CONTROLS
Litho U.S.A.
E2006
INSTALLATION INSTRUCTIONS FOR NETWORK REPEATER (11W30; LB−113402)
USED WITH L CONNECTION® NETWORK
505,228M
7/2006
NETWORK REPEATER KIT
Shipping and Packing List
Package 1 of 1 contains:
1− Repeater
1− Wiring diagram
1− 12VDC Power supply
Check items for shipping damage. Receiving party should
contact last carrier immediately if shipping damage is found.
These instructions are intended as a general guide and do
not supersede local codes in any way. Authorities having
jurisdiction should be consulted before installation.
Application
The Network Repeater is required when communication
cable length exceeds 4000 ft. (1219m) or when cable is
run between buildings.
WARNING
Improper installation, adjustment, alteration, service or maintenance can cause property damage,
personal injury or loss of life. Installation and service must be performed by a qualified installer or
service agency.
CAUTION
SysBus or
ZoneBus
SysBus or
Black
Red
SysBus or
ZoneBus
ZoneBus
G
D−
D+
NETWORK REPEATER
12VDC
POWER IN
FIGURE 1
REPEATER WIRING
TOP VIEW
G
D−
D+
SysBus or
ZoneBus
Black
Red
Danger of sharp metallic edges. Can cause injury.
Take care when servicing unit to avoid accidental
contact with sharp edges.
Installation
Install repeater in unit or mechanical room with access to
a 120V outlet. When used between buildings, install a
repeater before the first controller on each building. Use
field provided DIN rail if desired.
Wiring
1− Make communication wiring connections to repeater
as shown in figures 1 and 2.
2− Plug power source into a 120V outlet and connect to
the repeater as shown in figures 1 and 2.
3− Affix wiring diagram on inside unit panel near other
wiring diagrams.
07/06
*2P0706*
Page 1
V+V−
Black Red
FIGURE 2
*P505228M*
12VDC
From
Power
Supply
505,228M
Loading...