Lennox LSM45-2, LSM40ST, LSM40-2, LSM40ST-PV, LSM40-PV User Manual

...

HEARTH PRODUCTS

KITS AND ACCESSORIES

750183M REV. A 04/2011

INSTALLATION INSTRUCTIONS FOR DECORATIVE ANDIRON KIT

™

FOR USE WITH MONTEBELLO

FRONT VIEW MODELS LSM40-2, LSM45-2, LSM40-PV, LSM45-PV / SEE-THROUGH MODELS LSM40ST, LSM40ST-PV

HOT GLASS WILL CAUSE BURNS. DO NOT TOUCH GLASS UNTIL COOLED. NEVER ALLOW CHILDREN TO TOUCH GLASS.

•The surfaces on your ﬁreplace get EXTREMELY HOT!

• The glass on the front of the ﬁreplace reaches EXTREMELY

high emperatures and can cause severe burns if touched. Even after the gas is turned off, ﬁreplace surfaces remain extremely hot.

• Keep children away from an operating ﬁreplace. Closely supervise children in any room where a ﬁreplace is operating to prevent contact with glass.

RISK OF PERSONAL INJURY OR PROPERTY DAMAGE.

• Never operate ﬁreplace with glass door assembly removed.

• Securely tighten door latch screws when reinstalling glass door

assembly to prevent door from falling out.

• Handle glass door assembly with extreme care. Replace damaged

glass door assembly with approved replacement assembly only.

The door assembly on this ﬁreplace contains ceramic glass. Handle with

care to prevent damage. If the door frame or glass becomes damaged, replace the entire glass door assembly with a manufacturer-approved replacement assembly only. Do not attempt to substitute any materials used on this door assembly or replace cracked or broken glass with any other materials.

KIT CONTENTS

(2) ea. Andirons (4) ea. Thumbscrews (2 attached to each andiron)

REQUIRED TOOLS

Phillips screwdriver

Montebello Series Andiron Kits

Description Cat. No. Model

Andiron Kit, Mission H2227 AKM-LSM

Andiron Kit, Classic H2228 AKC-LSM

SERIES DIRECT VENT GAS FIREPLACES

WARNING

GENERAL INFORMATION

These decorative andiron kits are offered in two attractive styles as an enhancement to the ﬁrebox appearance.

INSTALLATION INSTRUCTIONS

Step 1. If applicable, remove the mesh pull screens, as follows:

Lift up the left side of the screen rod and slide it to the LEFT until

Step 2. Remove the glass door assembly, as follows:

•Readallstepsbeforestartinginstallation.

•Theseinstructionsmustbeleftwiththeappliance.

•Allwarnings,precautions,andinstructionsintheInstallation

Instructions and Care and Operation Instructions provided with the appliance also apply to these instructions.

•Ifyouencounteranyproblems,needclaricationofthese

instructions, or are not qualiﬁed to properly install this kit, contact your local distributor or dealer.

WARNING: Burn hazard. Install only when ﬁreplace is

OFF and COLD.

the right side of the rod is disengaged from the hole. Slowly remove the rod and ﬁrescreens from the ﬁreplace. Set aside in a safe location for later reinstallation.

a. See Figure 2. While holding the top of the glass door frame

in place, use a Phillips screwdriver to remove the two (2)

screws securing the door frame to the two (2) door latches.

b. Carefully swing the top of the glass door frame outward (as

shown in Figure 2), and then lift the door assembly up and out of its lower track.

c. Carefully set aside the glass door assembly in a safe location

(on a padded surface) for later reinstallation.

(2) Latch

Screws

DECORATIVE ANDIRON KIT

MONTEBELLO™ SERIES

NOTICE

(2) Door Latches

Figure 1

Classic Andirons Mission Andirons

Glass Door

(2) provided Thumbscrews per Andiron (both styles)

Front View Montebello™ ﬁreplace model shown. Instructions also apply to See-Through models.

Assembly

Figure 2

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

LENNOXHEARTHPRODUCTS•ANDIRONKITFORMONTEBELLO® GASFIREPLACES•INSTALLATIONINSTRUCTIONS

Step 3. Fireplace models LSM40-2, LSM45-2, LSM40-PV, LSM45PV:

Remove the front three logs indicated in Figure 3.

Note: Logs are FRAGILE! Handle with care to prevent breakage.

For ﬁreplace models LSM40ST and LSM40ST-PV: Log removal

is not necessary.

Fireplace models LSM40-2, LSM45-2, LSM40-PV, LSM45-PV: Remove front three logs before installing andirons.

Figure 3

Step 4. Install andirons as described in Figure 4.

Andirons (Classic style shown)

(Side View)

Andiron (Classic style)

Step 5. Fireplace models LSM40-2, LSM45-2, LSM40-PV, LSM45PV:

Reinstall the logs removed in Step 3. For details, refer to the log placement instructions in the ﬁreplace Installation Instructions.

Note: Logs are FRAGILE! Handle with care to prevent breakage.

Step 6. See Figure 2. Reinstall the front glass door assembly, as follows:

a. Retrieve the glass door assembly. Visually inspect the gasket

on the backside of the frame to ensure it is clean, free of irregularities, and ﬁrmly seated on the frame.

b. Position the door assembly in front of the ﬁrebox opening

with the top of the door held away from the ﬁreplace, as shown in Figure 2. Lower the bottom of the door assembly onto the bottom door track. Pivot the door up after engaging and centering in the base channel.

c. Using a Phillips screwdriver, fasten the door frame to the

door latch with the two (2) latch screws removed in Step 2.

WARNING: Risk of personal injury or property

damage.

To prevent glass door assembly from falling out, securely tighten latch screws when reinstalling. (Also see WARNING box on Page 1.)

Step 7. If applicable, reinstall the mesh pull screen assembly removed

in Step 1, as follows:

a. Reattach both mesh pull screens to the rod. b. Insert the right side of the rod into the corresponding hole

on the upper right side of the ﬁrebox opening.

c. Insert the left side of the rod into the corresponding hole on

the upper left side of the ﬁrebox opening.

Grate Assembly

DETAIL A

To install andirons in Montebello Front View ﬁreplace models LSM40-2, LSM45-2, LSM40-PV and LSM45PV:

1) Loosen thumbscrews by turning them counterclockwise (do not

remove thumbscrews).

2) Place andirons onto grate as shown above in Detail A and B.

3) Turn thumbscrews clockwise until snug (do not overtighten). Also

see Figure 5.

To install andirons in Montebello See-Through ﬁreplace models LSM40ST and LSM40ST-PV:

1) Remove thumbscrews by turning them counterclockwise. Discard

thumbscrews.

2) Place andirons onto grate as shown above in Detail A. Also see

Figure 6.

Figure 4: Installing Andirons

Thumbscrew

DETAIL B

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

Mesh Pull Screens

Mission Andirons Installed in Front View Fireplace

Figure 5

Classic Andirons (2 sets) Installed in See-Through Fireplace

Figure 6

Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, speciﬁcations, and prices, and to discontinue colors, styles, and products. Consult your local distributor for ﬁreplace code information.

P/N 750183M Rev. A 04/2011

1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210