Lennox 290M User Manual
HEARTH PRODUCTS
KITS AND ACCESSORIES
775,290M
Rev. A, 10/2008
INSTALLATION INSTRUCTIONS FOR INSTALLING TRIM
KITS FOR USE WITH VISION DIRECT-VENT GAS STOVES
KIT CONTENTS
Please ensure that all these parts are included
1 ea. Louver Assembly
2 ea. Side Window Trim
1 ea. Front Window Trim
1 ea. Ash Lip Trim
2 ea. Allen Head Screws
4 ea.
10-24 Hex Nuts
4 ea. #10 Washers
1 ea. Instruction Sheet
TOOLS NEEDED:
5/32” Allen Wrench or T-Handle Wrench
1/8” Allen Wrench or T-Handle Wrench
3/8” Open End Wrench
TRIM KITS
MODEL VISTION™
INSTALLATION INSTRUCTIONS
Step 1. Remove the four screws from the top of the stove - Using a 1/8”
allen wrench remove the two button head screws on the back of
the stove (see Figure 1) and using a 5/32” allen wrench remove
the two socket head screws on the front of stove (see Figure 2).
Lift off the top of the stove. Retain the screws for reinstallation
of the stove top in Step 6.
(Step 1) Using a 1/8” allen wrench remove the
two button head screws on the stove back.
Cat. No. Model Description
75276 VISN-TRIM-B-G Black Trim Kit / Gold Handle
75277 VISN-TRIM-B-N Black Trim Kit / Nickel Handle
75274 VISN-TRIM-G-G Gold Trim Kit / Gold Handle
75275 VISN-TRIM-N-N Brushed Nickel Trim Kit / Nickel Handle
Kits Include: Matching Trim for Glass, Louvers and Ash Lip
GENERAL INFORMATION
If you encounter any problems, need clarification of these instructions
or are not qualified to properly install this kit, contact you local distributor or dealer.
Read this instruction sheet in its entirety before beginning the installation.
All of these parts may scratch and bend, great care should be used
in handling them.
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND
OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO
THESE INSTRUCTIONS.
TURN OFF THE STOVE AND ALLOW IT TO COMPLETELY COOL BEFORE
PROCEEDING.
CAUTION: Always ensure that plated surfaces are clean and free of
fingerprints before lighting stove. Fingerprints will leave permanent
blemishes if left on plated surface when lit. When installation is
complete, the trim should be gently cleaned with a soft cloth and
either alcohol or a household glass cleaner. Do not overtighten nuts,
overtightening can create visible dimples on the plated surface.
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.
Stove Back
Figure 1
(Step 1) Using a 5/32” allen wrench, remove
the two socket head screws on the stove front.
(Step 3) Attach the louvers above the door with four supplied
Figure 2
screws (two on left side and two on right side of stove).
Stove Front
1
Step 2. Using a 5/32” allen wrench, attach the ash lip to the lower control
door using two supplied screws. See Figure 3.
5/32” Allen Wrench
Front Door Trim
Figure 3
Step 3. Using a 5/32” allen wrench, attach the louvers above the door
with four supplied screws (two on left side and two on right side
of stove). See Figure 1 on Page 1.
Step 4. Slide the side window trim down into the brackets in the side wall
of the stove. It may be helpful to slightly pry open the brackets
on the stove to slide the side trim in. Be careful to not scratch the
glass or the trim. See Figure 4.
Figure 5
Step 6. Reattach the top of the stove with the four screws.
Step 7. To install the spring handle, first close the door and screw the
handle into the receiving nut. Then spray a household glass cleaner
or water on the shaft of the handle to act as a lubricant. Next,
twist the spring handle counterclockwise onto the shaft. Use a
household glass cleaner or alcohol and a soft cloth to remove
any fingerprints from all plated surfaces prior to firing the stove.
Read Caution on Page 1.
COMPLETED
INSTALLATION
Figure 4
Step 5. Using a 3/8” open end wrench, install the front door trim with
the four supplied nuts and washers. DO NOT OVERTIGHTEN THE
NUTS OR SCREWS
Lennox Hearth Products reserves the right to make changes at any time, without notice, in
design, materials, specifications, prices and also to discontinue colors, styles and products.
Consult your local distributor for fireplace code information.
Printed in U.S.A. © 2008 Lennox Hearth Products
P/N 775,290M REV. A 10/2008
2
. See Figure 5.
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.
Figure 6
1110 West Taft Avenue • Orange, CA 92865
Loading...