Lennox CI1000HT User Manual

HEARTH PRODUCTS

KITS AND ACCESSORIES

775,092M REV. B 09/2007

INSTALLATION INSTRUCTIONS FOR WINDOW TRIM KITS FOR USE WITH SPECTRA MODELS CI1000HT AND CI2000HT WOODSTOVES

KIT CONTENTS

1 ea. Window Trim Kit 1 ea. Instruction Sheet 6mm Braided Rope Gasket

TOOLS REQUIRED

Scissors Glass Cleaner and Soft Cloth

WINDOW TRIM KITS

Cat. No. Model Description Where Used

41M2401 WTK-CI10 Charcoal Trim CI1000HT

41M2001 WTK-CI20 Charcoal Trim CI2000HT

Table 1

Cut Top Rope Gasket

Figure 1

Cut Bottom Rope Gasket

Spectra™ Wood Stoves Window Trim Kits

WARNING

INSTALL ONLY WHEN APPLIANCE IS COLD!

INSTALLATION INSTRUCTIONS

Step 1. Cut Top Rope Gasket - Turn the door trim casting face down so

that the attachment clamps are fully visible. Measure the braided rope gasket so that it is roughly the same length as the arched top surface of the casting, and cut with scissors (see Figure 1).

Step 2. Cut Bottom Rope Gasket - Measure the rope gasket against the

bottom edge of the casting and cut (see Figure 2).

Step 3. Peel Off Tape - Peel the paper backing off of the gasket adhesive

(see Figure 3).

Step 4. Install Lower Rope Gasket - Place the lower rope gasket along the

bottom edge of the casting and press down ﬁrmly (see Figure 4).

Figure 2

Peel Off Tape

Figure 3

Install Lower Rope Gasket

Figure 4

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

Step 5. Install Top Rope Gasket - Place the top rope along the top edge of

the casting and press down ﬁrmly.

Note: Ensure gasket is positioned so it will not be visible from the

front (see Figure 5).

Step 6.

Clean Glass - Prior to installing the window trim, the glass should

be cleaned thoroughly with a glass cleaner using a soft cloth. A household ammonia based glass cleaner is approved (see noteS below).

Note:

For woodstove models CI1000HT and CI2000HT, when cleaning

the inside of the glass after it has been burned, a commercial glass cleaner designed for stoves is recommended.

For woodstove models CI1000HT and CI2000HT, when cleaning

the inside of the glass after it has been burned, a commercial glass cleaner designed for stoves is recommended.

Step 7.

Install Trim - Position the locating nub on the top center of the trim

into the notch on the top center of the window opening (see Figure

6).

While slightly lifting up on the trim rotate the bottom of the trim to

the glass. Let the trim drop down until the 2 nubs on the bottom of the trim drop into the slots on window opening (see Figure 7).

Figure 6 - Position Locating Tab at Top Center

Figure 5 - Install Top Rope Gasket

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, speciﬁcations, prices and the discontinuance of colors, styles and products. Consult your local distributor for ﬁreplace code information.

P/N 775,092M REV. B 09/2007

Figure 7 - Lift and Rotate Trim into Place

1110 West Taft Avenue • Orange, CA 92865