Lennox 42BFOD-BS, 36BFOD-BS User Manual

FIREPLACE KITS

AND ACCESSORIES

750,210M
Rev. A 07/2006

BI-FOLD GLASS DOORS

INSTALLATION INSTRUCTIONS FOR OUTDOOR BI-FOLD GLASS DOORS

MODELS: 36BFOD-BS & 42BFOD-BS

INSTALLATION INSTRUCTIONS

Remove Screens And Rods:

Using a 5/16" socket or nutdriver, remove the screen rod assemblies
(see

Figure 1

Pull out the rods from locating holes on the side of the firebox opening.

IMPORTANT! REINSTALL SCREEN ROD SCREWS INTO THE EXISTING
HOLES WHERE REMOVED.

The screen and rod assemblies must not be installed when the Bi-Fold
Glass Door Kit is installed. You may wish to retain the screen and rod
assemblies is case the Bi-Fold Glass Door Kit is ever removed in the future.

IMPORTANT! IF THIS OPTIONAL BI-FOLD GLASS DOOR KIT IS EVER
REMOVED, THE ROD AND SCREENS MUST BE REINSTALLED FOR
SAFE OPERATION OF THE APPLIANCE.

). Remove the screen rod screws as shown in

Figure 1

.

These bi-fold glass door assemblies have been designed for use with and
may be easily fitted to your Lennox Outdoor Gas Fireplace, Models
E36ODG & E42ODG.

Do not alter or modify these door assemblies or a fireplace malfunction
or a fire hazard may result.

These doors have been tested and listed by Omni-Test Laboratories
Inc.

PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE.

GENERAL INFORMATION

The door assembly consists of a right and left glass panel assembly with the
door handles factory mounted. Included is a four piece door frame with
eight (8) screws and a hood (hood packaged separately), which are required
for assembly. Fireplaces listed on the front page of this document, have
been designed to accept these doors with minimum effort.

TOOLS REQUIRED

• Medium Phillips Screwdriver • 3/8" Open-end wrench

• 1/4" Drive Socket

Figure 1

Screen Rod
Screws

Screen And
Rod Assembly

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE

1

Hood Installation:

Begin the assembly by installing the hood (packaged separately). Be
certain to remove any protective plastic coatings for the stainless steel
parts before installing those components.

Step 1. Turn off the fireplace and allow it to cool before proceeding.

Step 2. Place the hood lip under the face top opening, as shown in

Figure 2

as shown in

- Step 1. Attach the hood with two (2) screws, one each side,

Figure 2 -

Step 2.

After assembly, the frame inserts under the hood as shown in
and drops down inside the opening without fasteners.

Figure 4

Face Top

Place The Hood

Lip Up And

Under The Face

Top Opening

Hood Lip

Step-1

Attaching Screw
(Seen From Below)

Step-2

Figure 2

Frame Assembly:

Assemble the four piece door frame with the eight (8) screws provided
as shown in

Figure 3

. Two spring clips attach inside the upper track as

illustrated.

Assembled
Door Frame

Figure 4

Door Installation:

Step 1. Starting with the lower end of either the right or left hand door

hold the door at a slight angle to the door frame outer edge with the
top tilted toward the center.

Swing the lower corner of the door over the hole in the lower frame
and engage the lower pivot pin into the hole on the lower frame of the
firebox opening (

Figures 5 and 6

Pivot Pin

Lock

).

Roller Pin

2

Screws (8)

Figure 3

Spring Clip

Figure 5

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE

Pivot
Point

Lower
Frame