bottom Piece Holding Screws
1-1/4 inch
(31.8 mm)
Step 3. Hook the two cast iron side pieces onto the fireplace side
channels as shown in
adjust the gap of the two holding screws. (See
Side Piece
Note: The left cast iron side piece (shown above) is sloped upward
at the top, from left to right, to form a mating fit to the arched cast iron
top piece. The right cast iron top piece has the opposite slope at the top.
Figure 2
Installing Cast Iron Side Pieces
Figure 2
. If the fit is too tight or loose,
Figure 1
Cast iron side piece screw head
hooked behind top portion of shown
fireplace side channel detail
(top and bottom same method).
.)
Cast Iron Side Piece
Figure 1
1/2 inch long,
1/4-20 Facade Holding Screws
1-1/2 inch long,
1/4-20 Facade
Holding Screws
Screw Head to Facade Side Piece Gap
and Fastener Usage.
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Step 4. Slide the top cast iron piece (arched piece) down between and
behind the side pieces as shown in
Figure 3
. See
Figure 4
for
the final appearance of the installed cast iron facade .
Top Cast Iron (Arch) Piece
Previouly Installed
Cast Iron Side Pieces
Bottom Cast Iron Piece
Step 5. Hook the bottom cast iron piece (with the top, up, as shown
in
Figure 3)
cast iron side pieces as shown in
to the 4 holding screws protruding from the two
Figure 3
. See
Figure 4
for
the final appearance of the installed cast iron facade.
Installed Fireplace Cast Iron Facade and Grills
TOP
Slot orientation
indicates facade top.
Bottom Cast Iron Piece Detail
Showing Installation
Orientation
Installing the Top and Bottom Cast Iron Pieces
Figure 3
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
The manufacturer reserves the right to make changes at any time, without notice, in
design, materials, specifications, prices and also to discontinue colors, styles and
products. Consult your local distributor for fireplace code information.
Figure 4
Printed in U.S.A. © 2002 by LENNOX
P/N 750,150M REV. N/C 8/2002
1110 West Taft Avenue • Orange, CA 92865
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Loading...